Technical report describing that the pressure drop along an annular channel with dimensions D(1) = 0.375 inch; D(2) = 0.875 inch, L = 70 inches. Flow was vertical and upward, and only the internal surface was heated. Subcooled conditions existed at the inlet, with two-phase conditions at the exit. Groups of three radial spacer pins on 18-inch centers along the channel, held the inner surface concentric with the outer surface. The single phase loss coefficient for each spacer group is K(8) = 0.21. The single phase friction factor for the annual channel is given by f = 0.16 N(R)(-0.16). The two phase pressure drop increases as the quality increases for G [over] 10(6) = 0.5 ;b/hr ft(2). The effect of heat flux on the pressure drop is very is very slight over the range of fluxes tested (0.55 less than or equal to Q over 10(6).\ less than or equal to 0.8). The two-phase pressure drop gradient in the same annulus, with no heat addition is qualitatively the same as for a 1/4-inch by 1-3/4 inches rectangular channel but is quantitatively greater than for the rectangular channel.

Abstract: A cyclic stress analysis of the SM-1 primary system was carried out. Problems encountered in the fabrication of PM-2A Core II and SM-lA Core II are described, and the results of an examination of damaged SM-lA Core I stationary fuel elements reported. A preliminary study of the radiation damage to SM-1 reactor vessel was made and the possibility of annealing the vessel discussed. Performance analyses are presented for five cores: SM-1 Core, SM-1 Core 1 rearranged and spiked, SM-1 Core II with special components, PM-2A Core 1, and SM- 1A Core 1. Preliminary critical experiments were made with SM-2 elements in a SM- 1 core configuration and nuclear and thermal analyses of the use of SM-2 elements in SM-1, SM-1A, and PM-2A completed. A throttling steam calorimeter was selected for measuring moisture carry-over on the PM-2A steam generator. Test procedures for evaluating the shielding of the SM-1, SM-lA, and PM-2A plants are summarized. Radiochemical and chemical analyses of SM-1 coolant and crud are summarized, and methods of activity control discussed. Preliminary results of studies of the properties of reactor pressure vessels under irradiation and no irradiation conditions are summarized briefly.