From abstract: "This project was a study of electrostatic classification of submicron aerosols. Classification of particles as small as 0.006-[mu]-diameter was shown to be feasible, and good classification of atmospheric dust was achieved. However, a practical solution to the problem of overlapping between particles larger and smaller than 0.1 [mu], the point of minimum electric mobility, was not found."

The following quarterly progress report covers the period from November 16, 1962 to February 15, 1963. This report summarizes three activities that study the ratio of the maximum absorption of the K band to the maximum absorption of the F band has been made in additively colored and [gamma]-irradiated rubidium chloride.

The following quarterly report covers the period during February 16 to May 15, 1963. This report is divided into sections covering the separate activities during this period, studying the thermal behavior of the F-center in RbCl.

This report discusses many low energy neutron capture gamma ray spectra from many elements. Also, a series of neutron capture gamma ray spectra from a wide variety of meteorite and terrestrial rock samples were obtained.

A report focused on obtaining further neutron capture gamma ray spectra for inclusion in the Atlas, and in conducting subsidiary experiments to determine the cause of the anomalous broad peak structure which was reported in ARF 1193-20.

Abstract: "Measurements have been made of the cross sections for the reactions Id-6(n, dn)He-4 and Li-7(n, tn)He-4 over an incident neutron energy range of 5 - 14 MeV. The energy and angular distributions of all reaction products were determined."

This technical report is a summary of short time strength data for CS1830 series Cb-1Zr material. The data are presented as a function of fabrication history or the amount of cold work received during fabrication. Three fabrication categories were considered for comparison: forgings and extrusions; bar, plate, rod and pipe; and sheet and tubing. Forgings and extrusions having received no cold work showed the highest strength over the entire temperature range 68F to 2800F; bar, plate, rod and pipe received moderate cold work and showed lower strength than forgings and extrusions but higher strength than sheet and tubing in the temperature range 2000F to 2800F.

Work performed during the quarter is summarized by: direct measurement of fission gas pressure, loop operations, performance of UO2 fuel, UO2 grain growth and melting studies.

"The performance of the Model I electrostatic precipitator sampler in recent field and laboratory tests is described and discussed. Two of the four precipitator-bearing balloon flights during this interval reached the floating altitude of approximates 105,000 feet, and the precipitator operated efficiently on both. One sample was collected at the nominal design flowrate of approximates 100 cfm, and the second at approximates -200 cfm. Comparison of the deposition profiles of the stratospheric samples with those obtained under controlled conditions in the altitude chamber indicates that the field samples were collected with >90% efficiency. The laboratory tests also showed that the performance capability of the precipitator improves with increasing precipitator current, and with increasing altitude. One of the above balloon flights carried two Model A-I altimeters with recorder outputs. The two records were identical within plus or minus 250 feet. In addition, variations in altitude indications were consistent with the less sensitive aneroid barocoder measurements from the same flight. A revised Model A-I altimeter with a telemeterable output signal has been designed and constructed. The frequency of the signal is a function of the altitude. A preliminary design concept for a flowmeter with negligible flow resistance is described. It would utilize …

"Results of the continuing stratospheric flight test evaluation program for the Del Model I Electrostatic Precipitator Sampler and the Del Electrical Discharge Altimeter are described and discussed. Only one of four balloon launches reached floating altitude. The altimeter obtained an altitude recording consistent with concurrent aneroid barocoder readings. The reported gross gamma concentration for the precipitator sampler was approximates 25 and 80% higher than those of the two simultaneous direct flow filter samples. The completion of the design and construction of two prototype units of the Del Electrical Discharge Altimeter and their laboratory evaluation are described. A preliminary design concept is presented for an operational high volume electrostatic precipitator sampler to operate with high collection efficiency at an ambient flowrate of 500 cfm throughout the altitude range 100,000 to 150,000 ft."

Work performed during the quarter is summarized by direct measurement of fission gas pressure, loop operations, performance of UO2 fuel.

"Design work was completed and construction initiated on a prototype field altimeter based on the gas density dependence of Townsend discharge current in an electrical discharge. The design of an ion tracer air velocity meter for laboratory applications, and construction of three units were successfully completed. Theoretical and experimental support is presented, showing the applicability of the ion tracer system to the accurate measurement of linear gas velocity. The operating range of the laboratory meter is 150 to 2500 ft/min at ambient pressures between 200 mu and 30.0 mm Hg. Further investigations on the application of the ion tracer concept to flowrate measurements are presented. By generating velocity profile curves with an ion tracer calibrated thermoanemometer, it was possible to determine the flowrate for 2 flow and pressure conditions; 37.5 cfm at 19.6 mm and 75 cfm at 9.8 mm Hg. Comparison with a calibrated Rotameter technique was within 5% in both cases. Also presented are some preliminary investigations leading to the development of a generalized ion tracer flowmeter for low gas densities. Results of some supplemental electrical discharge experiments in rarefied atmospheres are described. It was observed that electrical oscillations could be produced in a low density gas discharge, …

Tests were run at the General Electric Company, Atomic Power Equipment Department, to determine the burnout conditions for a non-uniformly heated rod in an annular geometry.

Work performed during the quarter is summarized by direct measurement of fission gas pressure, loop operations, performance of UO2 fuel.

"The study of the toxicity of Ra and MsTh(Ra/sup 228/) in humans was continued. Several Thorotrast cases were also examined. Physical and clinical studies were made on 151 persons. In all cases possible gamma ray measurements were made of Ra and MsTh decay products retained in the body, alpha -ray measurements of Rn and Rn/sup 220/ in breath, a complete medical history was taken, a complete x-ray examination was made of the skeleton, and urinalysis, hematological, and blood chemistry studies were made."

Work performed during the quarter is summarized by; direct measurement of fission gas pressure, loop operations, performance of UO2 fuel, UO2 grain growth and melting studies.

Appendix I, Determination of random coincidence in a fast-slow coincidence circuit; Appendix II, Multiple scattering during measurements of S-directional distribution from polarized nuclei, of S-y-circular polarization correlation, and of S-y-directional correlation.

The present paper is devoted to the determination of the heats of reaction of lanthanum ions with halogen ions within a broad concentration range of hydrogen halides. The enthalpies of the interaction of lanthanum perchlorate with perchloric and halogen acids increase with the increasing of acid molality from one to eight. The enthalpies of the interaction between lanthanum and halogen ions in water solutions are endothermic and decrease in the sequence; Cl > Br > J. The values support the fact of formation of lanthanum chloride complexes and point to the possibility of forming bromide complexes, but the question of the existence of iodide complexes of lanthanum in aqueous solutions is left open.

None

The driving force for liquid metal corrosion is the equilization of chemical potential for dissolution of all solid surfaces in contact with the liquid. In any practical system, this is an impossible goal; therefore, one observes several mass transfer processes.

Since the end of the last century (Tarknow, 1896) radiation effect o the nervous tissue has been studied in experimental animals and humans by numerous investigators, using mostly pathomorphological changes as a parameter of radiosensitivity . With increasing time intervals following radiation, pathomorphological changes are more evident, which has been known for quite some time.

In the summer of 1960 one of the little used wells on the Brookhaven National Laboratory site became accidentally contaminated with radioactive material. The contamination was discovered during a routine sampling of all wells in the waste disposal area, so there was a period of several weeks between the time of discharge.

Radiation and annealing mechanisms for dimensional and c-axis changes in which the di-interstitial can be mobile at any or all temperatures above absolute zero are shown to be concordant with earlier work used to determine the migration energy energy of single interstitials and the absolute rate of displacing atoms in graphite. The mechanisms account for the stability of c-axis and dimensional changes with time in the absence of irradiation and with observed c-axis annealing at room temperature following irradiation at low temperatures.

Electron-transfer reactions involving bridged transition states are examined from the point of view of adiabatic electron transfer theory. One important function of the bridging group is to decrease the effective dipole moment of the charge system of the reaction ions. The effect on the activation energy is different for outer-sphere and inner-sphere reactions. Trends in the halide and hydroxide catalysis of isotopic exchange reactions of transition metal ions are discussed.