"The hot-wire anemometer suggests itself as a promising method for measuring the fluctuating air velocities found in turbulent flow. The only obstacle is the presence of a lag due to the limited energy input which makes even a fairly small wire incapable of following rapid fluctuations with accuracy. This paper gives the theory of the lag and describes an experimental arrangement for compensating for the lag for frequencies up to 100 or more per second when the amplitude of the fluctuation is not too great. An experimental test of the accuracy of compensation and some results obtained with the apparatus in a wind-tunnel air stream are described. While the apparatus is very bulky in its present form, it is believed possible to develop a more portable arrangement" (p. 359).

This report shows how the actual performance of an airplane varies with air temperature when the pressure is held constant. This leads to comparatively simple methods of reducing observed data to standard conditions. The new methods which may be considered exact for all practical purposes, have been used by the Navy Department for about a year, with very satisfactory results. The report also contains a brief historical review of the important papers which have been published on the subject of performance reduction, and traces the development of the standard atmosphere. (author).

This report describes in detail the new propeller research tunnel of the National Advisory Committee for Aeronautics at Langley Field, Va. This tunnel has an open jet air stream 20 feet in diameter in which velocities up to 110 M. P. H. Are obtained. Although the tunnel was built primarily to make possible accurate full-scale tests on aircraft propellers, it may also be used for making aerodynamic tests on full-size fuselages, landing gears, tail surfaces, and other aircraft parts, and on model wings of large size. (author).

"This investigation was made to determine the pressure distribution over a rib of the wing and over a rib of the horizontal tail surface of an airplane in flight and to obtain information as to the time correlation of the loads occurring on these ribs. Two airplanes, VE-7 and TS, were selected in order to obtain the information for a thin and a thick wing section. In each case the pressure distribution was recorded for the full range of angle of attack in level flight and throughout violent maneuvers" (p. 79).

This research was undertaken in connection with a general study of the application of the fuel injection engine to aircraft. The purpose of the investigation was to determine the effect of four important factors in the design of a centrifugal type automatic injection valve on the penetration, general shape, and distribution of oil sprays. The general method employed was to record the development of single sprays by means of special high-speed photographic apparatus capable of taking 25 consecutive pictures of the moving spray at a rate of 4,000 per second. Investigations were made concerning the effects on spray characteristics, of the helix angle of helical grooves, the ratio of the cross-sectional area of the orifice to that of the grooves, the ratio of orifice length to diameter, and the position of the seat. Maximum spray penetration was obtained with a ratio of orifice length to diameter of about 1.5. Slightly greater penetration was obtained with the seat directly before the orifice.

From Summary: "The purpose of this test was to compare six well-known airfoils, the R.A.F 15, U.S.A. 5, U.S.A. 27, U.S.A. 35-B, Clark Y, and Gottingen 387, fitted to the Sperry Messenger model, at full scale Reynolds number as obtained in the variable density wind tunnel of the National Advisory Committee for Aeronautics; and to determine the scale effect on the model equipped with all the details of the actual airplane. The results show a large decrease in minimum drag coefficient upon increasing the Reynolds number from about one-twentieth scale to full scale. A comparison is made between the results of these tests and those obtained from tests made in this tunnel on airfoils alone."

"In this report a formula for calculating the induced drag of multiplanes with end plates is derived. The frictional drag of the end plates are used, is sufficiently large to increase the efficiency of the wing. Curves showing the reduction of drag for monoplanes and biplanes are constructed; the influence of gap-chord ratio, aspect ratio, and height of end plate are determined for typical cases. The method of obtaining the reduction of drag for a multiplane is described" (p. 253).

This report presents the results of an investigation of the planing and get-away characteristics of three representative types of seaplanes, namely, single float, boat, and twin float. The experiments carried out on the single float and boat types have been reported on previously. This report covers the investigation conducted on the twin-float seaplane, the DT-2, and includes as an appendix, a brief summary of the results obtained on all three tests. At low-water speeds, 20 to 30 miles per hour, the seaplane trims by the stern and has a high resistance. Above these speeds the longitudinal control becomes increasingly effective until, with corresponding speeds of 56 to 46 miles per hour. It was further determined that an increase in the load caused little if any change in the water speed at which the maximum angle and resistance occurred, but that it did produce an increase in the maximum angle.

This report was prepared at the request of the National Advisory Committee for Aeronautics in order to supply a systematic study of the relations between the flight velocity V and its horizontal component V subscript H, in power glides. Curves of V and V subscript H plotted against the inclination of the flight path 0 are given, together with curves which show the maximum values of V subscript H and the corresponding values of 0. Curves are also given showing the effect of small departures from the horizontal in high speed performance testing.

This report is a compilation of test data on airplane fuselages, nacelles, airship cars, seaplane floats, and seaplane hulls, prepared by the Bureau of Aeronautics, at the requests of the National Advisory Committee for Aeronautics. The discussion of the data includes the derivation of a scale correction curve to be used in obtaining the full scale drag. Composite curves of drag and L/D for floats and hulls are also given. (author).

This report develops new equations which give the range and endurance of airplanes with an accuracy equal to that obtained from a step-by-step integration of the flight. A method of obtaining equally satisfactory results from Brequet's equations is also given in detail. A third method of calculating range and endurance, derived by the writer for use in routine estimating in the Bureau of Aeronautics, is also given in full. The reports contains tables and curves arranged for convenient use and illustrates the three methods by comparative estimates.

This report, on the planing and get-away characteristics of the F-5-L, gives the results of the second of a series of take-off tests on three different seaplanes conducted by the National Advisory Committee for Aeronautics at the suggestion of the Bureau of Aeronautics, Navy Department. The single-float seaplane was the first tested and the twin-float seaplane is to be the third. The characteristics of the boat type were found to be similar to the single float, the main difference being the increased sluggishness and relatively larger planing resistance of the larger seaplane. At a water speed of 15 miles per hour the seaplane trims aft to about 12 degrees and remains in this angular position while plowing. At 2.25 miles per hour the planing stage is started and the planing angle is immediately lowered to about 10 degrees. As the velocity increases the longitudinal control becomes more effective but over control will produce instability. At the get-away the range of angle of attack is 19 degrees to 11 degrees with velocities from the stalling speed through about 25 per cent of the speed range.

Detailed tables of pressures and densities are given for altitudes up to 20,000 meters and to 65,000 feet. In addition to the tables the various data pertaining to the standard atmosphere have been compiled in convenient form for ready reference. This report is an extension of NACA-TR-147.

Equations for instantaneous velocity and distance flown are derived for an airplane which crosses the starting line of a speed course at a speed higher than that which can normally be maintained in horizontal flight. A specific case is assumed and calculations made for five initial velocities. Curves of velocity, average velocity, and distance flown are plotted against time for each case and analyzed. It is shown that the increase in average velocity due to a diving start may be very large for short-speed courses.

From Summary: "This report is a study of a test data on a family of Durand's propellers (nos. 3, 7, 11, 82, 113, 139), which is fairly representative of conventional design. The test data are so plotted that the proper pitch and diameters for any given set of conditions are readily obtained. The same data are plotted in other forms which may be used for calculating performance when the ratio of pitch to diameter is known. These new plots supply a means for calculating the performance, at any altitude, of airplanes equipped with normal or supercharged engines."

At the request of the Bureau of Aeronautics, Navy Department, the National Advisory Committee for Aeronautics at Langley Field is investigating the get-away characteristics of an N-9H, a DT-2, and an F-5l, as representing, respectively, a single float, a double float, and a boat type of seaplane. This report covers the investigation conducted on the N-9H. The results show that a single float seaplane trims aft in taking off. Until a planing condition is reached the angle of attack is about 15 degrees and is only slightly affected by controls. When planing it seeks a lower angle, but is controllable through a widening range, until at the take-off it is possible to obtain angles of 8 degrees to 15 degrees with corresponding speeds of 53 to 41 M. P. H. or about 40 per cent of the speed range. The point of greatest resistance occurs at about the highest angle of a pontoon planing angle of 9 1/2 degrees and at a water speed of 24 M. P. H.

This report contains a series of charts which were developed in order to simplify the estimation of airplane performance. Charts are given for estimating propeller diameter and efficiency, maximum speed, initial rate of climb, absolute ceiling, service ceiling, climb in 10 minutes, time to climb to any altitude, maximum speed at any altitude, and endurance. A majority of these charts are based on the equations given in NACA Technical Report no. 173. Plots of pressure and density against altitude in standard air are also given for convenience. It must be understood that the charts giving propeller diameter, maximum speed, initial rate of climb, absolute ceiling, and speeds at altitudes are approximations subject to considerable error under certain conditions. These particular charts should not be used as a substitute for detailed calculations when accuracy is required, as, for example, in military proposals. (author).

"These experiments were made at the request of the Bureau of Aeronautics, Navy Department, to investigate the velocity of the air in the slipstream in horizontal and climbing flight to determine the form of expression giving the slipstream velocity in terms of the airspeed of the airplane. The method used consisted in flying the airplane both on a level course and in climb at full throttle and measuring the slipstream velocity at seven points in the slipstream for the whole speed range of the airplane in both conditions. In general the results show that for both condition, horizontal and climbing flights, the slipstream velocity v subscript 3 and airspeed v can be represented by straight lines and consequently the equations are of the form: v subscript s = mv+b where m and b are constant" (p. 199).

From Summary: "This report contains a brief study of the variation of engine power with temperature and pressure. The variation of propeller efficiency in standard atmosphere is obtained from the general efficiency curve which is developed in NACA report no. 168. The variation of both power available and power required are then determined and curves plotted, so that the absolute ceiling may be read directly from any known sea-level value of the ratio of power available to power required."

This report is an extension of NACA-TR-168 and has been prepared for the National Advisory Committee for Aeronautics to show the relative values of various direct and geared drives. It is well known that in general a geared-down propeller has higher efficiency than a direct-drive propeller, but the literature on this subject does not present the data in such form that the aeronautical engineer can readily visualize the effect of gearing. This report has been prepared to show the actual net gain or loss in maximum efficiency due to the use of various modifications of the conventional two-bladed, direct-drive propeller. (author).

This report contains the derivation and the verification of formulae for predicting the speed range ratio, the initial rate of climb, and the absolute ceiling of an airplane. Curves used in the computation are given in NACA-TR-171. Standard formulae for service ceiling, time of climb, cruising range, and endurance are also given in the conventional forms.

This report describes the theory of calculating the principal stresses in the envelope of a nonrigid airship used by the Bureau of Aeronautics, United States Navy. The principal stresses are due to the gas pressure and the unequal distribution of weight and buoyancy, and the concentrated loads from the car suspension cables. The second part of the report deals with the variations of tensions in the car suspension cables of any type of airship, with special reference to the rigid type, due to the propeller thrust or the inclination of the airship longitudinally.

"The object of the investigation described in this report was to compare the damping coefficients of an airfoil as calculated from a knowledge of the static characteristics of the section with those obtained experimentally with an oscillation. The damping coefficients as obtained, according to the conventional notation, can be considered either as due to pitching or as due to yawing, the oscillation in these experiments being so arranged that the surfaces oscillate about a vertical axis. This is in reality the case when the influence is yawing about the standard Z-axis, but it can also be considered as a pitching motion when the model is so rigged that its standard Y-axis becomes vertical" (p. 118).

Among the fuels which will operate at compression ratios up to at least 8.0 without preignition or "pinking" is hecter fuel, whence a careful determination of its performance is of importance. For the test data presented in this report the hecter fuel used was a mixture of 30 per cent benzol and 70 per cent cyclohexane, having a low freezing point, and distilling from first drop to 90 per cent at nearly a constant temperature, about 20 degrees c. below the average distillation temperature ("mean volatility") of the x gasoline (export grade). The results of these experiments show that the power developed by hecter fuel is the same as that developed by export aviation gasoline at about 1,800 r.p.m. at all altitudes. At lower speeds differences in the power developed by the fuels become evident. Comparisons at ground level were omitted to avoid any possibility of damaging the engine by operating with open throttle on gasoline at so high a compression. The fuel consumption per unit power based on weight, not volume, averaged more than 10 per cent greater with hecter than with x gasoline. The thermal efficiency of the engine when using hecter is less than when using gasoline, …