The following report describes the process of the determination of nitrous oxide with the infrared spectrometer.

Introduction: "A laboratory investigation of the relative corrosion resistance of several austenitic stainless steels to the RAW stream of the Tributyl Phosphate Waste Metal Recovery Process was made during the first quarter of 1950. The results of this investigation are reported herein; all original data are recorded in laboratory notebook HW-3282-T."

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: The authority of a life insurance company, which owns home office properties in another state, to own real estate for a branch office in Texas.

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: Authority of the County to prevent a land owner from closing a road across his land.

Malonate has been found to inhibit the formation of malic acid during short periods of photosynthesis with radioactive carbon dioxide. This result, together with studies which show the photosynthetic cycle to be operating normally at the same time, indicates that malic acid is not an intermediate in photosynthesis but is probably closely related to some intermediate of the cycle. Absence of labeled succinic and fumaric acids in these experiments, in addition to the failure of malonate to inhibit photosynthesis, precludes the participation of these acids as intermediates in photosynthesis.

None

"Model investigations were made to determine the ditching characteristics of three typical multiengine airplanes equipped with possible arrangements of hydro-ski ditching gear. The behavior of the models was determined from visual observations, acceleration records, and motion pictures of the landings. Data are presented in tabular form and sequence photographs" (p. 1).

Report discussing an investigation of the effect of spanwise aileron location on the rolling effectiveness of plain faired ailerons on untapered wing plan forms with designated sweep, airfoil sections, and aspect ratio using rocket-propelled test vehicles. Drag data is also presented for all configurations tested. Spanwise aileron location was found to have little effect on the effectiveness of the aileron on an unswept wing plan form.

Report discussing the stability and control characteristics and drag of a canard or tail-first configuration explored using the free-fall method. Information about the basic flight characteristics, experimental coefficients, zero-lift drag configurations, and longitudinal stability and trim characteristics is provided.

A flight investigation in natural icing conditions was conducted to determine the effect of inlet ice formations on the performance of axial-flow turbojet engines. The results are presented for icing conditions ranging from a liquid-water content of 0.1 to 0.9 gram per cubic meter and water-droplet size from 10 to 27 microns at ambient-air temperature from 13 to 26 degrees F. The data show time histories of jet thrust, air flow, tail-pipe temperature, compressor efficiency, and icing parameters for each icing encounter. The effect of inlet-guide-vane icing was isolated and shown to account for approximately one-half the total reduction in performance caused by inlet icing.

Report presenting an investigation of the pressure distribution over a rectangular wing with a 9-percent-thick symmetrical circular-arc section and a 30-percent-chord trailing-edge flap. Results are given for pressure distributions, Schileren and liquid-film studies, and wing section characteristics are provided.

Report presenting measurements of the longitudinal stability and control characteristics of a canard airplane configuration using the wing-flow method. The investigation included measurements of lift, pitching moment, and rolling moment of the semispan model with control settings between several different degrees. The experimental data are presented in summarized or abridged form and calculated trim curves are presented for various flight loading conditions.

Report presenting an investigation of zero-lift drag of a fin-stabilized wing-body combination made at high-subsonic and supersonic speeds in a range of Reynolds numbers. The data are presented with that from a wingless body and similar winged body with a slightly different ratio of body frontal area to wing area. Results regarding total drag and wing-plus-interference drag are provided.

Report of testing on an untapered 35-degree sweptback airfoil-flap model, representative of a wing or tail surface, with several 1/4-chord full-span flaps differing in aerodynamic balance. A plain flap, a horn-balanced flap, and a beveled-trailing-edge flap were compared to a flap that had a 31-percent-flap-chord overhang balance. Information about lift, pitching-moment, and hinge-moment characteristics is provided.

Report presenting a theoretical analysis of a supersonic canard missile configuration to show the means that might be used to improve its dynamic performance characteristics. The analysis was conducted by using the best available estimates of aerodynamic and airframe parameters. Results regarding missile longitudinal performance, selection of rate factor, angle of attack and normal acceleration, frequency response, pole plots, and tip control are provided.

Report presenting an investigation to determine the ditching characteristics of three typical multiengine airplanes equipped with different arrangements of hydro-ski ditching gear. The behavior was determined from visual observations, acceleration records, and motion pictures of the landings. Results regarding ski size, shape, and location are provided.

This report follows work with the purposes of determining the minimum amount of nitric acid required to dissolve slurries of stored metal waste, determining the stability of such metastable solutions as a function of their chemical compositions - primarily acidity - versus time and temperature, and to define a feed suitable for a low-acid TBP process flowsheet, and to indicate the range of variations in composition which can be tolerated for plant operation.

This report follows experiments conducted to determine an alloy addition agent for uranium which would subsequently increase the yield strength and creep resistance of uranium.

Quarterly progress report on various research projects conducted at the University of California Radiation Laboratory.

A report concerning fast neutrons including theory and compiled data.