None

The test of March 7, 1947 was planned as a check on power coefficient values; however, an analysis of reactivity data gave evidence of a considerable flattening of ``A`` rod in the region between 0--75 inches out. A second test of longer duration was therefore made on April 1, 1947 in order to obtain a check calibration of this portion of the control rod. The results of this test verified the flattening of this portion of ``A`` rod. The redetermined power coefficients based on new rod calibrations are given.

This report contains a letter, written on July 25, 1947, concerning the sampling program at Columbia River. The author suggests reducing the sampling schedule. He states that chemical composition sampling should be reduced by one-fifth and radioactivity sampling be reduced by one-third. He suggests that only mid-channel samples are required for representative studies. He further states that weekly sampling should occur. By following these suggestions, the cost of the sampling program should be drastically reduced because the hours of manpower taken to sample the river, analyze the data, organize, and store information would be reduced.

There were no cases of unusual blistering of slugs being followed under Production Tests. Two normal production tubes were borescoped following trouble with discharge. In Tube 3188-D a distorted slug became stuck in the region of sharp curvature near the inner end of the rear gun barrel; this is the first time this phenomenon has occurred. Examination of irradiated slugs of rolled metal after normal exposure indicates that rolled material has no particular advantages over extruded material from the standpoint of blistering. However, no extensively blistered pieces were found in either the rolled metal are being held for more extended exposure. Inspection of a large number of Van Stone flanges in the D and F Piles has confirmed that the inlet flanges are in generally good condition but that the rear Van Stone flanges of tubes in the 0.140-inch orifice sone of both piles were badly corroded and generally contained deep pits that extended about half-way through the flange. The Van Stone test units are to be installed unshielded in the risor room at the rear of the D Pile, since the shielding required in the X Sample Room exceeded the allowable floor loading. Recent experimental observations indicate that solid …