A report describing a the results of a fluorimetric and volumetric method for the determination of fluoride. This method was developed for the determination of ionizable fluorine in gases in the range of 1-500ppm. This method was chosen because the determination depends on the generation of a color rather than the bleaching effect or on a change of color.

Report describing how the neutralized aqueous waste from the TBP Metal Recovery Process will be concentrated by evaporation to minimize the requirements for underground storage tank capacity.

The following document analyzes plutonium in urine which uses nuclear track film for evaluation of the quantity of separated plutonium.

The following documents are progress reports that follow chemical research studies in subjects such as ruthenium tetroxile distillations, extraction-scrub studies of zirconium and niobium, and oxidation of plutonium and stabilization of plutonium(VI) during extraction of IAF solutions.

The following report was made to determine the effective clarity improvement, flow rate characteristics, and operational problems encountered on passing Redox uranium feed solution through sintered, modified Type 304 stainless steel filter elements.

On a project of the magnitude and complexity of the Plutonium Recycle Test Reactor is was considered prudent engineering practice to obtain an independant design review by a competent off-site group that had not participated in any way in the development of the design. Accordingly, the Atomic Power Equipment Department of the General Electric Company was requested to make such an engineering review, and an Assistance to Hanford contract authorizing this work was approved by the Atomic Energy Commission in November, 1958.

Report from Hanford Laboratories concerning "the design and construction of the 100-N Reactor and heat dissipation plant complete with the necessary auxiliaries" (p. 2). Details of its construction and the plant's systems and instrumentation are described as well as economic considerations.

The following report provides results from laboratory tests on the corrosion resistance of various types of stellite facings on astenitic stainless steel T-347 to Redox streams.

Chain reacting conditions for plutonium nitrate in water solution have been examined experimentally for a variety of sizes of spheres and cylinders.

Describes the design criteria, design details, and final installation of a high precision temperature and intimate contact monitor.

The PRTR pressure loop is an experimental facility to be installed in the Plutonium Recycle Test Reactor, Building 309, for use in testing the feasibility of reactor cooling systems utilizing high pressure water or steam as the coolant. It will furnish operating experience with such systems and serve to test fuel elements and components designed to operate in such environments.

The following report describes a successful procedure used for the determination of americium in the presence of plutonium. Provided are articles listed that describe the research done in developing the method.

The following report describes the process to determine the method for determination of americium in the presence of plutonium and uranium.

Sinterability studies on mixtures of UO2 and PuO2 powders have been continued. All of the censities from previous sintering experiments have been recalculated utilizing a somewhat different water immersion technique. Since densities of pellete obtained by physical dimensions are inaccurate due to chipping, and water immersion does not account for the open porosity, the pellets were coated with clear krylon before being immersed in water. This effectively sealed the open pores. Plots of density versus composition still indicate a drastic reduction in UO2 sinterability with even the slightest additions of PuO2 and a rapid increase with PuO2 contents greater than 20 weight percent. The following table compares densities of pure UO2 and PuO2 after an eight hour soak time:

Two Zircaloy-clad capsules (GKH-14-19,20) containing two compacts each of high density PuO2-UO2 mixed crystal oxides were shipped to the MTR in December 2, 1958. The compacts contain 0.026 a/o PuO2, have densities of 91 percent of the theoretical value, and will generate the same specific power as an Al-1.8w/o Pu alloy rod of the same diameter would produce. Two capsules (GKH-14-21,22) have been prepared and contain three compacts each of low density, about 65 percent of the theoretical value, PuO2-UO2 mixed crystal oxides. It is tentatively planned to ship the last two capsules during January 1959.

Plutonium Oxide Fuels. Mixtures of PWR grade UO2 containing 10, 20, 30, 40, 50, and 60 w/o PuO2 were sintered in hydrogen for 44 hours at 1600 C to get additional data on solubility in this system. Densities of all the pieces were low, approximately 80 percent of theoretical; however, solid solution formation was complete in every case. The low density material should not affect lattice parameter values, but it did slightly reduce the intensity of the reflections.

PuO2-UO2 Irradiation Capsules. Four capsules of Zircaloy-clad, sintered PuO2-UO2 mixed crystal oxides in a UO2 matrix are awaiting irradiation in the NTR.

Basic Studies. It has been reported previously that mixed crystals of PuO2 and UO2 have a higher sintering rate than UO2 alone. However, results to the contrary were obtained on addition to 1/4, 1/2, 1, 2, 5, and 10 w/o PuO2 to PWR grade UO2. Pellets of the above concentrations were heated for one hour in hydrogen at 100 C intervals from 1000 to 1600C.

Plutonium Fuels Development Basic studies. Experiments to determine the effect of plutonium dioxide additions on the sinterability of UO2 have continued. PuO2 has been added to ball milled PWR grade UO2 as a physical mixture, and in the form of the mixed crystal oxide.

Basic Studies. Sinterability experiments in the system UO2-PuO2 have continued, and data are available at one hour hold times across the UO2-PuO2 composition limits. Sintered densities appear to be markedly dependent on pressed densities with densification occurring very rapidly at higher pressing pressures. The following table illustrates the effect of one hour at temperature on final density for pure plutonium dioxide pressed to both 40 and 60 percent of theoretical density.

The following report follows a test for remelting and casting uranium scrap specified that a pressure of 25 microns or less must be attained within the furnace before a charge is melted. The report was made to evaluate the effect of furnace pressures upon the quality if recast uranium metal.

Summary: "This investigation showed that a sound , weather-resistant coating can be applied to uranium that the surface to be plated is cleaned and etched properly. Using the proposed two-bath plating method at 80 C., a four-mil nickel coat can be deposited in thirteen hours."

Basic information on the design of the Knolls Atomic Power Laboratory (KAPL) -120 loop.

The Hanford Remote Pipetter has developed into a very useful tool for routine pipetting by semi-skilled non-technical personnel. Radiation exposure to the operators has decreased to normal background levels as proper shielding exists between the sample and the operator. The results achieved by the pipetter have demonstrated its flexibility and simplicity of operation.