Report discussing an investigation to determine the effects of changes in aspect ratio and tail height on the longitudinal stability characteristics of a model with a 32.6-degree sweptback wing. The effects of a leading-edge discontinuity were also examined.

The variation of dielectric constant has been measured as a function of the concentration of magnesium particles; the shape, size, and degree of oxidation of the particles; the temperature; and the frequency of oscillation. The variation of dielectric constant and settling rate was investigated as a function of time. Also investigated were the effects of particle concentration, shape and time on dielectric losses.

Report presenting tests to determine the flight characteristics of an F-86A airplane equipped with an area-suction boundary-layer-control system on the flaps and to investigate the possible operational problems which may arise on a flight installation of boundary-layer control. Results regarding the airplane with slatted leading edge, suction requirements, airplane with suction flap and various leading-edge configurations, factors affecting flap lift increment, and operational characteristics of boundary-layer control are provided.

Report presenting flight measurements on a swept-wing jet aircraft to determine the effects of adding forward camber and an increased leading-edge radius on the low-speed stalling characteristics, the high-speed static longitudinal stability, and the airplane drag. The modified leading edge produced values of maximum lift somewhat greater than the slats on a normal airplane, but the stall was unacceptable because of an abrupt roll-off.

Report presenting information regarding transient oscillations observed in response to elevator pulses of the Douglas D-558-I airplane at a range of Mach numbers and altitudes. An application of the Fourier transform was used to obtain the frequency-response characteristics. The effects of lift coefficient on the frequency response are also included.

Report discussing testing of a Douglas D-558-II to investigate its longitudinal stability characteristics in accelerated flight at supersonic speeds. Information about the normal-force coefficients and their relation to stability and pitch-up of the aircraft is included.

"Results are presented of a free-flight investigation between Mach numbers of 0.7 to 1.3 and Reynolds numbers of 3.1 x 10(exp 6) to 7.0 x 10(exp 6) to determine the longitudinal aerodynamic characteristics of the Northrop MX-775A missile. This missile has a wing, body, and vertical tail, but has no horizontal tail. The basic wing plan form has an aspect ratio of 5.5, 45 deg of sweepback of the 0.406 streamwise chord line, and a taper ratio of 0.4" (p. 1).

Memorandum presenting results of a free-flight investigation over a range of Mach and Reynolds numbers to determine the longitudinal aerodynamic characteristics of the Northrop MX-775A missile. The missile has a wing, body, and vertical tail, but has no horizontal tail. Results regarding basic data, drag, trim, lift and static stability, damping, and static pressure are provided.

Report presenting an investigation of an axial-flow compressor rotor with a 13-percent reduction in exit annulus in Freon-12 gas at a range of tip speeds. In order to analyze the results caused by the reduction, the performance of the rotor was compared to that of the same rotor with a constant annular area. Results regarding the overall performance, radial variation of performance, and blade-element performance are also provided.

Report presenting data obtained from an investigation of the Douglas-D558-II airplane to determine its buffeting characteristics at high lift and supersonic speeds. From Summary: "Buffeting was encountered at normal-force coefficients greater than about 0.7 in the Mach number range from 0.96 to 1.27 but at Mach number of 1.57, a peak normal-force coefficient of 0.80 was attained with no indication of buffeting. The increase in buffet intensity with lift is very gradual at supersonic speed compared with the buffet intensity-lift variation at subsonic Mach numbers."

Report presenting an experimental investigation of external airfoils, known as paddle-control surfaces, as the longitudinal control device on a triangular wing of aspect ratio 2. The lift, drag, pitching moment, and hinge moment were obtained for a variety of Mach numbers.

Report presenting an investigation to determine the stability and control characteristics of a vertically rising airplane model. Results of preliminary hovering flight tests are made in still air, away from the interference effects of the ground and side walls, and with normal airplane-type controls operating in the slipstream.

Memorandum presenting an experimental investigation of four rectangular-throat two-dimensional wedge exhaust nozzles. Three of the nozzles were designed to conform to Prandtl-Meyer streamlines for pressure ratios of 5, 10, and 24, and a fourth, arbitrarily contoured, with a length less than that required for isentropic expansion, was designed for a pressure ratio of about 9.

Report presenting an investigation to determine the effect of several chord-extension configurations at low speed on a variable-sweep airplane model with a partially cambered wing. Testing occurred at a designated Reynolds number based on the mean aerodynamic chord of the wing at 50 degrees sweep for average test conditions. Results regarding the effect of chord extensions at 50 degrees, 60 degrees, and 20 degrees sweep, effect of chord extensions on lateral stability, and a comparison with different wing modifications are provided.

Memorandum presenting the results of flight testing of four different ski-equipped airplanes. Two types of skis were tested: hydro-skis designed to operate under or on the water surface and general-purpose skis designed to operate on a variety of surfaces but not underwater. A breakdown of the ski performance for each plane and ski combination is provided.

Report presenting an investigation of the effects of rocket-armament-exhaust-gas ingestion on the performance of a supersonic-inlet J34-turbojet-engine installation at Mach 2. Rockets were fired from two different spike positions and with the engine at high or low speed. Results regarding engine air flow, temperature, and flame-out are provided.

Report presenting an experimental investigation of a series of fixed-geometry exhaust nozzles which simulated a variable exit, which was conducted in the 8- by 6-foot supersonic wind tunnel at Mach numbers 0, 0.6, 1.5, 1.7, and 2.0. Gross thrust performance of the long-shroud exit configurations was considerably better than the short-shroud. Results regarding flow coefficients, thrust characteristics, flight performance analysis of data, and shroud drag are provided.

Report presenting an investigation of the flight characteristics of the Bell X-5 research airplane with sweepback that can be varied from 20 degrees to 59 degrees in flight. Lift and drag data have been obtained for the 59 degree sweep configuration for a range of Mach numbers and from zero to almost maximum lift.

Report presenting an investigation of the aerodynamic characteristics of a swept-wing supersonic bomber configuration conducted in the 8-foot transonic tunnel. The wing had an aspect ratio of 3.5, taper ratio of 0.2, 47 degrees of sweepback of the 0.25-chord line, and airfoil sections which were 5.5 percent thick parallel to the plane of symmetry. Results regarding the longitudinal force characteristics, effects of wing incidence, a modified wing, various auxiliary wing devices, and horizontal-tail height are provided.

"An investigation of the endurance characteristics, at high Mach number, of the J65-W-7 engine was made in an altitude chamber at the Lewis laboratory. The investigation was made to determine whether this engine can be operated at flight conditions of Mach 2 at 35,000-feet altitude (inlet temperature, 250 F) as a limited-service-life engine. Failure of the seventh-stage aluminum compressor blades occurred in both engines tested and was attributed to insufficient strength of the blade fastenings at the elevated temperatures" (p. 1).

Report presenting a scale model of the Convair XF2Y-1 airplane with a solid-fuel rocket motor designed to simulate full-scale turbojet engine characteristics with full afterburning at a Mach number 1.2 and an altitude of 35,000 feet in free flight at a maximum Mach number of 1.45. Results regarding stability characteristics, trim characteristics, and the effect of rocket exhaust over the beaches are provided.

Report presenting two-group criticality calculations for sodium-hydroxide-cooled, moderated, and reflected reactors for various concentrations and compositions of reactor fuel-element structural material. The investigation was performed in order to determine the applicability of the fuel properties to power a nuclear aircraft. Results regarding the specific reactor calculations, reflector savings, criticality generalization, typical neutron flux and heat-generation distributions, static stability characteristics and excess uranium requirements, reactor heat-transfer characteristics, and airplane and turbojet cycle characteristics are provided.

Report presenting results of two-group criticality calculations for sodium-hydroxide-cooled, moderated, and reflected reactors for various concentrations and compositions of reactor fuel-element structural material. Based on turbojet-engine cycle operating conditions optimized for minimum airplane gross weight, the maximum reactor fuel-element and coolant temperatures are related to the reactor heat release and airplane gross weight for a range of reactor heat-transfer variables.

"An investigation of the low-speed, power-off stability and control characteristics of a 1/10-scale model simulating the Convair F-102A airplane has been made in the Langley free-flight tunnel. The model in its basic configuration and with two modifications involving leading- edge slats and an increase in vertical-tail size was flown through a lift-coefficient range from 0.7 to the stall. Only relatively low-altitude conditions were simulated" (p. 1).