Examination of Al- 1.65w/o Pu and Al- 12 w/o Si- 1.65 w/o Pu capsules irradiated 55- 60% burnout of the plutonium atoms revealed a 1.4% volume increase and no apparent microstructural changes. A four rod cluster containing Al-8 w/o Pu and Al-12 w/o Si-8 w/o Pu alloy cores is currently under irradiation in Loop 3 of KE Reactor at a water temperature of approximately 230C. A second cluster has been fabricated an is scheduled for charging late in 1958. Two seven-rod clusters for irradiation in KER are also being fabricated.

The decontamination of the present Hanford reactors involves a once-through cleaning operation. Considerable interest has been shown in determining the feasibility of this once-through technique for cleanup of certain portions of the NPR system. This is the second interim report of a series that covers tests performed in the 242-B Single Pass Flow Facility. The first was distributed in January, 1960.

Theoretically aqueous hydrazine will react with dissolved oxygen for form only nitrogen and water. Most of the experimental evidence, however, indicates that the reaction proceeds rather slowly in low-temperature systems. Tests are currently being conducted to determine whether or not it is feasible to use activated carbon to catalyze the reaction in filtered water. A system of this type would be useful in high temperature reactors when it becomes necessary to convert to single-pass operation.

With the development of the zircaloy-2 clad uranium fuel element, it was necessary to develop a method of closing the end of the element after the extruded tubes were cut to the desired length. Regardless of the ultimate design of the closure, a satisfactory zircaloy-2 fusion welding technique had to be worked out. The first fully successful welding was performed with electron beam welding in a vacuum chamber. To make satisfactory welds, the electron beam welding involved time and equipment, plus undue maintenance on the equipment.

Accurate sampling of particulate in gaseous effluents is required for auditing and control of radioactive wastes released to the environment at installations generating or processing radioactive materials. Over the years a variety of sampling probe configurations, sampling velocities, lengths and sizes of sample delivery lines have been used locally to obtain these samples. Efforts to properly evaluate the validity of samples in most sampling installations have been hampered by a lack of basic knowledge of particle behavior under the various conditions imposed. Important variables about which minimal knowledge is available are those of particle impaction and retention on and re-entrainment from the walls of sampling lines. In some sampler configurations the effect of these parameters on sampling validity may be made negligible, but in lines already in place. or where long sampling lines are required, the degree to which deposition affects the sampling validity must be established. Deposition and rebuild up, then rapid release to the air stream. Research has been initiated in Hanford Laboratories Operation to provide the required data relative to deposition and retention on conduit walls and to eventually arrive at approved sampling system configurations.

Over the last decade, several computational methods have been developed and used to examine reactor flow transients caused by pump outage. The variations in system character which have been analyzed are sufficiently diverse that it appears worthwhile to compile them into a single report.

Report outlining the relation of the ASTM flash point of oil, a rough measure of the safety of storage and use when oil sparks, to other directly determinable physical properties. Summarizes the data on vapor pressures, boiling curves, and flash points of various hydrocarbon diluents.