Reported are: physics (B pile, D pile, F pile, general physics); and water, corrosion and engineering (process water control and pressure drop studies, purging studies, removal of process tube B-3671).

This technical progress report details 100 Area activities for the time period of July 16 through July 22, 1946.

This report presents the building and design philosophy of Building 234-5 at the Hanford site.

From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."

Measured values of lift, drag, and pitching moment at a Mach number of 1.53 and Reynolds numbers of 0.31, 0.62, and 0.84 million are presented for a wing-fuselage combination having a wing leading-edge sweep angle of 63 degrees, an aspect ratio of 3.42, a taper ratio of 0.25, and an NACA 64A006 section in the stream direction. Data are also presented for sweep angles of 57.0 degrees, 60.4 degrees, 67.0 degrees, and 69.9 degrees. The experimentally determined characteristics were less favorable than indicated by the linear theory but the experimental and theoretical trends with sweep were in good agreement. Boundary-layer-flow tests showed that laminar boundary-layer separation was the primary cause of the differences between experiment and theory.

A manual for the beginning airplane mechanic. Discusses the proper use and care of tools.

Report presenting an altitude-chamber investigation to determine the altitude performance characteristics of the British Rolls-Royce Nene II turbojet engine with an 18.41-inch-diameter jet nozzles. Testing occurred at a range of simulated altitudes and ram-pressure ratios. Results regarding the simulated flight performance, generalized performance, and effect of jet-nozzle area on performance are provided.

"An investigation was conducted in the Cleveland altitude wind tunnel to determine the performance of a Curtiss propeller with four 838-1C2-1SR1 blades on a YP-47M airplane at high blade loadings and engine powers. The study was made for a range of power coefficients between 0.30 and 1.00 at free-stream Mach numbers of 0.40 and 0.50. The results of the force measurements indicate primarily the trend of propeller efficiency for changes in power coefficient or advance-diameter ratio, inasmuch as corrections for the effects of tunnel-wall constriction on the installation have not been applied" (p. 1).

"An altitude-wind-tunnel investigation has been made to determine the performance of a Curtiss 732-1C2-0 four-blade propeller on a YP-47M airplane at high blade loadings and engine power. Propeller characteristics were obtained for a range of power coefficients from 0.30 to 1.00 at free-stream Mach numbers of 0.40 and .50" (p. 1).

None

From Summary: "A blade-element theory for axial-flow compressors has been developed and applied to the analysis of the effects of basic design variables such as Mach number, blade loading, and velocity distribution on compressor performance. The relations among several efficiencies useful in compressor design are derived and discussed. The possible gains in useful operating range obtainable by the use of adjustable stator blades are discussed and a rapid approximate method of calculating blade-angle resettings is shown by an example."

Annual report submitted by the Boy Scouts of America to Congress describing highlights from 1945, activities, organizational leadership, finance, service, public and local relations, other information about scouting programs.

"A theoretical analysis is presented for obtaining by use of Theodorsen's propeller theory the load distribution along a propeller radius to give the optimum propeller efficiency for any design condition. Examples are included to illustrate the method of obtaining the optimum load distributions for both single-rotating and dual-rotating propellers" (p. 1).

The following document analyzes studies to test the use of asphalt as a fast neutron moderating substance to be incorporated as a part of a pile shield.

None

This report contains data acquired during sampling of the Columbia River water on March 26, 1945. Topics of discussion include; the elevation of chlorine levels from 4 ppm to 20 ppm, what steps should be taken to remediate the problem, and the various processes that were taken into consideration for the clean up of this chlorine. Separation processes considered include; ion exchange, distillation, precipitation, heat exchange, and recirculation through a cooling tower.

Report presenting an analysis of the spanwise loading using two different methods on the wing of an airplane for which pressure-distribution measurements were available from flight tests up to a Mach number of 0.866. A comparison between measured and calculated distributions was made on the basis of equal wing-panel normal-force coefficients.

None

Abstract: "An investigation of the mercury salvage program has resulted in the development of an improved high compacity type of distillation apparatus. The still, electrically heated and essentially automatic in its operation, will produce at a rate greater than 75 pounds per hour and develop a product 99.99% pure or better. This still will handle the lowest grade crude of amalgam that can pass through the feed lines and will continue to develop a pure prodcut for comparatively long periods of time. The clean-out operation is amazingly simple and convenient and may be done within one-half hour while the apparatus itself is still hot. Two models of this design are scheduled for installation in a mercury recovery room of the Alpha Analytical Department of Building No. 9207."

"An experimental investigation at low airspeeds was made of the filling effect observed when a screen or similar resistance is placed across a diffuser. The filling effect is found to be real in that screens can prevent separation or restore separated flow in diffusers even of extreme divergence and to depend principally on screen location and pressure-drop coefficient of the screen. Results are given for three different diffusers of circular cross section with a variety of screen arrangements. Effects of single screens and multiple screens are shown" (p. 1).

Report presenting wind-tunnel testing to determine the low-speed lift, drag, and pitching-moment characteristics of a 40 degree sweptback wing with high-lift and stall-control flaps and a fuselage with a fineness ratio of 10.2 to 1. Low, medium, and high-wing-fuselage combinations were tested at high Reynolds numbers. Results regarding the high-lift and stall-control flaps and wing-fuselage combinations are provided.

Report presenting the results of a wind-tunnel investigation of the effects of variation of trailing-edge angle and leading-edge radius on the aerodynamic characteristics of a 10-percent-chord-thick airfoil section at a range of Mach numbers.

The following report studies a method of assay where an unknown sample is determined by comparison with a standard sample of known isotopic ratio. The purpose is to acquaint the technical personnel with the fundamentals of the feedback method of assaying samples of TF6.

The results obtained from gust and draft velocity measurements within thunderstorms for the period July 24, 1946 to August 6, 1946 at Orlando, Florida are presented herein. These data are summarized in tables I and II and are of the type presented in reference 1 for previous flights. In two thunderstorm traverses, indications of ambient-air temperature were obtained from photo-observer records. These data are summarized in table III.