The following report describes the electron spectrum of protactinium derived from 23 minute thorium 233 that was produced by neutron capture in stable thorium.

"A program of creep-rupture tests of several bars of Beryllium has been completed. The tests were made at 1200, 1400, 1550, and 1700 F. in protective atmospheres of tank helium or hydrogen. The results are given in a summary table and by creep and design curves. A description of the test set-up is included."

From introduction: "It has become desirable to develop an alternative method for the determination of lithium to serve as a stand-by method at times when the flame photometer is inoperative, or to supplement the latter in cases where a doubtful analysis requires further investigation. A method based upon the precipitation of lithium with potassium ferriperiodate was investigated because of its expected freedom from interference by aluminum."

This report has two parts to it discussing mineralogical examination of pitchblende concentrates and nitric acid digest residues. Part I gives the results of a cursory examination with the petrographic microscope of samples of pitchblende concentrates and residues to see if there is a relationship between the mineral composition of the samples and the filterability of the residue. Part II gives a revaluation of the data in Report BMI-241 on the mineral composition of two residues from the nitric acid digestion of pitchblende concentrates at the Rallinckrodt Chemical Works.

Introduction: A limited test progress on Alloghany-Ludlum type 347 stainless steel plate which failed the Huey test (ASTN A-262-44T) has been completed.

Calculations indicative of the power loss for 75 in.radius gap splitters are given.

This report discusses the development of a method for creating leak-proof closures in aluminum sample casings in order to pass a standard bubble-test inspection.

Technical report outlining the fabrication of twenty-five fuel assemblies and three shim-safety rod fuel sections for use in the Materials Resting Reactor Mock-Up Critical Experiments. Results show that two of the assemblies exceeded tolerance in a few of the key dimensions, but were considered acceptable and as a consequence, production was carried out with no rejects. [From Abstract]

Technical report outlining the investigation of corrosion on MTR type fuel elements for the Shielding Reactor in filtered water. Report includes two basic types of protection: element pretreatment by either anodizing or alodizing, and solution control using nitric acid to maintain a pH of 5.5 to 6.5 or the addition of 60 ppm sodium chromate as an inhibitor. [From Abstract]

The first part of this quarterly progress report details reactor theory and design, discussing the aircraft reactor experiment, experimental reactor engineering, reactor physics, and critical experiments. The second part of this report is not included. The third part of this quarterly progress report details materials research, discussing corrosion research, physical properties and heat-transfer research, metallurgy and ceramics, chemistry of high-temperature liquids, and radiation damage. The fourth part of this quarterly progress report details alternate systems, discussing a supercritical water reactor, circulating-moderator-coolant reactors. The fifth part of this quarterly progress report includes appendixes.

Technical report focusing on the Homogeneous Reactor Experiment (HRE) construction, completed 60% as of August 15, 1951. Report also includes alternate systems studies and long range studies of the Homogeneous Reactor Experiment. Technical report is organized in three parts. [From Summary]

This report discusses what effects the shift of an orbital axis relative to the center of the table-top stellarator tube as well as the magnitude of these effects.

Uranium ore from Radium Hill, South Australia was leached with hot sulfuric acid solutions and the uranium recovered from solution by uranous phosphate precipitation or by use of anion exchange resins.

The geometry of the magnetic pole structure in the cloverleaf cyclotron suggests the use of three dees excited by three phase rf placed in the valleys out of the way of the beam. Experience with the model machines indicates that it is desirable to be able to vary the phase angles between the three dee voltages through 30 or 40 degrees and to be able to maintain them at any given value within plus or minus one degree. It is desirable, also, to be able to vary the phase angle independently of the amplitude of the dee voltages. There are several possible ways of meeting these requirements. The one which was chosen appears to be the most flexible and to best meet the problems presented by the center geometry of the machine.

This technical report presents necessary information required to operate the raw materials feed preparation plant. The information herein is intended to serve as a guide to operating personnel and to provide general data concerning the process.

In recent months, experiments investigating the total, non-elastic, transport, etc., cross-sections of U-238 have been performed. It is the purpose of this memo to examine these data and to obtain from them information which will be of use in refinements pile calculations. In cases, e.g. transport cross-sections, where experimental data do not suffice, the theory developed pertaining to the continuum model of the nucleus has been depended upon. One of the fundamental requirements of this model is that the spacings of the energy levels in the compound nucleus are small compared to their widths and that consequently many levels are excited by the incoming particles. As a result there are many more modes of decay and the continuum model is an average over these levels.

Technical report covering the technology of hot-pressed beryllium production and its rapid advancement toward the end of 1949. Part I is devoted to corrosion studies made on hot-pressed and vacuum cast extruded metal which was considered representative of production. Part II is concerned with the results of tests made on special cast and hot-pressed beryllium which contained added impurities. [From Introduction]

Abstract: "The protection of thorium in hot water was studied. Copper electrocladding on thorium offers promising protection against hot water. The corrosion of thorium in 95 C water was reduced appreciably by a thorium phosphate film. The results of this abbreviated investigation offer a basis for the development of a method of protecting thorium at elevated temperatures in corrosive media."

For some time, the need has been recognized for an X-ray diffraction unit applicable to studies concerning the crystallographic characteristics of pile irradiated materials. Except for studies involving specimens of low activity, it has been impossible in the past to investigate materials which emit intense beta and gamma radiations. The exact type and degree of irradiation damage to high activity materials has been largely a matter of theoretical conjecture. The object of this report is to describe an X-ray diffraction spectrometer that can be used to collect crystallographic data from irradiated materials.

One of the oldest properties of electrons is their emission of x-rays (discrete and continuous spectra) when impinging on matter. Cloud-chamber tracks show light ionization, and considerable multiple scattering, except for fast electrons. Tracks are long and range indefinite.

"Using the Brookhaven fast chopper, transmission curves were obtained for the 6.70 +/- .06 ev resonance in U238 using four different thicknesses of natural uranium metal." The measurements for the transmission curves are summarized in the table provided.

The following report is a general monthly progress report conducted by the radiation laboratory of the University of California discussing experimental physics, theoretical physics, the MTA target physics program, accelerator construction and operation, biology and medicine, and a plant and equipment report. The period being covered is January 15, 1954 to February 15, 1954.

The absorption bands induced in α-Al2O3 by gamma and reactor irradiation have been studied. The slight coloration due to γ-rays saturates. Bands specific to reactor irradiation have been found and their growth studied.

From Introduction: "The self-shielding characteristics of a number of absorbers and of U-235 and U-238 have been investigated in PPA-20 (66°). Most of the measurements have been made in Ring 3 at the core mid-plane. The foil doubling technique was employed. Particular attention was given to 'thin' foil regions for the purpose of extrapolating the data to zero thickness."