"In addition to a description of the 20-mm aircraft gun matériel M1 and M2, this manual contains technical information required for the identification, use, and care of the matériel."

The weekly progress for D and F piles is given. Status of the test to determine the cause of white deposits on the horizontal control rods of the F pile is given. Also discussed are studies of process water control and pressure drop, corrosion, and graphite expansion. Test results indicate that graphite expansion has not seriously limited discharge of process tubes.

From Introduction: "This paper presents the test data obtained for the NACA 10-(3) (08)-03R propeller blade which was one of the blades tested to determine the effects of shank design."

"An altitude-test-chamber investigation was conducted to determine the operational and performance characteristics of a McDonnell afterburner with a fixed-area exhaust nozzle on a J34 engine. At rated engine speed, the altitude limit, as determined by combustion blow-out, occurred as a band of unstable operation of about 6000-foot altitude in width with minimum altitude limits from 31,000 feet at a simulated flight Mach number of 0.40 to about 45,500 feet at a simulated flight Mach number of 1.00. Considerable difficulty was experienced in attempting to establish or maintain balanced-cycle engine operation at altitudes above 36,000 feet" (p. 1).

An altitude-wind-tunnel investigation of the performance of AN-F-58 and AN-F-32 fuels in an experimental turbojet engine was conducted over a range of simulated altitudes and flight Mach numbers. Combustion efficiencies obtained with AN-F-58 and AN-F-32 fuels were approximately equal. The minimum-speed altitude operational limit was essentially the same with either AN-F-58 or AN-F-32 fuel. Starting characteristics of the two fuels were approximately the same at low wind milling speeds. Visual observation showed no apparent differences in the carbon-deposition rates of AN-F-58 and AN-F-32 fuels.

An investigation of the performance of several propellers on the YP-47M airplane at high blade loadings has been conducted in the Cleveland altitude wind tunnel at the request of the Air Materiel Command, Army Air Forces. As part of the program, a study was made of a Curtiss 836-14C2-18R1 four-blade propeller. The investigation was made for a range of power coefficients from 0.10 to 1.00 at free-stream Mach numbers of 0.30, 0.40, and 0.50 for density altitudes from 10,000 to 45,000 feet, engine powers from 150 to 2500 brake horsepower, and for engine speeds from 1000 to 2900 rpm.

"In order to understand the operation and the interaction of jet-engine components during engine operation and to determine how component characteristics may be used to compute engine performance, a method to analyze and to estimate performance of such engines was devised and applied to the study of the characteristics of a research turbojet engine built for this investigation. An attempt was made to correlate turbine performance obtained from engine experiments with that obtained by the simpler procedure of separately calibrating the turbine with cold air as a driving fluid in order to investigate the applicability of component calibration. The system of analysis was also applied to prediction of the engine and component performance with assumed modifications of the burner and bearing characteristics, to prediction of component and engine operation during engine acceleration, and to estimates of the performance of the engine and the components when the exhaust gas was used to drive a power turbine" (p. 1).

Memorandum presenting an approximate method for the estimation of the properties of the incompressible laminar boundary layer on a flat plate in the slip-flow region using Karman's momentum method. At equivalent stations, the total thickness and the skin friction of a slipping boundary layer are less than that of the normal boundary layer at the same Reynolds number.

A major problem encountered in the Manhattan Project was the protection of workers against damage resulting from acute or chronic exposure to external radiation. The problem of how to detect evidence of damage following exposure to total body radiation led to this study. These studies were conducted between January, 1942 and November, 1945. Three groups of persons were employed in this study. The first group of eight individuals harboring incurable neoplasms which was not extensive enough to influence general health, these patients were treated with 400 KV x-radiation while sitting in a wooden chair, doses were 27, 60, and 120r. Three persons having generalized illnesses chronic in nature were given total body radiation using 200 KV X-rays in multiple exposures totaling 100, 300, and 500r. A third group of normal volunteers from personnel of the Metallurgical Laboratory were treated with 200 KV x-rays in three divided doses totaling 21 r. Changes in peripheral blood in the fourteen individuals is reported. In group 1 the most persistent abnormality noted was a diminution in the number of lymphocytes after completion of the treatment. In group 2 a depression in the lymphocytes was also the most marked single change. In group 3 no …

A guide to the operation and maintenance of the portable electrocardiograph.

Memorandum presenting wind-tunnel tests to determine the aerodynamic characteristics of a 15-percent- and a 35-percent-chord plain trailing-edge flap on the NACA 0006 airfoil section. Simultaneous measurements of section lift, drag, and pitching moment were made over a range of Mach numbers, angles of attack, and flap deflections.

Abstract: "The advantages of high scaling ratios in counting random pulses are discussed. The mechanism of the basic circuit used in the Columbia University scaling circuits is described. The difficulties experienced in the performance of the earlier circuits are indicated and modified circuits to eliminate these difficulties are given. Precautions that must be observed in carrying out the constructional details are suggested. The complete circuit and specifications are given in detail for a Scale of 128 for use with linear-amplifier systems" (p. 1).

Report presenting an investigation using a 4600 pound-thrust turbojet engine as part of a program to determine the comparative performance of fuels conforming to specifications AN-F-58 and AN-F-32. Results regarding the altitude performance, altitude low-speed blow-out limits, idling limits of fuel-metering control, altitude windmilling starts, carbon-deposition rates, and iron oxide contamination are provided.

"This supplement outlines in detail the methods for plotting of observation data, for entry of analysis, and for preparation of supplementary maps, charts, and diagrams for all Army Air Forces weather stations."

Abstract: "Gravitational observations were made of the pre-Cambrian Coal Creek serpentine mass in Blanco and Gillespie Counties, Texas, the geology of which had been mapped previously. The observed gravitational anomalies indicate roughly the depth of the serpentine mass below which it may possibly grade into its parent peridotitic rock. Probable correlation between the gravitational map and the other geologic features of the area is indicated" (p. 151).

In order to obtain a correlation of drag data from wind-tunnel and flight tests at high Mach numbers, a typical pursuit airplane, with the propeller removed, was tested in flight at Mach numbers up to 0.755, and the results were compared with wind-tunnel tests of a 1/3-scale model of the airplane. The tests results show that the drag characteristics of the test airplane can be predicted with satisfactory accuracy from tests in the Ames 16-foot high-speed wind tunnel of the Ames Aeronautical Laboratory at both high and low Mach numbers. It is considered that this result is not unique with the airplane.

Tests were made in the Langley 7 by 10 foot tunnel on a model of a fighter-type airplane with external stores. The data obtained is presented and compared to flight-test results to determine the feasibility of estimating flight buffet Mach number from tunnel data.

From introduction: "This report examines the hazard which would result in the extremely unlikely event that all of the safety devices failed to operate either by accident or sabotage."

Design data are presented for the graphical construction of two-dimensional sharp-edge-throat supersonic nozzles of minimum length for test-section Mach numbers from 1.20 to 10.00. The method of characteristics used in the design is briefly reviewed.

Abstract: "A method for the potentiometric titration of uranium with ferric sulfate is described. This method provides a rapid and accurate way of determining the element in solutions free from interfering ions. Application of the method to analysis of pure uranium compounds and to uranium recovered from contaminated solutions by suitable procedures is briefly discussed."

Abstract. A satisfactory method has been found for dissolving thorium metal and thorium oxide in heat-treated 25-12 stainless steel vessels without excessive corrosion of the vessels. The dissolution medium consists of strong HNO3 containing a small amount of fluoride or fluo-silicate. the fluoride required has no harmful effects on a subsequent solvent-extraction step for a separation of uranium isotopes from the dissolved thorium.

"An investigation was conducted in an altitude test chamber to determine the effects of inlet airflow distortion on the compressor steady-state and surge characteristics of a high-pressure ratio, axial-flow turbojet engine. Circumferential-type inlet flow distortions were investigated, which covered a range of distortion sector angles from 20 deg to 168 deg and distortion levels up to 22 percent. The presence of inlet airflow distortions at the compressor face resulted in a substantial increase in the local pressure ratio in the distorted region, primarily for the inlet stages" (p. 1).

Abstract. The effect of various inhibitors on the production of CrIII in W waters containing chromatic has been studies at a variety of pH's in the CP-3 pile. The addition of 2 ppm NaClO3 appears to have little effect a a pH of 5.3, but 2 ppm NaClO3 cr 0.15 ppm of Cl2 (in the form of NaOCl) somewhat decreases the amount of chromatic reduced at a pH of 7.1. The inhibition is not great enough, however, to reduce the amount of CrIII formed to the maximum concentration permissible at W (0.02 ppm). The addition of 3 ppm (NH4)2S2O3 as an inhibiter will permit W water to be used a a Ph of 7.0, but not at a pH of 6.5 as far as chromate reduction is concerned. The concentration of CrIII would be 0.01 ppm and 0.05 ppm, respectively, after one passage through the pile. Previous conclusion as to the effects of temperature, pH, intensity and the addition of ammonium persulfate, which had been reached from experiments with simulation W water, have been checked by studies with solutions made from water chipped directly from Hanford. All of the effects noted were found to be similar to those already reported, …

Abstract. Measurements were made to determine the effect of thermal cycling on heat transfer from slug to jack using a slug with a sand blasted surface. The value of the transfer coefficient h decreased from initial values ranging from 10 to [formula], to values and [formula] after 1700 cycles, and to a range of 0.15 to 0.45 [formula] after 3200 cycles. Comparisons are made with the results found for slugs with different surfaces.