Introduction: "The need for a method of acid determination which could be used for small samples and easily adapted to remote control led to the investigation of the use of electrolytically generated base for the titration of acid in certain solutions. The use of electrolytically generated base for the titration of acetic acid in the presence of nitric acid has been reported (1)."

From introduction: "The following report presents a body of information obtained in the Health Instrument Development Laboratory from September, 1948, to the present, and is intended to be a preliminary review of [the study of electrodeposition of plutonium]. Many improvements in technique and methods and investigations along lines not explored are suggested by the present work. These will be undertaken as time permits, and reported at a later time."

This report covers an investigation made to develop a gasometric determination that can determine 1.2 x 10-(-5) g. of nitrite with a precision (99% limits) of +/- 8%, and discusses how this procedure works.

The following report provides data from completed tests for corrosion testing of stellite-T347 stainless steel test cylinders.

This report analyzes infrared absorption measurements that were made in the regions of carbonyl band and hydroxyl band absorptions on solutions of water in hexone and water in acetone, confirming intermolecular association of water and hexone.

The following report describes methods used to determine tributylphosphate in a deodorized shell base. An infrared absorption method is developed to emphasize toward determination of TBP in RCW streams, the organic waste streams.

A report which discusses the data submitted for evaluation. This data is about optical densities from infrared spectrometer readings on eight standard samples, ranging in percent TBP from 6.71 to 17.85.

This report follows the study of the oxidation of plutonium III and IV to the plutonyl state.

This report discusses methods for preparing thin films of plutonium on metallic disks, which are used for alpha energy analysis, fission counting, and preparation of geometry standards in ordinary counting. Various methods of preparation were tested and analyzed, but electrodeposition was the most effective method. Deposition was then tested, but the yields were "somewhat erratic".

This report studies tritium oxides and tritium in water vapor, a product of P-10.

The reports aims to determine the solubility limitation of concentrations of uranium in the food preparation step of the tributyl phosphate waste metal recovery process, and the subsequent solubilities in the RA column.

A report intended to correlate the RA and RC Column uranium equilibrium data presented in the reports cited in the introduction.

The following report describes work carried out to investigate whether the Hanford IB column as designed in a previous report will decontaminate the uranium adequately from plutonium, particularly if there's any slowness in either the rate of reduction or transfer of the plutonium.

From summary: "Uranium billets deficient in U235 were subjected to the normal successive steps in the slug fabrication process; viz., rolling, machining, and canning. No unusual behavior was observed at any point in the process, thus indicating that the depleted metal from the standpoint of mechanical properties can be considered equivalent to normal uranium."

Report that communicates a new permissible activity level of plutonium and uranium.

Report discussing studies regarding the properties and nuclear constants of xenon, an element relevant to use of high power thermal neutron reactors.

From summary: The object of the study was to determine if the heavy metal ions within the concentration ranges normally found in pile cooling water were responsible for corrosion of aluminum.

Abstract: "Laboratory production of an explosion between UNH and "red oil" under calcination conditions has been accomplished. Attempted production of a vapor phase explosion was unsuccessful below 150-160 C. Since such severe conditions are necessary to obtain an explosive reaction, it appears that present Purex plant design is adequate to avoid explosive conditions."

Report discussing the procedures and experimental data of various plutonium waste recovery methods. The report elaborates on the different methods of collection necessary for different wastes.

Introduction: "The problem of determining the properties and necessary controls on the TBP Plant waste disposal to eliminate transport line plugging and to permit higher concentration prior to return of this to the tank farms was studied. A report of preliminary findings was made to L. W. Finsh on January 31, 1953. This report compiles information in the aforementioned report and findings since its issuance. Previous studies related to this problem are summarized in the U. R. Technical Manual, HW-19140."

Introduction: "In the evaluation of pile designs it is necessary to know how the production varies with the number of tubes. It has been possible to solve the problem in terms of some general parameters whose values may be quickly computed for any specific design when the pertinent information is available."

Four D-12 coil nests have failed since the start-up of the Redox Separations plant. Due to the high contamination and radiation levels of these vessels, the cost of decontamination has prevented the examination of all but one of the four. It was hoped that the examination of D-12 pot #2 would lead to an explanation of all four failures. This report will deal primarily with the metallurgical examination of the failure of D-12 pot #2.

The purpose of this study has been to evaluate the chemical resistance of various bearing materials to solutions of nitric acid and uranyl nitrate hexahydrate with views toward selecting the best material to be used as bearings in Purex submerged rotating equipment.

An electromagnetic instrument similar to the Multitest was built and used to test 2200 uranium slugs. It was found that the equipment could be used to detect inclusions and cracks in the uranium, but that small cracks are not readily detectable on a production basis unless the material is absolutely uniform in inclusion content. The instrument can be used, however, to sort out hidden defects of a reasonable size and to reject grossly dirty uranium.