for filtration of plutonium oxalate slurries. A scalpel produces a slit in the filter precoat, leading to increased filtration in this slit, and the oxalate is removed by a doctor knife; this technique results in prolonged blowback cycles and more uniform delivery of filtered oxalate to subsequent processing steps. Several types of filter media were tested, and rigid porous aluminum oxide was found to be the best one. (D.L.C.)

Report presenting an investigation of a fin-stabilized scale model of the NACA RM-10 missile at a Mach number of 1.62. Measurements were made of the lift, drag, and pitching moment of the finned body over a range of angles of attack. Comparisons with the results from other testing facilities are also provided.

Report presenting an investigation of an NACA 1-80-100 nose inlet fitted alternately with an elliptical, a parabolic, a 14 degree-inch conical, and a 22 degree-inch conical central body at subsonic and transonic speeds in the 8-foot transonic tunnel. Drag, surface-pressure, and pressure-recovery measurements were obtained at 0 degrees angle of attack through a range of Mach numbers. Results regarding tunnel boundary interference, surface-pressure distribution, external drag, pressure recovery, and propulsive thrust comparison are provided.

Definite identification has been made of an isotope of the element with atomic number 98 through the irradiation of Cm{sup 242} with about 35-Mev helium ions in the Berkeley Crocker Laboratory 60-inch cyclotron. The isotope which has been identified has an observed half-life of about 45 minutes and is thought to have the mass number 244. The observed mode of decay of 98{sup 244} is through the emission of alpha-particles, with energy of about 7.1 Mev, which agrees with predictions. Other considerations involving the systematics of radioactivity in this region indicate that it should also be unstable toward decay by electron capture. The chemical separation and identification of the new element was accomplished through the use of ion exchange adsorption methods employing the resin Dowex-50. The element 98 isotope appears in the eka-dysprosium position on elution curves containing berkelium and curium as reference points--that is, it precedes berkelium and curium off the column in like manner that dysprosium precedes terbium and gadolinium. The experiments so far have revealed only the tripositive oxidation state of eka-dysprosium character and suggest either that higher oxidation states are not stable in aqueous solutions or that the rates of oxidation are slow. The successful identification …

The flowsheet proposed by KAPL for the treatment of alkaline nitrate radiochemical processing waste has been modified to include an ion-exchange step for the decontamination of cesium, strontium, and other cationic fission products. In laboratory studies of the electrolysis steps in a nitrate reduction cell, synthetic alkaline waste, 0.55 to 4.83 M total electrolyte, was decontaminated from ruthenium by factors of > 210. The nitrate of 3.0 M waste was reduced to ammonia with current efficiencies of 100%. Power consumption was 4.7 kwh/lb of nitrate reduced. Significant factors affecting the rate of ruthenium decontamination were temperature, cathode area, cathode current density, and electrolyte concentration. Those affecting nitrate reduction current efficiencies were the cathode current density, electrolyte concentration, and stirring rate. In an acid-base membrane cell, reusable nitric acid as well as sodium hydroxide was regenerated. However, such a cell is less economical to construct and operate than the nitrate reduction cell. At least 5 kwh of power is required to transfer 1 lb of nitrate from ORNL type waste. In addition, the greater complexity of the acid-base cell makes it less adaptable for remote control.

The following report follows an investigation made to determine the composition of uranium-rich ternary eutectic alloys most suitable for reactor application in the as-cast condition. These determinations were made based metallographic examination and thermal analysis of as-cast alloys.

Report discussing the rolling of thorium rods. Abstract: "Thorium rods, 1-7/16 inch in diameter, were rolled from Ames castings. The billets were roughed down in diamond-grooved rolls and finished in hand-rounding rolls. Remelted chips as well as primary-metal castings were rolled, and both yielded satisfactory rods. The surface quality of the rods was generally excellent, and the machined slugs were free of seams."

Abstract: Information on five uranium binary alloy systems has been surveyed. These systems are the alloys of uranium with zirconium, chromium, columbium, vanadium, and molybdenum. The equilibrium diagrams are discussed, and where available, data have been included on diffusion studies, cladding experiments, and mechanical properties.

Report discussing the redetermination of liquids for aluminum alloys containing 13 to 25 w/o uranium by metallographic examination, thermal analyses, and electrical resistance measurements. In addition, phase diagrams and a method for producing sound, homogeneous aluminum 16 w/o uranium alloy sleeve castings are presented.

This report studies ammonium dichromate and the conditions it needs to be under in order to precipitate and be isolated from an aqueous system.

From Introduction: "The objective of this report are (1) to describe the complete fuel system, (2) to discuss the procedure used for transitions between JP-4 fuel and hydrogen, and (3) to present and discuss engine performance obtained with both fuels, and (4) to review the reliability of the fuel system."

Report presenting an investigation of a liquid-hydrogen fuel system developed to operate one of the turbojet engines in a twin-engine light bomber at an altitude of 50,000 feet and Mach number 0.75. The heat exchanger was evaluated in an altitude test chamber in conjunction with the complete aircraft fuel system. Results regarding calculated heat-exchanger performance, experimental heat-exchanger performance, and reliability are provided.

Memorandum presenting the system analysis, design, and performance of a control system for an experimental flight-type hydrogen fuel system. The fuel system was designed to investigate some of the problems associated with the utilization of hydrogen as an aircraft fuel. Speed control of the engine was obtained by coupling the hydrogen regulator to the JP-4 fuel control.

Memorandum presenting testing of a twin-engine light bomber modified to utilize hydrogen fuel in one of the two engines during flight at an altitude of 50,000 feet. Three completely successful flights were made using hydrogen fuel. Data are presented to show the effect of tank agitation on fuel pressure and fuel losses.

From abstract: "A continuous countercurrent solid-liquid contactor has been developed which retains the desirable features of the conventional fixed bed and gains the advantages of countercurrent flow. It can be adapted to many solid-liquid mass-transfer processes such as ion exchange, silica gel adsorption, and ore leaching."

None

The objective of this test is to establish that scavenging of first-cycle wastes in the Bismuth Phosphate Plant will give a supernatant liquor, after the precipitate settles, that may be routinely cribbed. This test will also perform the functions: establish an effective scavenging procedure, shakedown the pH monitor, and train operational personnel. This document discusses test procedures and results.

Technical report describing a brief survey of the problems concerned with radioactive waste disposal.

Technical report investigating the corrosion resistance of thorium and thorium alloys containing from 2 to 6% chromium, columbinium (niobium), titanium, zirconium and titanium-zirconium in distilled water at 95ºC. The true effects of the various alloy additions could not be determined because of the more marked effect of cold working. [From Abstract]

Technical report presenting a consideration of the characteristics of fused salt-ThF4 solutions suitable for use in homogeneous reactors. Presented in tandem with a brief survey of the literature pertaining to such solutions and a summary of the experimental work accomplished. [From Abstract]

From abstract: "This report presents the laboratory development of the MTR-RaLa Process for the production of barium140 from Materials Testing Reactor assemblies." The laboratory studied four possible chemical schemes with the final process being chosen "on the basis of chemical yield and purity of product, ease of recovery of uranium235, simplicty of equipment, and overall time required for processing" (from introduction).

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Will Wilson, regarding a legal question submitted for clarification: Motor Fuel Tax Refund

Document issued by the Office of the Attorney General of Texas in Austin, Texas, providing an interpretation of Texas law. It provides the opinion of the Texas Attorney General, Will Wilson, regarding a legal question submitted for clarification: Is the Austin State School Farm a separate institution apart from the Austin State School, and related questions.

The General Electric Company has prepared in past years numerous documents for the Atomic Energy Commission outlining in some detail its current and proposed programs at Hanford. Last year, at the request of the commission, program types of information were consolidated into one document, the HAPO Five Year Program. That document was well received and useful to an extent that the General Electric Company was requested by the Commission to prepare another covering the fiscal years 1959 through 1963. In outlining the five year program for the Hanford Atomic Products Operation, the General Electric Company has made assumptions regarding the US Atomic Energy Commission`s current and future programs and Hanford`s relationship to these programs. Two major objectives of the Commission were considered basic for future planning: first, to provide adequate atomic weapons for national defense; and second, to encourage and assist in the development of atomic energy for peaceful uses. The Hanford contributions to these objectives are conceived to include the acquisition and potential application of new technology in support of: (1) Increased production of plutonium, as nitrate solution, buttons, and as current and future shapes. (2) A program that will provide the technological capability to implement broad changes in …