Data taken on radiation traverse of the Mark 1 control rod were analyzed. Future radiation levels for all SRE control and safety rods were predicted from this. The shielding necessary to ship a complete rod and that necessary to protect a person doing maintenance work on these rods were calculated. The unshielded gamma dose rate 1 cm from the surface of the most highly activated portion of the control rod was calculated to be 5.0 x 10/sup 4/ r/hr 14 days after shutdown following an extended power run of 90 days duration. (M.C.G.)

This report discusses preliminary results acquired from investigations made on the ultrasonic properties of uranium, such as sonic vibrations in the megacycle frequency range.

The September, 1957 monthly report for the Chemical Processing Department of the Hanford Atomic Products Operation includes information regarding research and engineering efforts with respect to the Purex and Redox process technology. Also discussed is the production operation, finished product operation, power and general maintenance, financial operation, engineering and research operations, and employee operation.

The September, 1958 monthly report for the Chemical Processing Department of the Hanford Atomic Products Operation includes information regarding research and engineering efforts with respect to the Purex and Redox process technology. Also discussed is the production operation, finished product operation, power and general maintenance, financial operation, engineering and research operations, and employee operation. (MB)

A core parameter study of the operating costs was performed for a 300- Mwe sodium graphite reactor, a scale-up of the Hallam Power Reactor. The results of the study indicate that the core design is nsar optimum and that core modifications would reduce the power costs by less than 5%. The lattice spacing, fuel rod diameter, and sodium flow can be varied within a rather broad range without significant changes in power generation costs. The effect of the fuel cladning thickness is more significant; fuel cycle costs can be reduced if stainless steel canning is replaced with zirconium canning. Use of UC in place of uraniummolybdenum fuel would also permit cost reductions. (D.L.C.)

None

None

It is the purpose of this report to review our experience with recombiners under actual reactor operating conditions, and to discuss new developments in the field.

None

Double-ramp side inlet with combinations of fuselage, ramp, and throat boundary layer removal.

"In the present paper attention is directed to the aerodynamic parameters, the so-called stability derivatives, that affect the lateral behavior of airplanes and missiles. The discussion is centered on three important quantities, the effective-dihedral derivative, the directional-stability derivative, and the damping-in-roll derivative. These quantities are considered for a large angle-of-attack range at subsonic speeds" (p. 1).

Report presenting testing of JP-3 fuel and a slurry of 60 percent powdered magnesium in JP-3 fuel in a small-scale afterburner in the presence of large quantities of water vapor. The results indicated that total temperature, combustion efficiency, and air specific impulse were improved when the magnesium slurry was used, but the improvements came at the cost of increased liquid consumption.

Memorandum presenting the results of an experimental investigation to determine the effects of Reynolds number on the flow characteristics over a delta wing at a Mach number 2.41. The wing streamwise airfoil sections are based on the NACA 00-thickness series with the maximum thickness varying from 4 percent at the root section to 6.24 percent at the 90-percent spanwise station. Results regarding force data and pressure-distribution data are provided.

Report presenting the low-speed lateral control and hinge-moment characteristics of a 20-percent-chord plain aileron on a 47.7 degree sweptback wing of aspect ratio 5.1 in the pressure tunnel. The tests were performed with and without high-lift and stall-control devices. Results regarding the basic aileron data, rolling-moment characteristics, and pitching-moment characteristics are also provided.

Testing occurred using the NACA wing-flow method at a range of Mach numbers to determine the effect on aerodynamic characteristics of reversing a triangular wing with a 6-percent-thick biconvex section. Results regarding the lift characteristics, drag characteristics, and pitching-moment characteristics are provided.

Report presenting an investigation of the longitudinal characteristics of a wing with 45 degree sweepback of the quarter-chord line, an aspect ratio of 8, a taper ratio of 0.45, and NACA 63(sub)1A012 airfoil sections. The results were obtained from force measurements and distribution measurements for a range of Reynolds numbers. Information regarding lift and pitching-moment characteristics, drag characteristics, and loading characteristics is provided.

From Introduction: "This report presents the initial study, the tracking performance of typical fighter airplanes with fixed gunsights. The types of airplanes tested afford two comparisons of particular interest: that between typical World War II and currently operational fighters of greatly increased speed and altitude, and that between conventional and irreversabile power-boosted controls with artificial feel, both installed on the same airframe."

Report discussing free-flight tests of normal-shock nose-inlet models with 1-series, parabolic, and conic cowling profiles in order to investigate the external drag characteristics at an angle of attack of 0 degrees. The testing occurred at a variety of Mach numbers, mass-flow ratios, and Reynolds numbers. Information about the effect of afterbody length, basic data, and effect of cowl shape is provided.

The results of a study to determine reliable heat transfer data for the design of a suitable heat exchanger for the Intermediate Scale Homogeneous Reactor are presented. Design studies of a vertical submerged-tube evaporator with nucleate boiling from the outer tube surfaces and of a vertical tube, forced-circulation evaporator are presented in detail. (M.P.G.)

None

The design features and the performance of UO/sub 2/SO/sub 4/ blanket processing Loop P-1 are evaluated from an engineering viewpoint. This unique experiment development loop was operated with pump heating to study the behavior of plutonium in 1.4 M UO/sub 2/SO/sub 4/at 250 deg C and was designed for mixed O/ sub 2/-H/sub 2/ gas pressurization The canned loop and the feed and sampling systems in glove boxes completely contained the plutonium throughout the experimental program. (auth)

The physical limitations of existing storage tanks for radioactive wastes from separations plants are defined as a guide for preparing process and operating criteria for the existing tank forms to assure continued integrity of the tanks. A "safe-load" curve for each of the four groups of tanks based on current technology is presented. Loading conditions, operation procedures, and thermal stresses are discussed. (M.C.G.)

Abstract: "The oxidation resistance of thin sheets of iron-28 w/o chromium-2.67 to 10.0 w/o alloys, nominally 0.004, 0.006, 0.008, 0.012, and 0.016 in. thick, was determined by exposure in static air for 100 hr at 2100 and 2300 F. A minimum of 3.67 and 9.37 w/o aluminum was necessary to prevent excessive oxidation of 0.004-in.-thick sheet material at 2100 and 2300 F, respectively. Correspondingly, specimens of lower aluminum content and greater thickness withstood the oxidation attack. Oxidation of iron-chromium-aluminum alloys appeared to be related to the diffusion of aluminum to surfaces of the sheet to form an adherent protective layer of Al2O3."

This document details activities of the irradiation processing department during the month of September, 1959. A general summary is included at the start of the report, after which the report is divided into the following sections: Research and Engineering Operations; Production and Reactor Operations; Facilities Engineering Operation; Employee Relations Operation; and Financial Operation.