Measurements of dielectric leakage, capacitance, electric strength, andd charge scattering phenomena were performed at the Kukla and Godiva III critical assemblies for tantalum and aluminum electrolytic, wax- and oilimpregnated paper, mylar, mica, and ceramic capacitors, and for mylar and Vitamin B-impregnated paper. Leakage data indicate that gamma induced conductivity in capacitor dielectric varies directly with gamma DELTA , where gamma is the gamma radiation rate and DELTA is 0.9 for mylar, 0.7 for Vitamin Q-impregnated paper, and approximately 1.0 for the other dielectrics. A small portion of the tantalum oxide conductivity induced by gamma radiation exhibited a recovery time of approximately 150 mu s. Transient capacitance changes due to radiation were non- existent within plus or minus 0.1% for mica and Vitamin Q capacitors. Transient charging of tantalum capacitors was noted during irradiation with no applied voltage. No drastic changes in electric strength were noted during irradiation of mylar and Vitamin Q-impregnated paper. Results are compared with a summary of data previously collected by others. The use of test data in parametric form as a tool for predicting transient radiation effects is discussed. (auth)

A summary is presented of activities in reactor and general engineering research programs. Discussions are included for developments in EBWR, BORAX-V, ZPR-III. ZPR-VI, ZPR-IX, EBR-I, and EBR-II. Reactor safety studies were performed for fast and thermal reactors. Nuclear technology developments are discussed for applied nuclear and reactor physics, reactor fuels and materials development, heat engineering studies, separations processes, and advanced reactor concepts. (B.O.G.)

This report deals with some techniques in applied programming using the Livermore Timesharing System (LTSS) on the CDC 7600 computers at the National Magnetic Fusion Energy Computer Center (NMFECC) and the Lawrence Livermore Laboratory Computer Center (LLLCC or Octopus network). This report is based on a document originally written specifically about the system as it is implemented at NMFECC but has been revised to accommodate differences between LLLCC and NMFECC implementations. Topics include: maintaining programs, debugging, recovering from system crashes, and using the central processing unit, memory, and input/output devices efficiently and economically. Routines that aid in these procedures are mentioned. The companion report, UCID-17556, An LTSS Compendium, discusses the hardware and operating system and should be read before reading this report.

An information storage and retrieval system (PIC) was developed, utilizing the IBM 7090 computer, for handling data pertaining to the effects of neutron irradiation on metals. The input includes a reference identification, an appropriate abstract or extract summarizing the article, code identification parameters analogous to those used by the ASM-SLA Literature Classification System, and special codes identifying relevant irradiation and testing parameters. The output contains the same data plus printing out the meaning of all special codes. Presently, the information storage consists of more than two hundred references representing several thousand lines of information. The system is both general and definitive, permitting the selection of a single piece of information or of many references dealing with a general field. It is possible to select material on the basis of one or more of the following factors: material, general or specific; type of literature; general or specific property such as mechanical tests or tensile tests; conditions of irradiation including type and level of flux, integrated flux, irradiation temperature, and reactor environment; test conditions such as temperature and environment; and general variables that might be controlling such as strain rate, specimen geometry, grain size, and fabrication history. It is felt that this …

The number and types of cables for various experiments planned for the ISABELLE storage rings are estimated, and the results of a questionnaire on anticipated data taking rates are discussed. Necessary data acquisition rates, data storage capabilities, and data processing rates are estimated. (PMA)

The toxicology and metabolism of nickel compounds (e.g., NiCl/sub 2/, ..cap alpha..Ni/sub 3/S/sub 2/, and Ni(CO)/sub 4/) were investigated in rats and hamsters.

Extremely smooth, uniform metal coatings of micrometer thicknesses on microscopic glass spheres (microspheres) are often needed as targets for inertial confinement fusion (ICF) experiments. The first part of this paper reviews those methods used successfully to provide metal coated microspheres for ICF targets, including magnetron sputtering, electro- and electroless plating, and chemical vapor pyrolysis. The second part of this paper discusses some of the critical aspects of magnetron sputter coating of microspheres, including substrate requirements, the sticking of microspheres during coating (preventing a uniform coating), and the difficulties in growing the desired dense, smooth, uniform microstructure on continuously moving spherical substrates.

Augmented Fish Health Monitoring Contract AI79-87BP35585 was implemented on July 20, 1987. Second year activities focused on full implementation of disease surveillance activities and histopathological support services to participating state agencies. Persistent and sometimes severe disease losses were caused by infectious hematopoietic necrosis (IHN) in summer steelhead trout in Idaho and in spring chinook salmon at hatcheries on the lower Columbia River. Diagnostic capability was enhanced by the installation, for field use, of enzyme-linked immunosorbent assay (ELISA) technology at the Dworshak Fish Health Center for the detection and assay of bacterial kidney disease and by a dot-blot'' training session for virus identification at the Lower Columbia Fish Health Center. Complete diagnostic and inspection services were provided to 13 Columbia River basin National Fish hatcheries. Case history data was fully documented in a computerized data base for storage and analysis. This report briefly describes work being done to meet contract requirements for fish disease surveillance at Service facilities in the Columbia River basin. It also summarizes the health status of fish reared at those hatcheries and provides a summary of case history data for calendar year 1988. 2 refs., 4 tabs.

This report is the first part of a comprehensive summary of the literature on hydrogen isotope permeability through materials that do not readily form hydrides. While we mainly focus on pure metals with low permeabilities because of their importance to tritium containment, we also give data on higher-permeability materials such as iron, nickel, steels, and glasses.

The Institute of Paper Science and Technology (IPST) has received a project grant from the US DOE to develop and demonstrate the use of realtime process simulation modeling as a means of process analysis and optimization. The Project, to be conducted under the auspices of the International Energy Agency (IEA), will target a Thermo-Mechanical Pulping (TMP) operation as the site for the commercial implementation of the technology. IPST and a sub-contractor, SACDA Inc. (SACDA), will cooperate in a two-to-three year effort to produce an on-line simulation program having both steady-state and dynamic modeling capabilities. The Project will take advantage of a current IPST and SACDA joint development effort to merge the IPST's MAPPS (Modular Analysis of Pulp and Paper Systems) program with SACD's MASSBAL program. Using the combined proprietary programs, realtime'' steady-state and dynamic TMP models will be developed and installed as part of a millwide'' information/analysis system. By utilizing the Performance Attribute (PAT) Modeling concept developed at IPST, the models will have the capability of optimizing energy usage and other process operating variables as a function of pulp quality. The primary goal of the Project is to demonstrate that on-line simulation models can provide assistance to operators and managers …

None

None

BS> A method for the measurement of thermal conductivities of electrically conducting materials at temperatures in excess of 1000 deg C with a high accuracy was devised. The spatial boron concentration gradient in boron- doped graphite to achieve maximum p-type thermoelectric output was established. The production of an n-type silicon carbide-graphite composit was studied. Theoretical studies produced a detailed picture of the effect of doping on the electronic properties of graphite. A method was developed for the preparation of rare earth nitrides in a good state of purity. Electrical studies of the materials produced showed that several of the compounds are semiconductors as had been predicted. (M.C.G.)

Activities in a project aimed at the improvement of fuel elements for high flux test reactors are reported. The investigation of new fuel compositions, distributions, and geometries is being undertaken to increase fuel life, to improve the flux distribution, and to provide a means of safely reaching higher reactor operating power and power density in these reactors. The effects of nuclear irradiation on the fuel and structural materials is being studied to predict the performance of these materials in more advanced reactor designs. A summary of the past year's progress is given and the fabrication and irradiation of samples containing up to 50 wt % U--Al alloys, cermets of UO/sub 2/, U/sub 3/O/ sub 8/, UC, UN, U/sub 3/Si, and Al, clad in various Al an d Be--Al materials is described. The use of ThO/sub 2/ and Th cores, the addition of BeO to cermet cores and high density fuei cores of U--Al intermetailics produced by powder metallurgy techniques were studied during the year. High strength APM claddings involving Al/sub 2/O/sub 3/ contents from 8 to 10% were tested and indicate the need for improved quality control of the APM material. Duplex claddings involving burnable poison layers and APM clad …

A composite sample of groundwater from F- and H-Areas was collected by Waste Management Tech and delivered to the Savannah River Laboratory to use in preliminary experiments that would test three remediation technologies under consideration. The three technologies are pH adjustment and filtration, decontamination with a strong acid ion exchange resin, and decontamination with a chelating ion exchange resin.

This report is an introduction to the CDC 7600 computer and to the Livermore Timesharing System (LTSS) used by the National Magnetic Fusion Energy Computer Center (NMFECC) and the Lawrence Livermore Laboratory Computer Center (LLLCC or Octopus network) on their 7600's. This report is based on a document originally written specifically about the system as it is implemented at NMFECC but has been broadened to point out differences in implementation at LLLCC. It also contains information about LLLCC not relevant to NMFECC. This report is written for computational physicists who want to prepare large production codes to run under LTSS on the 7600's. The generalized discussion of the operating system focuses on creating and executing controllees. This document and its companion, UCID-17557, CDC 7600 LTSS Programming Stratagems, provide a basis for understanding more specialized documents about individual parts of the system.

The toxicology and metabolism of nickel compounds (NiCl/sub 2/, Ni/sub 3/S/sub 2/, NiS, Ni powder, and Ni(CO)/sub 4/) were investigated in rats. Results are summarized.

Progress during July 1979 in the development of the TAAMM warhead is reported. The one gun test was unsuccessful due to the velocity augmentor misfiring. Analytical studies were performed to determine velocity augmentor optimization. Hardware for the optimum augmentor is being fabricated. The results of a series of shaped charge tests are reported. Some delay detonators have been obtained and will be tested. (LCL)

State and federal tax treatment as an incentive to development and non-tax financial incentives such as: the federal geothermal loan guarantee program, the federal geothermal reservoir insurance, and state financial incentives are discussed. (MHR)

The research funded by this NEER grant establishes the framework for a detailed understanding of the challenges in beta dosimetry, especially in the presence of a mixed radiation field. The work also stimulated the thinking of the research group which will lead to new concepts in digital signal processing to allow collection of detection signals and real-time analysis such that simultaneous beta and gamma spectroscopy can take place. The work described herein (with detail in the many publications that came out of this research) was conducted in a manner that provided dissertation and thesis topics for three students, one of whom was completely funded by this grant. The overall benefit of the work came in the form of a dramatic shift in signal processing that is normally conducted in analog pulse shape analysis. Analog signal processing was shown not to be feasible for this type of work; digital signal processing was a must. This, in turn, led the research team to a new understanding of pulse analysis, one in which expands the state-of-the-art in simultaneous beta and gamma spectroscopy with a single detector.

Most streamline generation algorithms either provide a particular density of streamlines across the domain or explicitly detect features, such as critical points, and follow customized rules to emphasize those features. However, the former generally includes many redundant streamlines, and the latter requires Boolean decisions on which points are features (and may thus suffer from robustness problems for real-world data). We take a new approach to adaptive streamline placement for steady vector fields in 2D and 3D. We define a metric for local similarity among streamlines and use this metric to grow streamlines from a dense set of candidate seed points. The metric considers not only Euclidean distance, but also a simple statistical measure of shape and directional similarity. Without explicit feature detection, our method produces streamlines that naturally accentuate regions of geometric interest. In conjunction with this method, we also propose a quantitative error metric for evaluating a streamline representation based on how well it preserves the information from the original vector field. This error metric reconstructs a vector field from points on the streamline representation and computes a difference of the reconstruction from the original vector field.

Cyclotides are an emerging family of naturally occurring circular mini-proteins ({approx}30-40 amino acids) characterized by six conserved Cys residues (forming 3 disulfide bridges) that create a topologically unique structure designated as a cyclic cysteine knot (CCK). The cysteine knot motif, which is embedded within the macrocylic backbone, is described as two disulfide bridges that form a ring that is penetrated by the third disulfide bridge. The cyclic backbone and CCK motif together confer cyclotides with a remarkable stability and resistance to proteolytic, chemical, and thermal degradation. Further, cyclotides are functionally diverse and display a wide range of functions including uterotonic activity, trypsin inhibition, cytotoxicity, neurotensin binding, anti-HIV, antimicrobial, and insecticidal activity. Together, these characteristics make cyclotides attractive candidates for both drug design and agricultural applications, both in their native forms and as molecular scaffolds for the incorporation of novel bioactivities. [1] The ability to manipulate production of cyclotides within biological systems is critical for mutagenesis studies, production of grafted products, and the mass production of cyclotides with novel activities. My adviser's hope is to achieve this capability by employing recombinant DNA expression techniques to generate large combinatorial libraries of cyclotides. The advantage in creating a biosynthetic library (containing {approx}10{sup 6}-10{sup …

None

Today's PCs incorporate multiple CPUs and GPUs and are easily arranged in clusters for high-performance, interactive graphics. We present an approach based on hierarchical, screen-space tiles to parallelizing rendering with level of detail. Adapt tiles, render tiles, and machine tiles are associated with CPUs, GPUs, and PCs, respectively, to efficiently parallelize the workload with good resource utilization. Adaptive tile sizes provide load balancing while our level of detail system allows total and independent management of the load on CPUs and GPUs. We demonstrate our approach on parallel configurations consisting of both single PCs and a cluster of PCs.