The Dornier Mercury (Merkur) is an outgrowth of the Dornier Komet. It is designed as a passenger aircraft with the Alpine routes in mind. Its fuselage is made of steel for high stressed parts and duraluminum for all others. It can also be outfitted as a seaplane.

In November 1926, an exhibition flight of the Dornier giant flying boat was made for 3/4 of an hour. It was a larger version of the Dornier Wal, with a stepped hull, and wing stubs for lateral stability. It has a range of 1200 miles and is outfitted for baggage and 8 passengers.

Different engines are tested to determine their efficiencies in burning fuel. Fuel injection and ignition chamber engines are also discussed.

Gas and electric welding of duralumin are discussed. Some of the elements that go into determining a successful weld and inspecting for faults are also described.

"At the suggestion of Professor Von Karman, I have made a few theoretical investigations of the mutual reaction of the wings and body of an airplane. There was assumed as the basis of my calculations, a strongly idealized body shape, namely, a cylinder extended to infinity at both ends and having its axis parallel to the direction of motion of the airplane. The results are to be regarded as rough approximations for a long airplane body and also for an airship with fins. In my calculations, I have considered only a monoplane in which the axis of the wing is rectilinear" (p. 1).

"The tests described in this report were made to determine the error caused by using small tubes to connect orifices on the surface of aircraft to central pressure capsules in making pressure distribution tests. Aluminum tubes of 3/16-inch inside diameter were used to determine this error. Lengths from 20 feet to 226 feet and pressures whose maxima varied from 2 inches to 140 inches of water were used. Single-pressure impulses for which the time of rise of pressure from zero to a maximum varied from 0.25 second to 3 seconds were investigated" (p. 303).

"This report presents some results obtained during an investigation to determine the relative characteristics for several methods of control of an overcompressed engine using gasoline and operating under sea-level conditions. For this work, a special single cylinder test engine, 5-inch bore by 7-inch stroke, and designed for ready adjustment of compression ratio, valve timing and valve lift while running, was used. This engine has been fully described in NACA-TR-250. Tests were made at an engine speed of 1,400 R. P. M. for compression ratios ranging from 4.0 to 7.6" (p. 329).

"This report presents some results obtained during an investigation to determine the effect of high inlet air temperature on the performance of a Liberty 12 aviation engine. The purpose of this investigation was to ascertain, for normal service carburetor adjustments and a fixed ignition advance, the relation between power and temperature for the range of carburetor air temperatures that may be encountered when supercharging to sea level pressure at altitudes of over 20,000 feet and without intercooling when using plain aviation gasoline and mixtures of benzol and gasoline" (p. 409).

Aileron calculations have hitherto given greatly differing results according to different authors. It seems to be the general opinion that it is only necessary to give the ailerons such dimensions that the airplane can maneuver well, that the stresses they must undergo are relatively small, and that they are strong enough if their framework is of the order of strength as the wings to which they are attached. This article will show that the problem is really quite complex and that it should receive more attention.