This progress report discusses the work during the fourth quarter of 1951. During this quarter, "the uranium raw materials program at ORNL has been devoted to studies of uranium chemistry and to the development of processes for deriving uranium and byproducts from various types of ores" (From introduction).

Technical report covering the work done to explore heat transfer analytically and experimentally in liquid metals in turbulent flow within the thermal entrance region of circular tubes having uniform well temperature. Includes implications of this research. [From Summary]

From abstract: "This report summarizes the corrosion data obtained for nine construction materials located throughout the ORNL Purex Pilot Plant Acid Recovery Unit during seven hundred hours of operation."

Technical report containing the general arrangement of the Low Intensity Training Reactor and outcomes of experiments that have been performed in the reactor to measure the rate of fission product heat dissipation from the fuel pieces after loss of water. [From Summary, Introduction]

The power and estimated reprocessing load are tabulated for existing and proposed United States and United States-built reactors of 10 Kw or greater thermal power.

This memorandum is the first in a series reporting progress in the program of critical experiments in the ORNLArmy Package Power Reactor Project. The critical assembly, designated as CA-25, is analogous to the APPR design core and consists of 45 fuel boxes, in a 7 x 7 array with the corners removed, contaIned in a large water tank. Two sides of each box are slotted for the insertion and positioning of any desired loading of eighteen plates of fuel, structural material, and poison. The array is submerged in water to provide a moderated and reflector. Enriched uranium metal, in two-mil-thick foils 2.5 x 22 in, is encased in type 304 stainless steel sheets, 2.7 x 23 x 0.0105 in., to form fuel plates. Stainless steel plates, 2.7 x 23 x 0.025 in. are used to simulate additional steel in the APPR core. It is, therefore, possible to maintain an essentially constant metal to water ration in the assembly when the fuel content is varied. The fuel is distributed as uniformly as possible in all boxes and a symmetrical distribution of materials is maintained in the core at all times. Fuel plates containing half-width (1.25 in) uranium foils are provided for …

Report issued by the Oak Ridge National Laboratory discussing semiannual progress made by the Instrumentation and Controls Division. Descriptions of progress and studies conducted are presented. This report includes illustrations, and photographs.

Report issued by the Oak Ridge National Laboratory discussing revisions to previously issued conversion coefficient tables. The revised tables are presented. This report includes tables, and graphs.

Report issued by the Oak Ridge National Laboratory discussing aqueous homogeneous reactors used in central-station power. As stated in the introduction, "it contains an evaluation of the potentiality of producing power only, as exhibited by aqueous homogeneous systems" (p. 6). This report includes tables, and illustrations.

Electrodialysis in an ion-exchange membrane cell was shown to be technically feasible for the concentration of an azeotropic mixture of HF and water. A flowsheet is presented for recovery of anhydrous HF by distillation and electrodialysis of the azeotropic residue. In the electrodialysis step, 2.6 kwhr of energy per pound of anhydrous product was consumed, with electricity at 1¢ per kilowatt-hour, the total operating cost of the electrodialysis equipment alone, including amortization, would be 6¢ per pound of HF.

This progress report discusses new additions to the Mathematics Panel and discusses new and further work happening at Oak Ridge National Laboratory relating to the Mathematics Panel, of particular note is the Oak Ridge computer which is being fabricated at Argonne National Laboratory and the Technitrol Company.

The design of internally cooled electrical coils for the production of high frequency intensity magnetic fields presents many new aspects and combinations of the familiar modes of heat transfer. However, the customary methodology appears to be sufficient for preliminary analysis and understanding of those problems. This methodology comprises the derivation of a qualitative, approximate equation expressing the relative performance of the various parts of a system, followed by an examination of this equation in order to locate the limiting features of the system. These features are then investigated by more powerful methods, which in turn provide guidance for development research in the laboratory.

The measured diffusivity of uranyl nitrate in water at 25ºC was 0.7*10^e cm^2/sec with about 40% average deviation. A program was started to develop nonnuclear uses for depleted uranium. Two continuous DRUHM reaction tuns were terminate due to erratic operation of the sodium metering system. In the second Fluorox run with crude UF, which lasted for 29 hr, a total material balance of 94.8% was obtained and 17.9& of the theoretical amount of UF was collected in cold traps and chemical traps.

In the use of a reactor as a device to measure neutron cross sections, the pile oscillator is often employed because of its much higher sensitivity compared to that available in static reactivity measurements. The factor limiting the available in static reactivity measurements. The factor limiting the available sensitivity is the generation of random noise, which originates in the statistical nature of the chain reaction. In other words, the nuclear reactions which maintain the chain reaction do not proceed uniformly, but rather at rates which fluctuate in time around some average values. These fluctuations limit the accuracy of measurements in the reactor.

A helium coolant side-stream purification system consisting of parallel sections for radioactive and non-radioactive de-contamination was designed for the proposed Pebble Bed Reactor Experiment. Primary equipment components are two gas coolers, gas heater, charcoal delay trap, CuO oxidizer, Molecular Sieve adsorber, and full flow filter. The charcoal delay trap is sized to provide a hold-up of 30 minutes for Kr isotopes, 6hr hold-up for Xe isotopes, and 99.9% retention of iodine isotopes resulting in "de-contamination factors" varying from l for Kr85 to 556 for I131. Non-radioactive de-contamination will result in a steady state concentration of CO2 in the coolant of 20.8ppm or less.

The new and as yet unsolved problems introduced by the production of large quantities of fission products and radioactive isotopes from fission or neutron capture present mankind a most complex technical, economic, and political problem. On one hand, the possibility of using the fission process to produce energy from an unexploited and abundant natural source is emerging from large programs of research and development. We are also beginning to see the promise of use of particulate and electromagnetic radiation for the good of man. On the other hand, we are presented with the problem of controlling the dangerous products of fission for periods of time measured in terms of many hundreds of years, periods longer than the effective tenure of any political state in history. We must not only devise ways of protecting ourselves in the present and for our lifetime but, in addition, we must establish the basic technical, social, and administrative control of vast quantities of artificial radioactivity that must remain effective for at least ten to twenty lifetimes.

Several compatibility test of various materials in contact in sodium under 500 psi pressure were conducted for 716 hr at 1500 F. Of the diffusion couples studies, the Inconel-beryllium system showed the largest amount al alloying. The reaction between molybdenum and beryllium resulted in the formation of two compounds, both of which were severely cracked in several areas. The molybdenum-INOR #8, and the INOR #8p type 316 stainless steel interfaces showed little if any alloying.