Early results from actual laboratory operation of a more versatile magnet supply.

From introduction: This report reviews the Susie program (particularly reactor dosimetry and data analysis) as well as other items that represent a smaller share of the total effort.

Abstract: Various methods and techniques of measuring void fractions in boiling heat transfer media are discussed.

Introduction: The effects of temperature on the mechanical properties of Zircaloy-2 containing up to 7.5 wt % niobium and 3500-ppm oxygen were studied and are presented herein.

"Results of the continuing stratospheric flight test evaluation program for the Del Model I Electrostatic Precipitator Sampler and the Del Electrical Discharge Altimeter are described and discussed. Only one of four balloon launches reached floating altitude. The altimeter obtained an altitude recording consistent with concurrent aneroid barocoder readings. The reported gross gamma concentration for the precipitator sampler was approximates 25 and 80% higher than those of the two simultaneous direct flow filter samples. The completion of the design and construction of two prototype units of the Del Electrical Discharge Altimeter and their laboratory evaluation are described. A preliminary design concept is presented for an operational high volume electrostatic precipitator sampler to operate with high collection efficiency at an ambient flowrate of 500 cfm throughout the altitude range 100,000 to 150,000 ft."

A research program is being conducted to obtain experimental data in the irradiation of plutonium-enriched fuel to confirm a theoretical model for predicting isotopic composition and reactivity changes in plutonium-enriched, light-water-moderated reactors. Quarterly progress: The densitometry procedure (for measurement of alpha autoradiographs of fuel pellets) has been modified to eliminate the need for a second emulsion. The existence of a problem of latent image fading and non-reciprocity of the high-resolution emulsion has been recognized. A tentative procedure has been worked out to correct these emulsion difficulties. the number of polished pellets has been increased to thirteen. The number of hot spots per pellet has not changed appreciably. The largest spot seen is irregular with an estimated volume equivalent to that of a sphere of 35 mil diameter with a PuO2 concentration in the neighborhood of 60%. The VBWR irradiation run now under way is not scheduled to end until October. To the end of the last run the cumulative exposure reached 3703 MWD/T, as logged by VBWR operating personnel. Applying the same scale factor between logged exposure and Ce-Cs analysis of the first fuel sample gives a corrected exposure of 4416 MWD/T. Further debugging of EPITHERMOS, the epithermal extension of …

Introduction: The Transition Boiling Heat Transfer Program is sponsored jointly by the USAEC and Euroatom and is being conducted by the General Electric Company. The work commenced on this program February 11, 1963. The objective of this program is to perform basic investigation and measurement of the transition boiling regime in high pressure bulk boiling water flows, with particular emphasis i the high range of steam qualities.

Abstract: Residual and fission gas release from UO2 were studied in the laboratory and in in-reactor experiments. Arc-fused powder and sintered pellets were used to determine the rate of evolution and types of residual gases as a function of temperature. Fission gas release was related to the average UO2 temperature and fission gas release calculations were made using the latest thermal conductivity values, isotopic half lives, and branching ratios available in the literature. The results obtained were compared with those available in the literature, and a satisfactory agreement was found among the groups of comparable data.

Abstract: (1) Grain growth in UO2 pellets was studies between 100 C and 2600 C. The pellets were encapsulated in small vacuum-tight tungsten containers in an argon atmosphere. (2) The grain size-time relationship could be expressed by an equation. A low exponent, m>_ 1/3, was found in those experiments and is related to the type of UO2 investigated. An activation energy of 65 kcal/mole was obtained for the grain growth process. The time exponent, m, increased with increasing temperature if the pellets were not contained in closed capsules bu heated under an argon pressure of 1.5 atm. (3) An interaction between tungsten and UO2 could be observed at a a temperature of 2600 C after prolonged heat treatment.

Activities in a program to develop techniques in the use of pulsed neutron sources to measure shutdown parameters related to large thermal power reactors are reported. The development of pulsed neutron source techniques for large power reactors has led to a new theoretical model recently developed by E. Garelis and J.L. Russell, Jr. The theory is presently based on a bare, one-group model with m-delayed precursors and takes all spatial modes into account. Results indicate, however, that the application of this model is much broader. Experiments were designed and carried out to both verify this new theory and to demonstrate the performance of the experimental hardware in a large power reactor.

Technical report describing that as part of the AEC Fuel Cycle Program, tests are being conducted to evaluate the significance of current fuel design limitations that do not permit the maximum fuel temperature to exceed the melting point of UO2. The reliability of prediction of the fuel rod operating conditions that will cause melting of the UO2 was evaluated by means of a calibration test conducted in the Vallecitos Boiling Water Reactor. Conclusions: (a) The central portion of the 3.15-cm diameter uranium dioxide fuel column melted. It appears that the UO2 was molten to a radius of 1.22 cm in the peak power region. The maximum extent of melting probably occurred during the peak power run when the kdT in this region of the rod reached 171 watts cm. The estimated radius of melting from metallographic examination indicates the kdT for sintered UO2 is 89 watts/cm. This supports a calculated estimate for sintered UO2 thermal conductivity published by D. R. deHalas and G. R. Horn. The results of the previous calibration run and subsequent experimental data by Lyons are also consistent with the value. This conclusion is contingent on the interpretation of the post-irradiation crystal structure of the UO2. Insufficient …

From introduction: "This is the seventeenth in a series of quarterly reports which cover the progress and results from the conceptual designs, economic evaluations and research and development work performed by the General Electric Company as part of Contract AT(01-3)-189, Project Agreement No. 13."

From introduction: "Development of nuclear reactor cores having high power density, long fuel life, and low fabrication costs is the objective of this program sponsored by the AEC."

Summary: A prototype control rod containing absorber plates made from an electro- deposited dispersion of boron carbide in nickel was tested in the VBWR. It was exposed to the reactor environment of 545 degree F boiling water and thermal neutron fluxes (perturbed) which ranged from 0.6 to 1.1 x 10/sup 13/ nv for 2236 hours over a period of six months. The maximum B/sup 10/ burnup achieved during the test period was 1.8 percent. After irradiation, the rod was examined. The results of the examination are summarized below: (1) The B/sub 4/C-- Ni plate assembly did not undergo significant dimensional changes during irradiation. (2) Numerous blisters developed on both the outer and inner surfaces of three of the four plates. Blistering was more severe on the outer surface than on the inner, and was most severe in a large region located in the lower half of plate 4. Metallographic examination revealed that the blisters were located only in the 2- mil protective nickel overlay covering the B/sub 4/C-- Ni dispersion. It was concluded that they formed from the buildup of gas pressure at the Ni: Ni-- B/sub 4/C interfaces, rather than from corrosion attack. Helium from the B/sup 10/(n alpha …

A research program is being conducted to obtain experimental data in the irradiation of plutonium-enriched fuel to confirm a theoretical model for predicting isotopic composition and reactivity changes in plutonium-enriched, light-water-moderated reactors. All program efforts have been temporarily deferred except for those associated with the irradiation of the program fuel element in the VBWR. The program fuel element was exposed to a burnup of 831 MWD/T during the quarter which brings the total to 3165 MWD/T. Applying the same scale factor between logged exposure and Ce-Cs analysis of the first fuel sample gives a corrected exposure of 3774 MWD/T.

Activities in a program to develop techniques in the use of pulsed neutron sources to measure shutdown parameters related to large thermal power reactors are reported. The development of pulsed neutron source techniques for large power reactors has led to a new theoretical model recently developed by E. Garelis and J.L. Russell, Jr. The theory is presently based on a bare, one-group model with m-delayed precursors and takes all spatial modes into account. Results indicate, however, that the application of this model is much broader. Experiments were designed and carried out to both verify this new theory and to demonstrate the performance of the experimental hardware in a large power reactor.

From introduction: "This is the thirteenth in a series of quarterly reports which will cover the progress and results from the conceptual design, economic evaluations and research and development work performed by the General Electric Company as part of the Nuclear Superheat Project."

From introduction: "This is the fourteenth in a series of quarterly reports which will cover the progress and results from the conceptual design, economic evaluations and research and development work performed by the General Electric Company as part of the Nuclear Superheat Project."

Quarterly report discussing progress on the Fast Ceramic Reactor Development Program, "an integrated analytical and experimental program directed toward the development of fast reactors employing ceramic fuels, with particular attention to mixed plutonium-uranium oxide" (p. 1).

Report presenting in-pile loop experiments DD, EE, FF, GG, L-412, L-413, and L-418, which were seven of a series designed to test the radiation corrosion of zirconium, titanium, and stainless steel alloys in solutions under various conditions of radiation intensity, temperature, solution composition, and velocity of flow. Steel specimens exposed in the loop cores showed increases in corrosive attack over that expected out-of-radiation.

Report issued by the Argonne National Laboratory discussing progress made by the Reactor Development Program during March 1963. Reactor physics, experiments, and safety studies are presented. This report includes tables, and illustrations.

Report issued by the Argonne National Laboratory discussing progress made by the Reactor Development Program during April 1963. Reactor physics, experiments, and safety studies are presented. This report includes tables, and illustrations.

Report documenting the progress of the Army Gas-Cooled Reactor Systems Program to develop a mobile nuclear power plant for military field operation.

Report documenting the progress of the Army Gas-Cooled Reactor Systems Program to develop a mobile nuclear power plant for military field operation.