"The external wave drag of bodies of revolution moving at supersonic speeds can be expressed either in terms of the geometry of the body, or in terms of the body-simulating axial source distribution. For purposes of deriving optimum bodies under various given conditions, it is found that the second of the methods mentioned is the more tractable. By use of a quasi-cylindrical theory, that is, the boundary conditions are applied on the surface of a cylinder rather than on the body itself, the variational problems of the optimum bodies having prescribed volume or caliber are solved" (p. 131).

Report presenting results from a limited flight program to obtain information on airplane response and actual rates and amounts of control motion used by service pilot in performance of squadron operational training. Results regarding control deflection, control rates, airplane angular velocities, airplane angular accelerations, angle of attack and angle of sideslip, airplane load factors, and airspeed and altitude are provided.

Report presenting the results of an investigation to determine the pressure ratios required to operate a slotted tunnel through a range of Mach numbers where the speed variation is affected by removal of air from the main stream by auxiliary pumping, use of a main-stream-operated ejector located downstream of the test section, and a combination of these methods. Testing was conducted in order to improve the accuracy of transonic wind-tunnel testing.

Report presenting two-group theory calculations to determine the effect of nonuniform uranium loading as compared to uniform loading on the reflector control effectiveness attainable in a large thermal reactor usable for aircraft power application. Results regarding reactivities and investments, uranium distributions, and power distributions are provided.

Report presenting a flight and preflight evaluation of an automatic thrust-coefficient control system in a twin-engine ram-jet missile. A flicker-type single-loop servocontrol system is shown to be a usable way of controlling ram-jet thrust coefficients.

Report presenting an investigation of 57 experimental tubular designs embodying adjacent fuel-rich and air-rich regions and axial staging of the fuel introduction at simulated high-altitude conditions. Results regarding the development of pilot, development of secondary-air admission sleeve, development of final configuration, and performance of best configuration are provided.

Report presenting the results of an experimental investigation of the dynamic stability and control of a simple ducted-fan model in hovering flight in order to provide basic information on the stability and control of jet vertically rising airplanes in hovering flight. The investigation primarily consisted of flight tests with the model hovering at altitude and near the ground.

The present investigation was made at a free-stream Mach number of 1.59 to compare the afterbody drags to a series of conical boattailed models at zero angle of attack. Afterbody drags were obtained for both the power-off and the power-on conditions. Power-on drags were obtained as a function of afterbody fineness ratio, jet pressure ratio and divergence, and jet Mach number.

"Flow-angle and pressure surveys behind five, thin, pointed-tip wings of varying plan form have been made at Mach numbers 1.62 and 2.41. Schlieren studies at a Mach number 1.93 for the same five plan-form wings were made to illustrate the behavior of the vortex sheet. The surveys were conducted at 1.5, 3, and 4 root chords behind three triangular wings of 50 degree, 63 degree, and 72 degree leading-edge sweep angle, and behind the 50 degree triangular wing reversed" (p. 1067).

"An experimental investigation has been conducted to determine the stability and control characteristics of a 0.13-scale free-flight model of the Convair XFY-1 airplane during take-offs and landings in steady winds. The tests indicated that take-offs in headwinds up to at least 20 knots (full scale) will be fairly easy to perform although the airplane may be blown downstream as much as 3 spans before a trim condition can be established. The distance that the airplane will be blown down-stream can be reduced by restraining the upwind landing gear until the instant of take-off" (p. 1).

Report presenting the results of deflection tests on the wing of a full-scale, swept-wing jet bomber in the form of structural influence coefficients relating the deflection of a system of points on the wing and concentrated loads applied on the wing spars. The procedures for determining the coefficients are included.

Memorandum presenting a rocket-propelled model flown to determine the effects of four wing-mounted bomb-type external stores on the trim, buffet, and drag characteristics of a wing-fuselage configuration with a 45 degree sweptback wing. The model is compared with data from a similar model without stores. Results regarding trim, buffet, lift and stability, and drag are provided.