Report presenting an investigation in the stability tunnel at low speed to determine the rolling characteristics at combined angles of attack and sideslip for a model of a fighter-type airplane with a 45 degree sweptback wing. Testing was performed with the original vertical tail and a vertical tail with a 27 percent larger exposed area. Results regarding the static longitudinal stability, directional stability, and effect of the different tails are presented.

Report presenting an investigation to determine the overall performance of the modified eight-stage axial-flow compressor with new fourth-stage stator blades as part of a study of the problems encountered in a high-pressure-ratio axial-flow compressor with transonic inlet stages. The performance of the compressor was determined over a range of weight flows at equivalent speeds from 30 to 100 percent of design speed.

Memorandum presenting an investigation to determine the static longitudinal stability contribution of a horizontal tail at two vertical locations behind a 4-percent-thick unswept-wing-fuselage combination at transonic speeds. The model used in tests is comprised of an unswept wing located in the midwing position on a body of revolution and a sweptback horizontal tail mounted on a vertical tail.

Report presenting a study to show the effect of fuel-air ratio and initial temperature on spark-ignition energy and to apply the results to a previously developed theory of ignition. Results regarding initial-temperature effect and fuel-air-ratio effect are provided.

Memorandum presenting an investigation to determine the nature of the pressure distribution and the order of magnitude of the pressures on a streamline body moving on a water surface. The body of revolution was equipped with chine strips and had a fineness ratio of 9. The results from the investigation indicate that there is a characteristic pattern of hydrodynamic pressure distribution for streamline bodies equipped with chine strips and moving on a water surface.

Report presenting testing of about 150 rounds of 2.25-inch subcaliber aircraft rockets equipped with standard cruiform fins and twisted monoplane fins. No significant difference in dispersion was observed for the different configurations of fins on the rockets. Results regarding the stability of the different types of rockets, and general characteristics of the flight paths are provided.

Report discussing the results of an investigation to determine the low-speed power-off stability and control characteristics of a model of the Bell D-188A VTOL airplane. The static stability and control characteristics were generally satisfactory except above certain angles of attack and aileron effectiveness dropped off as the angle of attack was increased. Modifications for increasing the directional stability by altering the vertical tails are also described.

"A transonic turbine with a stator trailing-edge thickness reduced from 0.030 to 0.010 inch has been investigated experimentally. The performance results indicated an increase in efficiency of 0.6 of a point at design operation, and as much as 2.4 points at off-design conditions, as a result of reducing the trailing-edge thickness. This improvement could only be partially accounted for by the theoretical change in mixing loss for the two stator-blade rows, and it was felt that the improvement was largely due to a reduced amount of low-velocity fluids entering the rotor and the interference effect of these fluids with the mainstream flow" (p. 1).

"An investigation was conducted to determine the electric power requirements necessary for ice protection of inlet guide vanes by continuous heating and by cyclical de-icing. Data are presented to show the effect of ambient-air temperature, liquid-water content, air velocity, heat-on period, and cycle times on the power requirements for these two methods of ice protection. The results showed that for a hypothetical engine using 28 inlet guide vanes under similar icing conditions, cyclical de-icing can provide a total power saving as high as 79 percent over that required for continuous heating" (p. 1).

Report presenting an investigation in the transonic pressure tunnel to determine the afterbody pressure distribution and fin loading characteristics of two configurations of the TX-21 special weapon. The only different in the two configurations was the nose contour, with one having a hemispherical-flat shape and one with a double-radius ogive-flat shape. Results regarding the pressure port, fin loads, and force measurements are provided.

Report discussing various inlet design philosophies based on the results of testing at Mach numbers up to 5. The most ideal inlet design was found to be one with combined external-plus-internal compression due to problems noted with both external-only and internal-only inlets.

Report discussing an evaluation of a series of half-conical side inlets mounted on the fuselage of a supersonic aircraft at various Mach numbers. Information about the maximum total-pressure recovery, asymmetrical operation of the twin-duct system, potential reduction in stable mass-flow range, boundary-layer diverter height, and engine mass flow is described.

Effect of variation of combustion chamber length and inlet temperature on low pressure-loss sea level afterburner. A 70-percentage-point reduction in combustion efficiency resulted when the combustion-chamber length was reduced from 62 to 10 inches.

Report presenting an investigation of the aerodynamic characteristics of a model of the Grumman F9F-9 airplane in the transonic tunnel. Results regarding the transonic drag-rise increment, drag analysis, and effective downwash angle are provided.

Report discussing the influence of forces and moments on a fighter-bomber airplane with an open bomb bay and on two bluff bomb shapes in various positions below the fuselage and plane of symmetry. The wing was found to have a noticeable effect on bomb forces and that bluff bombs affect the longitudinal characteristics of the wing-fuselage combination.

Memorandum presenting an assessment of the importance of the addition lag of the monowing versus a cruciform shape on a missile.

Report presenting testing regarding the Bell X-2 supersonic research airplane, which is equipped with a skid main landing gear and nose wheel, to determine the low-speed handling qualities and landing characteristics. Results regarding the landing approach pattern, time histories, and final resting position of the airplane at landing are provided.

Report presenting measurements of elevator-stabilizer effectiveness and trim of the X-1 airplane at 40,000 feet altitude at a range of Mach numbers and normal-force coefficients.

Report presenting a rocket-powered model of the X-3 configuration flown through a range of Mach numbers to determine the response of the model to rapid deflections of the horizontal tail and its effects on lift, drag, longitudinal stability and control, and longitudinal-trim change. The model was found to remain statically and dynamically stable through the lift-coefficient and Mach number range of the test.

Report presenting an investigation of the overall performance of the J35-A-23 compressor, which is a 16-stage compressor designed to produce a total-pressure ratio of 8.75 at an equivalent flow of 155 pounds per second and an equivalent speed of 6100 rpm. Tests were run at a range of flows and speeds. Notes on installation and characteristics of the compressor are also provided.

From Introduction: "In the present paper, which supplements reference 1, V-g records obtained from F8F-2 airplanes in 1949 are analyzed statistically to determine the frequency of experiencing large values of normal load factor and airspeed. These results are compared with the results from the F8F-1 airplane."

Report presenting results of a flight investigation using a jet-powered bomber airplane to determine the vertical tail loads. Strain-gage measurements were made of the fin and rudder loads in abrupt rudder kicks and in gradual sideslip maneuvers.

Report presenting an investigation in the transonic blowdown tunnel from Mach numbers 0.80 to 1.41 to determine the increments in lift and drag due to installation of a triangular-shaped air inlet in the root of a 45 degree sweptback wing and to determine the internal flow characteristics of the inlet. Results regarding pressure measurements of the inlet model, force measurements of basic and inlet models, and effect of boundary-layer bypass scoop and fuselage nose configuration on characteristics of inlet model are presented.

Report presenting an investigation to determine the dynamic stability and control characteristics of a scale flying model of the Consolidated-Vultee XFY-1 vertically rising airplane. It includes the results of flight tests to determine the stability and control characteristics of the model in hovering, take-offs, and landings.