The authors report the first direct two-sided bound on the B{sub s}{sup 0} oscillation frequency using a large sample of B{sub s}{sup 0} semileptonic decays corresponding to approximately 1 fb{sup -1} of integrated luminosity collected by the D0 experiment in 2002-2006 during Run II of the Fermilab Tevatron Collider. The flavor (i.e., B{sub s}{sup 0} or B{sub s}{sup 0}) of the B{sub s}{sup 0} meson at the time of production was found using an opposite-side tagging technique, and the flavor at the time of decay was determined from the charge of the muon in the partially reconstructed decay B{sub s}{sup 0} {yields} {mu}{sup +} D{sub s}{sup -}X, D{sub s}{sup -} {yields} {phi}{pi}{sup -}, {phi} {yields} K{sup +}K{sup -}. A likelihood scan over the oscillation frequency, {Delta}m{sub s}, gives a most probable value of 19 ps{sup -1} and a range of 17 < {Delta}m{sub s} < 21 ps{sup -1} at the 90% C.L. At {Delta}m{sub s} = 19 ps{sup -1}, the amplitude method yields a result that deviates from the hypothesis of an oscillation amplitude of zero by 2.5 standard deviations, corresponding to a two-sided C.L. of 1%.

The authors present the measurement of R = {Beta}(t {yields} Wb)/{Beta}(t {yields} Wq) in p{bar p} collisions at {radical}s = 1.96 TeV, using 230 pb{sup -1} of data collected by the D0 experiment at the Fermilab Tevatron Collider. They fit simultaneously R and the number (N{sub t{bar t}}) of selected top quark pairs (t{bar t}), to the number of identified b-quark jets in events with one electron or one muon, three or more jets, and high transverse energy imbalance. To improve sensitivity, kinematical properties of events with no identified b-quark jets are included in the fit. They measure R = 1.03{sub -0.17}{sup +0.19}(stat+syst), in good agreement with the standard model. They set lower limits of R > 0.61 and |V{sub tb}| > 0.78 at 95% confidence level.

The authors present a measurement of the B{sub c}{sup +} meson lifetime in the semileptonic decay mode B{sub c}{sup +} {yields} J/{psi}e{sup +}{nu}{sub e} using the CDF II detector at the Fermilab Tevatron Collider. From a sample of about 360 pb{sup -1} of p{bar p} collisions at {radical}s = 1.96 TeV, they reconstruct J/{psi}e{sup +} pairs with invariant mass in the kinematically allowed range 4 < M{sub J/{psi}e} < 6 GeV/c{sup 2}. A fit to the decay-length distribution of 238 signal events yields a measured B{sub c}{sup +} meson lifetime of 0.463{sub -0.065}{sup +0.073}(stat) {+-} 0.036(syst) ps.

The authors present a measurement of the t{bar t} production cross section in p{bar p} collisions at {radical}s = 1.96 TeV which uses events with an inclusive signature of significant missing transverse energy and jets. This is the first measurement which makes no explicit lepton identification requirements, so that sensitivity to W {yields} {tau}{nu} decays is maintained. Heavy flavor jets from top quark decay are identified with a secondary vertex tagging algorithm. From 311 pb{sup -1} of data collected by the Collider Detector at Fermilab they measure a production cross section of 5.8 {+-} 1.2(stat.){sub -0.7}{sup +0.9}(syst.) pb for a top quark mass of 178 GeV/c{sup 2}, in agreement with previous determinations and standard model predictions.

The authors describe a general search for resonances decaying to a neutral e{mu} final state in p{bar p} collisions at a center-of-mass energy of 1.96 TeV. Using a data sample representing 344 pb{sup -1} of integrated luminosity recorded by the CDF II experiment, they compare Standard Model predictions with the number of observed events for invariant masses between 50 and 800 GeV/c{sup 2}. Finding no significant excess (5 events observed vs. 7.7 {+-} 0.8 expected for M{sub e{mu}} > 100 GeV/c{sup 2}), they set limits on sneutrino and Z{prime} masses as functions of lepton family number violating couplings.

The disposal of fly ash from the combustion of coal has become increasingly important. When the fly ash does not meet the required specification for the product or market intended, it is necessary to beneficiate it to achieve the desired quality. This project, conducted at PPL's Montour SES, is the first near full-scale ({approx}10 ton/day), demonstration of ash ozonation technology. Bituminous and sub bituminous ashes, including two ash samples that contained activated carbon, were treated during the project. Results from the tests were very promising. The ashes were successfully treated with ozone, yielding concrete-suitable ash quality. Preliminary process cost estimates indicate that capital and operating costs to treat unburned carbon are competitive with other commercial ash beneficiation technologies at a fraction of the cost of lost sales and/or ash disposal costs. This is the final technical report under DOE Cooperative Agreement No.: DE-FC26-03NT41730.

The conventional screening machines used in processing plants have had undesirable high noise and vibration levels. They also have had unsatisfactorily low screening efficiency, high energy consumption, high maintenance cost, low productivity, and poor worker safety. These conventional vibrating machines have been used in almost every processing plant. Most of the current material separation technology uses heavy and inefficient electric motors with an unbalanced rotating mass to generate the shaking. In addition to being excessively noisy, inefficient, and high-maintenance, these vibrating machines are often the bottleneck in the entire process. Furthermore, these motors, along with the vibrating machines and supporting structure, shake other machines and structures in the vicinity. The latter increases maintenance costs while reducing worker health and safety. The conventional vibrating fine screens at taconite processing plants have had the same problems as those listed above. This has resulted in lower screening efficiency, higher energy and maintenance cost, and lower productivity and workers safety concerns. The focus of this work is on the design of a high performance screening machine suitable for taconite processing plants. SmartScreens{trademark} technology uses miniaturized motors, based on smart materials, to generate the shaking. The underlying technologies are Energy Flow Control{trademark} and Vibration Control …

We propose a model-independent quantity, L/G, to characterize non-Gaussian tails in beam profiles observed with the Fermilab Booster Ion Profile Monitor. This quantity can be considered a measure of beam halo in the Booster. We use beam dynamics and detector simulations to demonstrate that L/G is superior to kurtosis as an experimental measurement of beam halo when realistic beam shapes, detector effects and uncertainties are taken into account. We include the rationale and method of calculation for L/G in addition to results of the experimental studies in the Booster where we show that L/G is a useful halo discriminator.

Since 1998, The Pennsylvania State University (PSU) has been successfully operating the Consortium for Premium Carbon Products from Coal (CPCPC), which is a vehicle for industry-driven research on the promotion, development, and transfer of innovative technology on premium carbon produces from coal to the U.S. industry. The CPCPC is an initiative being led by PSU, its co-charter member West Virginia University (WVU), and the U.S. Department of Energy's (DOE) National Energy Technology Laboratory (NETL), who also provides the base funding for the program, with PSU responsible for consortium management. CPCPC began in 1998 under DOE Cooperative Agreement No. DE-FC26-98FT40350. This agreement ended November 2004 but the CPCPC activity has continued under the present cooperative agreement, No. DE-FC26-03NT41874, which started October 1, 2003. The objective of the second agreement is to continue the successful operation of the CPCPC. The CPCPC has enjoyed tremendous success with its organizational structure, that includes PSU and WVU as charter members, numerous industrial affiliate members, and strategic university affiliate members together with NETL, forming a vibrant and creative team for innovative research in the area of transforming coal to carbon products. The key aspect of CPCPC is its industry-led council that selects proposals submitted by CPCPC …

Bimonthly newsletter focusing on information for and about the business community in Hutto, Texas, along with advertising.

The Alaska Department of Natural Resources (DNR), Division of Mining, Land, and Water manages cross-country travel, typically associated with hydrocarbon exploration and development, on Alaska's arctic North Slope. This project is intended to provide natural resource managers with objective, quantitative data to assist decision making regarding opening of the tundra to cross-country travel. DNR designed standardized, controlled field trials, with baseline data, to investigate the relationships present between winter exploration vehicle treatments and the independent variables of ground hardness, snow depth, and snow slab thickness, as they relate to the dependent variables of active layer depth, soil moisture, and photosynthetically active radiation (a proxy for plant disturbance). Changes in the dependent variables were used as indicators of tundra disturbance. Two main tundra community types were studied: Coastal Plain (wet graminoid/moist sedge shrub) and Foothills (tussock). DNR constructed four models to address physical soil properties: two models for each main community type, one predicting change in depth of active layer and a second predicting change in soil moisture. DNR also investigated the limited potential management utility in using soil temperature, the amount of photosynthetically active radiation (PAR) absorbed by plants, and changes in microphotography as tools for the identification of disturbance …

Monthly periodical from Oklahoma City, Oklahoma published by and for members of the Oklahoma State Firefighters Association that includes news and information along with advertising.

Modern scientific facilities are often outcomes of projects that are first-of-a-kind, that is, minimal historical data are available for project costs and schedules. However, at Fermilab, there was an opportunity to execute two similar projects consecutively. In this paper, a comparative study of the design costs for these two projects is presented using earned value methodology. This study provides some insights into how to estimate the cost of a replicated project.

This paper provides an overview of the methodology approach developed by the Generation IV International Forum Expert Group on Proliferation Resistance & Physical Protection for evaluation of Proliferation Resistance and Physical Protection robustness of Generation IV nuclear energy systems options. The methodology considers a set of alternative systems and evaluates their resistance or robustness to a collection of potential threats. For the challenges considered, the response of the system to these challenges is assessed and expressed in terms of outcomes. The challenges to the system are given by the threats posed by potential proliferant States and sub-national adversaries on the nuclear systems. The characteristics of the Generation IV systems, both technical and institutional, are used to evaluate their response to the threats and determine their resistance against the proliferation threats and robustness against sabotage and theft threats. System response encompasses three main elements: (1) System Element Identification. The nuclear energy system is decomposed into smaller elements (subsystems) at a level amenable to further analysis. (2) Target Identification and Categorization. A systematic process is used to identify and select representative targets for different categories of pathways, within each system element, that actors (proliferant States or adversaries) might choose to use or …

The reduction of mercury emission from fossil fuel applications is an increasing priority for the US power industry due to regulatory pressure. While mercury removal during combustion is well studied, mercury removal in gasification is less so. The increasing application of coal gasification in future plant designs supplies the incentive for more study of mercury removal gasification processes. In gasification where the mercury is expected to be elemental, activated carbon injection has been the most effective method of mercury removal. Absorption of elemental mercury at high temperature has not been shown to be effective. The carbon is best injected downstream where the temperature has moderated and an independent collector can be established. Experiments have been conducted at 400 F to compare mercury absorption on activated carbon as received and ''super'' activated carbon. The ''super'' activated carbon was prepared by soaking the carbon in 6M nitric acid followed by neutralization and washing. Each absorption experiment has been run for 16 hours of exposure time to the gasifier product stream. The carbon samples were tested for mercury absorption by ICP hydride generation. The two carbon samples which had been washed in nitric acid then exposed to the gasifier slipstream showed higher concentrations …

Photograph of Sirik Hearn, Kinesiology junior at UNT, taking a shot during an intramural three-point contest. Hearn can be seen on the left side of the photograph with his back to the camera. His arms are raised and he appears to be jumping. The basketball is visible above Hearn's hands in the top left portion of the image. Several other contest participants can be seen in the background.

Photograph of Sirik Hearn, Kinesiology junior at UNT, taking a shot during an intramural three-point contest. Hearn can be seen on the right side of the photograph with his back to the camera. His arms are raised and he appears to be jumping. The basketball is visible above Hearn's hands in the top right portion of the image. Several other contest participants can be seen in the background.

Photograph of a student taking a shot during an intramural three-point contest. The man can be seen on the left side of the photograph with his back turned to the camera. His arms are extended above him, and he appears to be jumping. A basketball can be seen in the top portion of the photograph, between the man and a basket on the right. Two other students are standing on the court on the right side of the photograph. They are each holding a basketball.

Photograph of a student taking a shot during an intramural three-point contest. The man can be seen on the left side of the photograph, facing to the right of the camera. His arms are extended out in front of himself and he appears to be jumping. A basketball can be seen in front of his hands. Other contest participants are on the right side of the photograph, facing the man.

The Ecological Monitoring and Compliance program (EMAC), funded through the U.S. Department of Energy, National Nuclear Security Administration Nevada Site Office (NNSA/NSO), monitors the ecosystem of the Nevada Test Site (NTS) and ensures compliance with laws and regulations pertaining to NTS biota. This report summarizes the program’s activities conducted by Bechtel Nevada (BN) during the Calendar Year 2005. Program activities included: (1) biological surveys at proposed construction sites, (2) desert tortoise compliance, (3) ecosystem mapping and data management, (4) sensitive and protected/regulated species and unique habitat monitoring, (5) habitat restoration monitoring, and (6) biological monitoring at the Non-Proliferation Test and Evaluation Complex (NPTEC).

Photograph of a memorial for Ann Whitney. It says, "In Memory of Ann Whitney. Born in Massachusetts about 1835, massacred by Comanche Indians, July 9, 1867 while protecting her pupils. Miss Whitney's grave is located 5 blocks north in the Graves-Gentry Cemetery. School was located 7 miles northeast of Hamilton on the Juan de la Garza Survey. Sponsored by Hamilton Kiwanis Club, 1858. Donated by Riley-Gardner Memorial Service Co.

Photograph of a building in Meridian. The sign above it reads "B. F. Word, Attorney at Law." There is another sign with the year 1916 on it. Above the doorway, a sign declares the current resident to be Dr. Ed Williamson, Dentist. A white van is parked on the far left side of the photo.

Photograph of the Bosque County Courthouse, undergoing a complete restoration. Constructed in 1886 by architect J. J. Cane of Fort Worth, this image represents the building's structure as it existed from 1935 to 2007. The courthouse originally had a gothic tower and small turrets which were dismantled in 1935, and subsequently rebuilt in 2007.

Photograph of the Bosque County Tax building, a two story building. The first story is built of stone, and the second of red brick.