From Summary: "A preliminary experimental investigation is being conducted to determine the feasibility of preventing rain from impinging on aircraft windshields by means of high-velocity jet-air blast. The results indicate that rain deflection by jet blast appears feasible for flight speeds comparable with landing and take-off speeds of interceptor-type jet aircraft; however, attainment of good visibility through the mist generated by raindrop breakup presents a problem. For the simulated windshield and the lower windshield angles used in the investigation, air-flow rates of the order of 3.3 pounds per minute of unheated air per inch of windshield span were required for adequate rain deflection at a free-stream velocity of 135 miles per hour."

Report presenting the results of a wind-tunnel investigation to determine the effects of various free-flight rocket-model booster-adapter configurations on the aerodynamic characteristics in pitch and sideslip of a swept-wing, fighter airplane model with a Mach number of 2.01. Results regarding the effect of adapter shape and aerodynamic characteristics of the model alone are provided.

Report presenting the results of oscillation tests to measure the dynamic-rotary stability derivatives of an airplane model at high subsonic speeds. Measurements taken included the damping in pitch, damping in yaw, damping in roll, and the yawing moment due to rolling velocity.

Report presenting a flight investigation of four air-to-air missiles mounted by pylons on a rocket-powered basic wingless buffet-research vehicle to determine the trim, buffet, and drag characteristics of the combination.

"Small-perturbation spectral-analysis techniques are used to obtain the root-mean-square flame-generated turbulence velocities and the attenuating pressure fluctuations stemming from interaction of a constant-pressure flame front with a field of isotropic turbulence in the absence of turbulence decay processes. The anisotropic flame-generated turbulence velocities are found to be of about the same intensity as those of the incident isotropic turbulence, the lateral turbulence velocities being always lower, but the longitudinal velocity is somewhat increased for flame-temperature ratios over 7" (p. 599).

At the request of the Bureau of Ordnance, Department of the Navy, the Langley Pilotless Aircraft Research Division has initiated a program to investigate the general aerodynamic characteristics of the Naval Ordnance Test Station's SIDEWINDER missile. The model used in the flight test presented herein was a full-scale, rocket-propelled test vehicle. This paper presents the results from a flight test investigation using the pulsed-control technique to determine the static and dynamic longitudinal stability and control derivatives and drag data for a canard-missile configuration.

Report presenting testing of a towed airplane model in the 19-foot pressure tunnel in conjunction with the development of a flutter testing technique. The model was equipped with an autopilot to keep the model flying straight and level in the tunnel while restrained only in drag. Results regarding period and cycles to damp to half amplitude, time histories, and motions of the flexible wing model are provided.

Report presenting lift, drag, and pitching-moment coefficients, lift-drag ratios, and center-of-pressure positions for four airplane-like configurations determined from tests at a range of Mach numbers and angles of attack. The wings and nose shapes were modified for each of the configurations.

Report presenting an investigation in the 4- by 4-foot supersonic pressure tunnel to determine the effects of body indentation on the minimum drag and maximum lift-drag ratio of a 60 degree swept-wing-body combination. A secondary goal of the tests was to determine the effect on the maximum lift-drag ratio of modifying the inboard plan form of the 60 degree swept wing. Lift, drag, and pitching-moment data are presented.

Memorandum presenting an investigation of the performances of two annular diffuser designs applicable to turbojet afterburner installations to determine the effectiveness of injection and suction boundary-layer controls. Results regarding inlet measurements, flow observations, static-pressure distributions, downstream velocity distributions, and mean performance coefficients are provided.

Report presenting a wind-tunnel investigation to determine the effect of lowering the wing from the top of the fuselage to the bottom of the fuselage on the longitudinal characteristics of a wing-fuselage and a wing-fuselage-tail combination with the horizontal tail at various heights above the plane of the wing. The effects of wing height on the longitudinal characteristics of the model were small.

Report presenting an investigation to determine the effect of lowering the wing from the top of the fuselage to the bottom of the fuselage on the longitudinal characteristics of a wing-fuselage and wing-fuselage-tail combination with the horizontal tail at various heights above the plane of the wing. Testing occurred at a range of Mach and Reynolds numbers.

Report presenting limited flight measurements made in order to investigate the effect of dynamic vibration absorbers on the structural response of a Lockheed F-80A airplane during buffeting. The results were obtained by comparison of data with and without the absorbers operating through use of electrical frequency-analysis techniques.

From Introduction: "The purpose of this paper is to present an analysis of the data for the remaining airplanes where the data were sufficient to warrant analysis. The data analyzed represent totals of 351 to 5660 hours of operations with ten types of Navy airplanes and were recorded during the period 1949 to 1953."

Preliminary results are presented from an investigation to determine the influence of afterbody geometry on the effects of a sonic propulsive jet at transonic speeds. The results presented are base pressure coefficient and afterbody pressure-drag coefficient as a function of jet pressure ratio for different values of Mach number and jet temperature. Geometric parameters investigated include boattail angle, jet-to-model diameter ratio, and jet-to-base diameter ratio.

Report presenting testing of two low-solidity transonic axial-flow-compressor rotors tested over a range of speeds up to a corrected tip speed of 1000 feet per second to determine the performance of such rotors and to provide experimental rotor blade-element data for low solidity levels. Comparisons of the hub and mean blade-element losses for the three rotors showed that the losses tended to decrease with a decrease in solidity. Results regarding rotor-inlet conditions, rotor-outlet conditions, overall performance, and stall characteristics are provided.

Report presenting an investigation to measure the effect of base bleed on the base pressure, lift, drag, and pitching moment of a 10-percent-thick blunt-base airfoil model. Small holes near the lower surface near the trailing edge into the base region were used to create base bleed. The drag was reduced as a result of the bleed holes.

From Summary: "Measurements of pressure distributions have been made over a wing midsemispan station on the 35 degree sweptback wing of the Douglas D-558-II research airplane at Mach numbers from 1.17 to 2.0. The results of the investigation indicate that, as the angle of attack increased at the higher Mach numbers, the pressure coefficient for a vacuum limited the extent to which the upper-surface pressures could expand. Consequently most of the increase in section normal-force coefficient at high angles of attack can be attributed to the increase in pressure over the lower surface."

Report presenting an approximate theory for predicting the rate of heat transfer to the stagnation region of blunt bodies in hypersonic flight. Attention is focused on the case where wall temperature is small compared to stagnation temperature. Experiments were conducted in the hypersonic gun tunnel to obtain a preliminary check on this theoretical prediction.

Report presenting an investigation of the low-speed static lateral stability characteristics of a complete model with a series of M- and W-wings. They were modified from a basic 45 degree swept wing and were designed to cover a range of spanwise locations of the sweep discontinuity.

From Introduction: "Numerous tests of tip controls on delta wings at transonic and low supersonic speeds have shown that such configurations provide satisfactory rolling-moment effectiveness, and that the hinge can be controlled by proper location of the hinge line (ref. 1). The purpose of the present tests is to determine the characteristics of such a configuration at Mach number of 4.04 and a Reynolds number of 5.8 X 10^6, based on the wing mean aerodynamic chord."

Report presenting an investigation at low speed in the 300 mph tunnel to determine the static aerodynamic forces and moments on a missile model during simulated launching from 25-percent-semispan and wing-tip locations of a wing-fuselage combination. Results regarding the differences in location and effects induced by the fuselage are provided.

Report presenting results of a wind-tunnel investigation to determine the effects of various free-flight rocket-model booster-adapter configurations on the aerodynamic characteristics in pitch and sideslip of a swept-wing, fighter airplane model for a Mach number of 2.01. Normal-force, lateral-force, pitching-moment, and yawing-moment coefficients of the airplane model were measured, and schileren photographs of the various configurations were obtained.

Report presenting an investigation to determine the zero-lift rolling effectiveness of all-movable sweptback horizontal tail fins mounted behind a notched delta wing at a constant angle of differential incidence of 7 degree per fin. Two models, one with a stiff wing and one with a flexible wing, were tested in free flight over a range of Mach numbers. The rolling effectiveness was about the same magnitude at subsonic and supersonic speeds for both models.