Introduction:"A corrosion test program to determine the effect TBP process streams, which contain chlorides, have upon the corrosion resistance of several construction materials, was completed. Data are presented on the performance of Carpenter 20, T-309SCb, T-347. T-316 and tantalum in the RAF and RAW process streams and on the performance of titanium and zirconium in the RAW stream."

This report provides data on production test 105-329-P and solid graphite samples used to analyze damage obtained from controlled natural erosion tests. The data provided will help establish current ideas on the status of filler block graphite and interpretation of the data will assist in establishing pile operating temperature limits based on stored energy.

The following report describes the procedures developed for the x-ray photometric determination of uraniuim in metal oxides and sludge and compares results, precision, and length of time of analyses by the General Electric X-Ray Photometer with analyses by the present titration method.

Summary: "This investigation showed that a sound , weather-resistant coating can be applied to uranium that the surface to be plated is cleaned and etched properly. Using the proposed two-bath plating method at 80 C., a four-mil nickel coat can be deposited in thirteen hours."

From introduction: "In this report an attempt was made to summarize the results of recent research on the effective height of smoke stacks. In this summary attention is paid only to the case in which the density of the stack effluent is the same as that of the surrounding air."

From introduction: "The test was performed to gain knowledge which would be useful for evaluating and improving currently planned methods for the design and construction of high density concrete shielding."

The following report discusses laboratory investigations of the suitability of some commercially available limestone for neutralization of slightly acidic distillates.

A report which is the ninth report of the research and development activities of the radiological sciences department, Hanford Works, which includes some items charged to control but include for for general interest.

Report describing "the effects of variable graphite conductivity and of the gas layers in the lattice" under the assumptions that "graphice conductivity varies as a power of the distance from the center of each cell" and "uniform distribution of heat sources" - from abstract.

The following document analyzes plutonium in urine which uses nuclear track film for evaluation of the quantity of separated plutonium.

Report describing alternative methods for depleting a large turnings inventory in a short period of time.

From introduction: "This report gives the results of a 1000-hour corrosion test of SAE 1010, low carbon steel, in synthetic Redox waste solutions...The present test was designed to obtain corrosion rates for waste solution temperatures of 180 F, 200 F, and 220 F in solutions neutralized to pH values of 11, 12, and 13.

This report examines the failure of two 18-8 grade stainless steel gate valves used in sulfamic acid and determines the cause of the failures through a series of tests.

Five continuous coatings were produced on zirconium coupons using an anodizing technique. These layers appear to be quite adherent and not subject to visible or audible failure caused by flaxion of the basis metal, Their abrasion resistance, though not investigated thoroughly, appears to be moderately good.

The results of this investigation indicate that maximum electric power generation can be obtained by selecting the turbine steam temperature within a range of plus/minus 30 degrees C. from an "idealized" steam temperature. This "idealized" steam temperature is shown to depend primarily on the maximum permissible uranium temperature. The minimum available condenser temperature and the temperature rise of the coolant in the pile effect the selection of the turbine steam temperature to lesser extent.

In connection with different seals for C & D equipment it appears advantageous that many parts could be made of rubber or other elastic polymers. However, data on the deterioration rate of these materials under irradiation are somewhat scant in the available literature. It appears that for neutrons and pure gamma radiation that a good grade of natural rubber stands up best in all the test reported and because the results of the neutron irradiation are so closely correlated with results from gamma it has been proposed that the principal source of damage is caused by secondary irradiation generated within the rubber by the neutrons.

The conventional volumetric micro-determination of phosphate depends upon the precipitation of phosphomolybdate, filtration and washing of the precipitate, and titration with standard base. The method is slow and tedious, subject to many interferences, and is not applicable to samples containing less than 1-2 mg of phosphate. Other weak acid anions, such as carbonate or acetate, interfere in the method. Strong acid anions, such as nitrate, sulfate, and chloride do not interfere.

Observations on sheep representing flocks in Utah adjacent to the Nevada Proving Ground were compared with findings made on experimental sheep exposed to various amounts of radioiodine. The Utah sheep showed no evidence of the radiation damage observed in experimentally treated sheep. Estimations of amounts of radioiodine on vegetation required to cause serious thyroid damage following a contamination event are included.

The hydrogen contents of several types of fabricated uranium have been determined by a vacuum method and expressed in terms of ccH2/ccU. The data indicate that alpha-rolled metal contains about 0.25 ccH2(STP)/ccU whereas beta heat-treated uranium yielded values between 0.30 and 0.37 cc per cc. Restricted efforts were made to determine where in the heat treatment the 5 to 10 cc of hydrogen per slug were taken up. It appears that no one operation is wholly responsible for this additional gas, although reactions between beta heat treated surfaces containing microscopic defects, and nitric acid may possibly play a large role. In general it may be said that slug produced by powder metallurgical techniques contain less hydrogen than pieces produced by rolling and heat treatment.

Detection of earthquakes by water-level recorders on water wells at Hanford Plant.

From objectives: "The objectives of this investigation were to evaluate the hydraulic forces in the pulse column, and determine their effects on pulse column design."

An electromagnetic eddy current instrument is described that is capable of measuring copper and nickel plating 1 to 8 mils thick plated on bismuth mandrils of various sizes and shapes.

The first series tests in the KER-REP-1 loop proved that a fisssion product contaminated loop could be decontaminated to a safe level for contact maintenance. The second series of tests ere scheduled for a more thorough evaluation of these processes includes specific decontamination factors, process corrosion rates, loop activity reduction factors (loop decontamination factors), and any preferential decontamination which may be present.

When following the performance of automatic and semi-automatic equipment that is left unattended for extended periods of time, it is often desirable to be able to check this equipment by remote means. A convenient vehicle for such a check is the telephone since nearly all locations have or can have a telephone extension installed. The check of the equipment may be made as simple or extensive as desired, with the outcome of the check represented by a relay condition, for example. The condition of the relay is then transmitted to the interrogator over the telephone line by means of the presence or absence of a tone.