Resource Type

Shielding on a 27,300 SHP Boiling Water Reactor Marine Propulsion System (open access)

Shielding on a 27,300 SHP Boiling Water Reactor Marine Propulsion System

This report summarizes the radiation and shielding analysis for a 30,000 SHP natural circulation boiling water reactor for ship propulsion. The reactor is proposed for installation in a 60,000 DWT, 18 knot tanker of the T-7 class.
Date: July 25, 1959
Creator: Craig, W. D.
Object Type: Report
System: The UNT Digital Library
Neutron Leakage Through Iron (open access)

Neutron Leakage Through Iron

Neutron attenuation in the old pile shields is dependent more and more on the slowing down characteristics of the iron as the hydrogen is baked out of the masonite. For neutrons above 1 or 2 Mev, iron does a good job by inelastic scattering. However, below this energy attenuation can be done only by the gradual moderation by elastic scattering to thermal energies with subsequent capture in the iron. Since iron is heavy and thus a poor moderator, there is a good possibility that many neutrons of intermediate energy will leak out of a burned out shield. Also, iron has a large dip in its cross section at 25 Kev which might allow a large burst of neutrons at this energy to leak out. Measurements using a lucite moderator with gold foil detectors indicate a large leakage of neutrons of intermediate energy, but interpretation of these measurements is difficult. These considerations prompted an attempt to get a rough idea of the energy distribution of the leakage neutrons through pure iron using a simple qualitative theory.
Date: July 25, 1956
Creator: Wood, D. E.
Object Type: Report
System: The UNT Digital Library
Atmospheric Contamination Associated with Inert-Gas-Shielded, Consumable Electrode Welding (open access)

Atmospheric Contamination Associated with Inert-Gas-Shielded, Consumable Electrode Welding

Apparent excessive concentrations of atmospheric contamination which were reported to be associated with an inert-gas-shielded consumable electrode arc wielding operation were studied to evaluate the potential health hazards. A study was made of the concentrations of metal fume and gaseous products of the operation as well as the spectrum of ultraviolet radiation. Recommendations for necessary controls were made.
Date: July 25, 1955
Creator: Adley, F. E. & Gill, W. E.
Object Type: Report
System: The UNT Digital Library
Tests on a High Current R.F. Joint in Vacuum (open access)

Tests on a High Current R.F. Joint in Vacuum

An R.F. joint tester was designed to determine the relative heating and tendency toward arching at high RF current density (100 amps/linear inch) of a 12 inch diameter circular copper butt joint in vacuum with several types of inserts and at various amounts of axial loading, ranging from a very small contact pressure to one of 1400 pounds per linear inch of joint.
Date: July 25, 1951
Creator: Wharton, Charles B.
Object Type: Report
System: The UNT Digital Library
Removal of ruptured slug from tube No. 2169-B (open access)

Removal of ruptured slug from tube No. 2169-B

The 105-B Pile which was shut down on July 18, 1951 to permit removal of a ruptured uranium slug from tube No. 2169-B. The rupture was detected from effluent water monitor evidence and a survey of rear face pigtails. Removal was accomplished with the pneumatic charging machine using only normal pushing force.
Date: July 25, 1951
Creator: Baker, J. T.
Object Type: Report
System: The UNT Digital Library
Laboratory project for isolation of plutonium (open access)

Laboratory project for isolation of plutonium

Construction of proposed facilities to be operated under Technical Division supervision for research with plutonium is discussed. An attempt is made in this memorandum to visualize the research program for such a facility for the next five years, to aid in determining whether the cost of providing such facilities is justified.
Date: July 25, 1955
Creator: Jenkins, W. A.
Object Type: Report
System: The UNT Digital Library
Analytical procedures for the plutonium Metal Fabrication Process (open access)

Analytical procedures for the plutonium Metal Fabrication Process

Report describing the results of the cupferron extraction-copper spark method in determining the impurity elements in plutonium metal. This was required the 234-5 Project analytical program.
Date: July 25, 1952
Creator: Bierlein, T. K.; Kendall, L. F. & Van Tuyl, H. H.
Object Type: Report
System: The UNT Digital Library
Analytical Procedures for the Plutonium Metal Fabrication Process (open access)

Analytical Procedures for the Plutonium Metal Fabrication Process

Report describing methods of determining trace impurities in plutonium in connection with the Metal Fabrication Process. The methods included are the cupferron extraction-copper spark method and the direct copper spark method.
Date: July 25, 1952
Creator: Bierlein, T. K.; Kendall, L. F. & Van Tuyl, H. H.
Object Type: Report
System: The UNT Digital Library
Natural Steam and Geothermal Power Generation : [bibliography] (open access)

Natural Steam and Geothermal Power Generation : [bibliography]

The following document is a bibliography containing a collection of documents discussing natural steam and geothermal power generation.
Date: July 25, 1958
Creator: Maynard, G. R.
Object Type: Report
System: The UNT Digital Library
Preparation and Properties of RAF Solutions : Low Acid TBP Flowsheets HW Number 4 and HW Number 5 (open access)

Preparation and Properties of RAF Solutions : Low Acid TBP Flowsheets HW Number 4 and HW Number 5

This report follows work with the purposes of determining the minimum amount of nitric acid required to dissolve slurries of stored metal waste, determining the stability of such metastable solutions as a function of their chemical compositions - primarily acidity - versus time and temperature, and to define a feed suitable for a low-acid TBP process flowsheet, and to indicate the range of variations in composition which can be tolerated for plant operation.
Date: July 25, 1950
Creator: Maness, R. F. & Harmon, M. K.
Object Type: Report
System: The UNT Digital Library
The Prompt Radiations in the Spontaneous Fission of Cf²⁵² (Revised) (open access)

The Prompt Radiations in the Spontaneous Fission of Cf²⁵² (Revised)

Summary: The radiations emitted in the spontaneous fission of Cf²⁵² have been studied. The results in general are in agreement with other similar measurements. An experiment is described which is expected to give the neutron energies and angular distribution in the center-of-mass system of the moving fission fragment when the analysis is completed.
Date: July 25, 1958
Creator: Bowman, H. R. & Thompson, Stanley Gerald, 1912-1976
Object Type: Report
System: The UNT Digital Library
THE EFFECT OF PLANT THERMAL EFFICIENCY ON THE COST OF NUCLEAR POWER (open access)

THE EFFECT OF PLANT THERMAL EFFICIENCY ON THE COST OF NUCLEAR POWER

Nuclear power cost is plotted versus thermal efficiency. The relationship is not limited to any particular reactor type and is applicable for any reactor system where steam is the working fiuid for the turbogenerator. (T- R.H-)
Date: July 25, 1958
Creator: Albrecht, W.L.
Object Type: Report
System: The UNT Digital Library
Remote Maintenance Experimental Work on a Reactor System Pump (open access)

Remote Maintenance Experimental Work on a Reactor System Pump

An experimentally determined evaluation of standardremote-handling equipment applied to the problems associated with remote maintenance of a typical reactor system component is presented It is comcluded that commercially available equipment can be used and that a good techmician can rapidly learn the use of manipulators required in remote maintenance. The use of closed circuit television in maintenance is possible; however, further development of radiation- resistant equipment is required. (j.R.D.)
Date: July 25, 1958
Creator: McDonald, W.B.; McGlothlan, C.K. & Storto, E.
Object Type: Report
System: The UNT Digital Library
THE PHYSICAL PROPERTIES OF TITANIUM AND TITANIUM ALLOYS (open access)

THE PHYSICAL PROPERTIES OF TITANIUM AND TITANIUM ALLOYS

None
Date: July 25, 1957
Creator: Lepkowski, W. J. & Holladay, J. W.
Object Type: Report
System: The UNT Digital Library
Some Comments on the Mechanism of Fission (open access)

Some Comments on the Mechanism of Fission

A correlation of spontaneous fission rates with Z and A is made to show that these rates depend on the nuclear type. Some suggestions as to the mechanisms are given and it is also shown how these relate to the mechanism of slow neutron and photo fission.
Date: July 25, 1951
Creator: Seaborg, Glenn T.
Object Type: Report
System: The UNT Digital Library
Geophysical Investigations for United States Atomic Energy Commission in the Colorado Plateau Area (open access)

Geophysical Investigations for United States Atomic Energy Commission in the Colorado Plateau Area

From introduction: The objective of the investigations is to test the usefulness of these geophysical procedures in connection with exploration for uranium-bearing mineral deposits.
Date: July 25, 1952
Creator: Wantland, Dart
Object Type: Report
System: The UNT Digital Library
Production test 234-5-1-MS, Evaluation or use of filter paper in conjunction with filter boats (open access)

Production test 234-5-1-MS, Evaluation or use of filter paper in conjunction with filter boats

None
Date: July 25, 1952
Creator: unknown
Object Type: Report
System: The UNT Digital Library
Description and Some Safeguard Aspects of Proposed Developmental Fast Neutron Breeder Reactor (open access)

Description and Some Safeguard Aspects of Proposed Developmental Fast Neutron Breeder Reactor

Report that generally describes sodium cooled fast reactors, the features and facilities of such a reactor proposed by Atomic Power Development Associates, and then its safety and siting considerations.
Date: July 25, 1955
Creator: Atomic Power Development Associates
Object Type: Report
System: The UNT Digital Library
Texas Attorney General Opinion: WW-176 (open access)

Texas Attorney General Opinion: WW-176

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Will Wilson, regarding a legal question submitted for clarification: Does the Retrieve State Farm, a unit of the Texas Prison System, have the authority to run a fence across Buffalo Camp Bayou at a point entirely within the prison owned property.
Date: July 25, 1957
Creator: Texas. Attorney-General's Office.
Object Type: Text
System: The Portal to Texas History
Texas Attorney General Opinion: V-1218 (open access)

Texas Attorney General Opinion: V-1218

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: Validity of a commissioners' court order creating new justice precincts without correspondingly changing the boundaries of election precincts.
Date: July 25, 1951
Creator: Texas. Attorney-General's Office.
Object Type: Text
System: The Portal to Texas History
Texas Attorney General Opinion: V-1219 (open access)

Texas Attorney General Opinion: V-1219

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Price Daniel, regarding a legal question submitted for clarification: Whether Bexar County may issue time warrants for purchase of right of way.
Date: July 25, 1951
Creator: Texas. Attorney-General's Office.
Object Type: Text
System: The Portal to Texas History
Investigation of the effects of body indentation and of wing-plan-form modification on the longitudinal characteristics of a 60 degree swept-wing-body combination at Mach numbers of 1.41, 1.61, and 2.10 (open access)

Investigation of the effects of body indentation and of wing-plan-form modification on the longitudinal characteristics of a 60 degree swept-wing-body combination at Mach numbers of 1.41, 1.61, and 2.10

Report presenting an investigation in the 4- by 4-foot supersonic pressure tunnel to determine the effects of body indentation on the minimum drag and maximum lift-drag ratio of a 60 degree swept-wing-body combination. A secondary goal of the tests was to determine the effect on the maximum lift-drag ratio of modifying the inboard plan form of the 60 degree swept wing. Lift, drag, and pitching-moment data are presented.
Date: July 25, 1955
Creator: Sevier, John R., Jr.
Object Type: Report
System: The UNT Digital Library
A flight study of requirements for satisfactory lateral oscillatory characteristics of fighter aircraft (open access)

A flight study of requirements for satisfactory lateral oscillatory characteristics of fighter aircraft

Report presenting a pilot-opinion survey conducted with a conventional fighter airplane fitted with special servo devices for varying in flight the dihedral effect, static directional stability, and directional damping. Results showing the boundaries that define satisfactory and tolerable lateral oscillatory characteristics are presented.
Date: July 25, 1951
Creator: Liddell, Charles J., Jr.; Creer, Brent Y. & Van Dyke, Rudolph D., Jr.
Object Type: Report
System: The UNT Digital Library
Experimental investigation of a transonic axial-flow-compressor rotor with double-circular-arc airfoil blade sections 3: comparison of blade-element performance with three levels of solidity (open access)

Experimental investigation of a transonic axial-flow-compressor rotor with double-circular-arc airfoil blade sections 3: comparison of blade-element performance with three levels of solidity

Report presenting testing of two low-solidity transonic axial-flow-compressor rotors tested over a range of speeds up to a corrected tip speed of 1000 feet per second to determine the performance of such rotors and to provide experimental rotor blade-element data for low solidity levels. Comparisons of the hub and mean blade-element losses for the three rotors showed that the losses tended to decrease with a decrease in solidity. Results regarding rotor-inlet conditions, rotor-outlet conditions, overall performance, and stall characteristics are provided.
Date: July 25, 1955
Creator: Schwenk, Francis C. & Lewis, George W., Jr.
Object Type: Report
System: The UNT Digital Library