Report discussing an improvement program on lithium mass spectrometers.

Abstract: This report describes an advanced sodium-cooled, graphite-moderated nuclear power plant which utilizes high-pressure, high-temperature steam to generate electricity at a high thermal efficiency.

Abstract: It has been proposed that a fuel element containing porous uranium be used for moderately high temperature applications. In an effort to determine the structural integrity of this type of fuel body, thermal cycling tests have been conducted on porous uranium.

"Results of the continuing stratospheric flight test evaluation program for the Del Model I Electrostatic Precipitator Sampler and the Del Electrical Discharge Altimeter are described and discussed. Only one of four balloon launches reached floating altitude. The altimeter obtained an altitude recording consistent with concurrent aneroid barocoder readings. The reported gross gamma concentration for the precipitator sampler was approximates 25 and 80% higher than those of the two simultaneous direct flow filter samples. The completion of the design and construction of two prototype units of the Del Electrical Discharge Altimeter and their laboratory evaluation are described. A preliminary design concept is presented for an operational high volume electrostatic precipitator sampler to operate with high collection efficiency at an ambient flowrate of 500 cfm throughout the altitude range 100,000 to 150,000 ft."

Abstract: In the March-April 1962 shutdown of SM-1 Core II, the SM-28 element will be re-inserted in SM-1 Core II and an SM-1 Core I element will be removed. An SM-1 Core II europium absorber will be replaced by a Ag-Cd-In absorber, and surveillance specimens will be inserted above the core support structure. Analysis of these changes concludes that re-insertion of the SM-2B stationary element and insertion of surveillance specimens do not affect hazards potential previously defined for SM-1. Replacement of the europium absorber by the Ag-Cd-In absorber will have negligible effect on reactivity control worth of the rod. The absorber meat section is encapsulated to prevent exposure of silver alloy to the primary coolant; postulated release of silver due to a cladding defect, after 2 years irradiation in SM-1, would not cause a hazard such as to restrict access to the vapor container. Possibility of steam formation in the air gap between the absorber core and cladding, causing a cladding failure, is remote. Deformation of the absorber section sufficient to cause the rod to stick, would not impair the ability of the other rods to shut down the reactor safely.

Specifications including detail dimension, materials, fabrication steps, acceptance criteria, and final assembly steps for the swaged uranium dioxide, 19-rod cluster Plutonium Recycle Test Reactor fuel element.

Abstract: An element by element reactivity check for SM-1 Core II fuel elements and control rod absorber sections was performed and the burnable nuclear poison loading in the SM-1 Core II stationary fuel elements was established. An approach to criticality of the SM-1 Core II was performed by the inverse multiplication method and the critical rod bank position obtained as a function of fuel loading up to the full SM-1 Core II loading. Maximum and minimum core reactivity measurements were obtained by selective loading of stationary fuel elements and the total "excess K" for the core established. Power distribution measurements in the region of the core-reflector interface and the fuel-absorber interface in the control rod assemblies were performed. The effectiveness of europium flux suppressors in the top of control rod fuel elements and the power peaking in stationary elements adjacent to water gaps in control rod assemblies were measured. Survey measurements established the worth of spiking cold clean SM-1 cores with SM-2 elements, and of water holes in the SM-1 core which might be utilized as flux traps for materials irradiation.

"Adlam and Allen and Davis, Lust, and Schluter have studied nonlinear plane-waves, propagating normal to the magnetic field, in a cold plasma. One solution of particular interest is a solitary wave, or single pulse. We present a method for solving the analogous problem for a plasma with finite temperature, in the limiting case where the amplitude of the wave is small and where, consequently, the width of the waver is very large."