Tests were made on the 1927 Williams racer in order to determine the effect of the wing radiator on the airfoil characteristics. It was found that the radiator doubled the minimum drag of the portion of the wing it covered, and also reduced the lift somewhat.

"These experiments show that the rate of auto rotation of a monoplane airfoil is reduced by sweepback, ceasing entirely when the sweepback is 30 degrees. In addition a very serious increase in rate and range of auto rotation with yaw is shown" (p. 1).

Tests were made on four racing type airfoils, the N-9, N-38, C-62, and N-46, in order to determine the high speed characteristics of the wings. The results indicate that the N-46 has about 12 percent lower minimum drag than the regular C-62 section, and that both the N-38 and N-46 have the same exceptionally low minimum drag coefficient.

In the development of Diesel engine fuel injection systems it is necessary to have an approximate knowledge of the absolute viscosity of the fuel oil under high hydrostatic pressures. This report presents the results of experimental tests conducted by Mr. Jackson Newton Shore, utilizing the A.S.M.E. high pressure equipment.

This report describes preliminary wind tunnel tests on a model of a monoplane wing equipped with wing tip floating ailerons. Lift and drag, as well as rolling and yawing moments, were measured.

An investigation was conducted to determine the injection lag, duration of injection, and spray start and cut-off characteristics of a fuel injection system operated on an engine and injecting fuel into the atmosphere. The results indicated that for the injection system investigated, the injection lag, in crank degrees, decreased with increase in engine speed for a constant quantity of fuel discharged, but was not affected at constant engine speed by varying the fuel quantity from approximately one-half to full load fuel quantity.

This report is concerned with the importance of the flat-top lift curve as a factor contributing to safety and control at low speed. An analysis of existing airfoil data indicated definite relations between the shape of the lift curve and certain section dimensions. The shape of the lift curve at maximum lift appears to be of sufficient importance to justify additional investigation with the view of developing a section with satisfactory efficiency and moment characteristics.

From Summary: "Tests have been made in the atmospheric wind tunnel of the National Advisory Committee for Aeronautics to determine the effects of pitching oscillations upon the lift of an airfoil. It has been found that the lift of an airfoil, while pitching, is usually less than that which would exist at the same angle of attack in the stationary condition, although exceptions may occur when the lift is small or if the angle of attack is being rapidly reduced. It is also shown that the behavior of a pitching airfoil may be qualitatively explained on the basis of accepted aerodynamic theory."

"This paper contains a description of the method of measuring the moments of inertia of full scale airplanes as practiced by the National Advisory Committee for Aeronautics at the Langley Memorial Aeronautical Laboratory. The method, while not at all new, is published for the information and guidance of others who may desire to make similar measurements. The paper includes as an appendix the computations for the moments of inertia of 0-2 airplane" (p. 1).

Report presenting testing in the variable density wind tunnel on two airship models known as the NPL Standardization Models, long and short. The resistance or shape coefficients were determined for each model through a range of Reynolds numbers. Further work is found to be necessary in the standardization of wind tunnels.

Report presenting an examination of the drag of airships in order to design more functional aircraft and to obtain information for future research.

"This report, prepared at the request of NACA, gives the results of tests on a model propeller having blade sections with form of Gottingen airfoil no. 409. The model is shown to have a dynamic pitch practically equal to the nominal or geometrical pitch, and a somewhat higher efficiency but lower coefficient than would be expected of a propeller of more conventional sections" (p. 1).

The following note, prepared for the NACA, contains several remarks on the possible improvement of the experimental determination of the aerodynamic properties of wing sections. It shows how errors of observation can subsequently be partially eliminated, and how the computation of the maxima or minima of aerodynamic characteristics can be much improved.

"This note shows that the main part of the discrepancy between full flight propeller performance and the performance of models in a wind tunnel is due to a scale effect, and that a minor part is caused by body interference. Analyses are made of propeller performances on several standard airplanes, and the actual brake horsepower compared with the power as calculated from model test data. The calculated power is based on that absorbed by a wind tunnel propeller model which is geometrically similar to the full scale propeller and is operating under the same ratio of V/nD" (p. 1).

"The tests described herein were made in 1918, in the old four-foot wind tunnel at the Massachusetts Institute of Technology and at the request of the Engineering Division of the U.S. Army Air Service. The results were given circulation only in official circles at that time. The interest of the work appears sufficient to justify its wider distribution even at this very late date" (p. 1).

A series of experiments were conducted related to the action of an airstream oscillating vertically on supporting surfaces. The object of the experiments was to verify the very interesting results of Mr. Katzmayr, Director of the Vienna Aerodynamics Laboratory, and, if possible, to obtain more complete data on the effect of the amplitude and velocity of the oscillations of the airstream. The results obtained by Mr. Katzmayr are briefly summarized. The conduct of the numerous experiments to verify his results are described in detail. Experimental results are given in tabular and graphical form.

A description is given of the methods used in design of Micarta propellers. The most direct method for working out the design of a Micarta propeller is to start with the diameter and blade angles of a wooden propeller suited for a particular installation and then to apply one of the plan forms suitable for Micarta propellers. This allows one to obtain the corresponding blade widths and to then use these angles and blade widths for an aerodynamic analysis.

"This report deals with an investigation carried out in the Civil Engineering Laboratory of the University of California, to determine the accuracy of existing methods of computing the stresses in an airplane fuselage when subjected to torsion, and to derive a simple approximate formula for the rapid calculation of these stresses. The formula is derived by using the customary least work equation and considering each bay separately" (p. 1).

The first section deals with the theoretical side of statical stability of airships in general. The second section deals with preliminary tests of the model and experiments for the determination of effects due to change of tail area, aspect ratio, tail form, and tail thickness.

Note presenting an analysis of the propeller model tests of Dr. Schaffran. Only the thrust is examined. The results indicate that the thrust produced by three-blade and four-blade propellers follows the same laws as with two-blade propellers, and that all conclusions reached from Dr. Durand's tests can be upheld.

The chief purpose in undertaking the development of this synchronous motor was the creation of a very small, compact power source, capable of driving the film drums of the recording aircraft instruments designed by the staff of the National Advisory Committee for Aeronautics.

Discussed here is research on a spring activated fuel pump for solid or airless injection with small, high speed internal combustion engines. The pump characteristics under investigation were the interval of fuel injection in terms of degrees of crank travel and in absolute time, the lag between the time the injection pump plunger begins its stroke and the appearance of the jet at the orifice, and the manner in which the fuel spray builds up to a maximum when the fuel valve is opened, and then diminishes.

"This investigation was undertaken to determine the relative effects of those factors which may interfere with the rudder control of an airplane, with especial reference to the process of landing. It shows that ground interference is negligible, but that the effects of a large rounded body and of the slip stream may combine to interfere seriously with rudder control at low flying speeds and when taxiing" (p. 1).

Given here are evaluations of six different European aircraft from the point of view of a passenger. The aircraft discussed are the DH 34, the Handley-Page W8B, the Farman Goliath, the Potez IX, the Spad 33 (Berline), and the Fokker F.III. The airplanes were evaluated with regard to seating comfort, ventilation, noise, seating arrangements, cabin doors, baggage accommodation, interior arrangement of cabins, pilot's position and communication with the pilot, pilot accommodations, view from the cabin, safety, and lavatory accommodations.