Report presenting a wind-tunnel investigation of a model equipped with a 60 degree delta wing and a 60 degree delta horizontal all-movable canard control surface to determine the stability, control, and canard-surface hinge-moment characteristics at low speeds and at a Reynolds number of 9 x 10(exp 6). Two longitudinal positions of the canard surface were tested. Results regarding lift and pitching moment, drag, and hinge moment are provided.

Report presenting a rotating total-pressure survey rake to obtain wake measurements of a compressor rotor. Results indicated that there was a considerable radial flow of the inboard-blade boundary layer and little radial flow of the inner casing boundary layer. Results regarding the variation in total-pressure-loss distribution with Mach number, variation in total-pressure-loss distribution with angle of attack, contour plots, spanwise variation in total-pressure-loss coefficient, variation of low-speed momentum loss coefficient withe angle of attack, and variation of momentum-loss coefficient with Mach number are provided.

Report presenting a brief experimental investigation of a method for designing fuselage side air inlets with high internal total-pressure recovery and zero spillage drag at a specified design inlet mass-flow ratio. With a scoop designed according to the concept, near-zero spillage drag can be attained at the design inlet mass-flow ratio through a range of Mach numbers. Results regarding pressure recovery and drag due to the scoop are provided.

Report presenting the longitudinal and lateral stability characteristics of a 40 degree swept-wing fighter model with and without horizontal tails of 0 degrees and 22.5 degrees negative dihedral for a range of Mach numbers, angles of attack, and sideslip.

For constant-mechanical-speed operation, the two-spool thrust values are as great as or greater than the one-spool thrust values over the entire flight range considered, while the specific fuel consumption for the two engines agrees within 1 percent. The maximum difference in thrust occurs at Mach 2.8 in the stratosphere, where the two-spool thrust advantage is about 9 percent for operation with the after burning.

Report presenting the stall characteristics of the J71-A2(X-29) turbojet engine as determined in an altitude test chamber. When the normal high-speed configuration of bleeds closed, inlet guide vanes open was operated in the low-speed range, the stall-limit line intersected the operating line at 4067 and 4630 rpm. Results regarding compressor performance at steady state and stall and fuel flow at steady state and stall are provided.

Report presenting three types of aerodynamic interference originating from forward components of airplanes, which are shown to contribute to decreased vertical-tail effectiveness.

Report presenting an investigation in the 9-inch supersonic tunnel to determine the jet effects for varying jet Mach number and nozzle divergence angle upon the pressure on the base annulus of a model with a cylindrical afterbody. Testing occurred over a wide range of jet static pressure ratios and Mach numbers. Results regarding sonic jets and supersonic jets are provided.

Report presenting steady straight-and-level and steady turning tracking runs against an aerial target using an F-51H airplane equipped with a fixed optical sight and with various combinations of maneuvering stick-force and stick-deflection gradients. Results regarding aim wander, elevator movement, and stick-force variation for various test conditions are provided.

Memorandum presenting an investigation to determine the effects of jet exhaust and Reynolds number on the flow over the vertical stabilizer and rudder of the Douglas D-558-II research airplane with special attention to an understanding of the rudder reversals experienced in flight on the full-scale airplane. Tests were made at Mach numbers of 1.62, 1.93, and 2.41 over a range of ratios of jet static pressure to stream static pressure from the jet-off ratio to about 40 and for a maximum range of sideslip angles of 6 degrees. Results regarding the effect of varying jet static-pressure ratio, effect of varying sideslip angle, effect of varying Reynolds number, and effect of varying angle of attack.

Report presenting an investigation conducted in the 8- by 6-foot supersonic wind tunnel to determine the thrust and pumping characteristics of a series of ejector exhaust nozzles. Data were obtained for various ejector diameter and spacing ratios at a range of Mach numbers, pressure-ratio ranges, and secondary-primary weight-flow ratios. Results regarding the primary-nozzle mass-flow coefficients, performance comparison of configurations, effect of free-stream Mach number on the ejectors, net thrust characteristics, and comparison to conventional nozzles are provided.

Report presenting an investigation in the supersonic wind tunnel to determine the thrust and pumping characteristics of a series of ejector exhaust nozzles. Results indicated that the free-stream Mach number had no effect on those characteristics of the ejectors in the range for which the secondary flow was choked.

Report presenting testing of specimens of various metals in selected geometric configurations exposed to liquid fluorine under controlled conditions of flow and pressure. None of the samples eroded, decomposed, or exhibited any measurable physical or chemical changes.

Memorandum presenting an investigation of three models of a delta-wing airplane designed for a long-range subsonic cruise and a supersonic dash. Results regarding the aerodynamic characteristics of the models and effect of elevon deflection on aerodynamic characteristics of the four-engine model are provided.

Memorandum presenting three types of aerodynamic interference originating from forward components of airplanes, which are shown to contribute to decreased vertical-tail effectiveness. The vorticity originating from a slender fuselage ahead of the wing resulted in a marked reduction in vertical-tail effectiveness with angle of attack for one model.

Memorandum presenting a study of aerodynamic performance and static stability and control at hypersonic speeds. In the first part of the study, the effect of interference lift is investigated by tests of asymmetric models with conical fuselages and arrow plan-form wings. In the second part, the aerodynamic performance and static stability and control characteristics of a hypersonic glider are investigated in somewhat greater detail.

Report presenting an investigation of the use of aerodynamic and mechanical devices for improving the response of guided missiles. An analysis indicates that the use of free-floating flaps and spring-mounted control surfaces should be able to increase maneuverability to the point that electronic automatic stabilization and gain-adjusting devices can be eliminated.

Report presenting an investigation to determine the aerodynamic characteristics of a sting-mounted Douglas Aircraft Company store in the presence of an unswept semispan cantilevered wing of aspect ratio 4.0. Results regarding wing loads and store loads are provided.

"Results of a static stability controls investigation carried out with a very low-aspect-ratio delta-winged missile are presented. Control effectiveness comparisons are made for tail, canard, and nose control configurations with respect to angle of attack, angle of bank, and Mach number. Trim capabilities of the various configurations are also presented" (p. 1).

Report presenting an investigation into the effects of interference at supersonic speeds on the aerodynamic properties of wing-body combinations to determine the pitching moments. The correlation points of various wing-body shapes are provided and suggestions for modifications are made.

Memorandum presenting an investigation made with an electrical heat-flow analog to determine the effect of internal modifications to a wing leading edge on the surface-temperature rise and temperature distribution for conditions of transient aerodynamic heating at high supersonic speeds. Results regarding the leading-edge temperature rise, influence of conduction on leading-edge temperature for skins of uniform thickness, and surface-temperature distribution are provided.

Memorandum presenting an investigation in the blowdown tunnel of the pressure tunnel to determine the aerodynamic characteristics of a sting-mounted Douglas Aircraft Company store in the presence of, but not attached to, an unswept semispan cantilevered wing of aspect ratio 4.0. The influence of the store on the aerodynamic characteristics of the wing was also obtained.

Memorandum presenting two turbine stator configurations designed to investigate the effect on turbine performance of either reducing or eliminating stator-blade wakes, secondary-flow loss accumulations, and circumferential variations in total pressure at the stator exits. Results regarding stator surveys, overall performance with the semivaneless stator, overall performance with the standard stator with spacer, rotor-exit surveys, and rotor-blade momentum loss are provided.

From Introduction: "The results are presented for flight Mach numbers of 0.9 to 1.5 at an altitude of 50,000 feet. The effect of flight altitude on optimum engine design-point airplane performance is also shown."