Three airfoils were tested with an intersecting flat plate normal to the span as a preliminary study of interference effects on airfoils. Small interference effects were noted on the first two airfoils, while larger effects were noted on the NACA 66,2-422 section, which had previously been shown to be unconservative with respect to separation. Airfoils known to be conservative should be used for inboard sections subject to nacelle and fuselage interference.

Wing pressure distribution diagrams for several angles of attack and flap deflections of 0 degrees, 20 degrees, and 40 degrees are presented. The normal force coefficients agree with lift coefficients obtained in previous test of the same model, except for the maximum lifts with flap deflection. Pressure distribution measurements were made at Reynolds Number of about 6,000,000.

Report presenting pressure distribution measurements on two 24-inch chord models equipped with Fowler flaps in the two-dimensional low-turbulence pressure tunnel. Results regarding pressure-distribution diagrams and normal-force and moment coefficients are provided.

Report presenting testing in the two-dimensional tunnel of four models submitted by the Glenn L. Martin Company as intermediate sections of the wing of the XB-33 airplane. Each airfoil model had different types of flaps or no flaps at all. Results regarding the lift and drag data, lift coefficients, effect of flap positions, aileron effects, drag coefficients, and hinge-moment coefficients are provided.

Tests were made in the NACA two-dimensional low turbulence pressure tunnel of a highly cambered low-drag airfoil (NACA 65,3-618) with a plain flap designed for lift control. The results indicate that such a combination offers attractive possibilities for obtaining low profile-drag coefficients over a wide range of lift coefficients without large reductions of critical speed.

"Hot-air engines with dynamic compressors and turbines offer new prospects of success through utilization of units of high efficiencies and through the employment of modern materials of great strength at high temperature. Particular consideration is given to an aerodynamic prime mover operating on a closed circuit and heated externally. Increase of the pressure level of the circulating air permits a great increase of limit load of the unit. This also affords a possibility of regulation for which the internal efficiency of the unit changes but slightly. The effect of pressure and temperature losses is investigated" (p. 1).

Report published by the U.S. Bureau of Mines regarding accidents at mines located in the United States for all operations except coal mines. The report includes statistics about the number and kinds of accidents as well as information about the mining operations (i.e., number of persons employed, average amount of work performed per person, etc.).

Report published by the U.S. Bureau of Mines which is a compilation of accidents in quarries located in the United States with data regarding the number and kinds of accidents as well as information about the mining operations (e.g., number of men employed, kinds of quarries, amount of work performed, etc.).

Report compiled by the U.S. Bureau of Mines including statistics on fatal and non-fatal accidents in coal mines located in the United States as well as data regarding the various operations (e.g., number of miners employed and average production). The information is organized into tables for comparison and the text draws some overall conclusions in the summary.

Report compiled by the U.S. Bureau of Mines including statistics on fatal and non-fatal accidents in coal mines located in the United States as well as data regarding the various operations (e.g., number of miners employed and average production). The information is organized into tables for comparison and the text draws some overall conclusions in the summary.

Report discusses the results of an experimental investigation of two low-drag wing-nacelle units suitable for use with pusher propellers. The benefits of adding a nacelle to the wing are detailed.

Report presenting a practical method for determining the chordwise distribution of the rate of heat transfer from the surface of a wing or body of revolution to air. The method is limited to use to the determination of heat transfer fro the forward section of such bodies when the flow is laminar.

Report issued by the U.S. Bureau of Mines regarding laboratory tests conducted on acid leaching of manganese ore. Descriptions of the methods used in testing and results are presented. This report contains tables, and graphs.

The yield of 49, the efficiency of production of 49, and poisoning in a power plant are discussed. Only the crudest of estimates of the poisoning are possible: these indicated that production will probably not be hampered by poisoning. In this case the yield of 49 could be as high as 3 kg/ton but only about 2 kg/ton is compatible with a fairly high efficiency. In the case that production is stopped by poisoning, smaller yields, proportional to the tolerable loss in k, are obtained. In this case the yield will be improved by a factor of 2 or 3 if only the most poisoned parts are extracted and replaced by new uranium.

"Tensile and compressive stress-strain curves, stress-deviation curves, and secant modulus-stress curves are given for longitudinal and transverse specimens of 17S-T, 24S-T, and 24S-RT aluminum-alloy sheet in thicknesses from 0.032 to 0.081 inch, 1025 carbon steel sheet in thicknesses of 0.054 and 0.120 inch, and chromium-nickel steel sheet in thicknesses form 0.020 to 0.0275 inch. Significant differences were found between the tensile and the compressive stress-strain curves, and also the corresponding corollary curves; similarly, differences were found between the curves for the longitudinal and transverse directions" (p. 1).

Report presenting aerodynamic tests of a 300-pound M-31 demolition bomb. Force tests at a range of angles of attack were made at Mach number 0.725, which corresponds to a speed of 810 feet per second at sea level. Results regard the drag, lift, and pitching moment are provided.

From abstract: The Parkfield district, one of the minor California quicksilver districts, lies on the southern end of the Diablo Range, in the southeastern part of Monterey County and the westernmost tip of Kings County. (...) Two geologically similar areas, separated by 10 miles of unmineralized rocks, have been mapped. These areas contain (1) sedimentary, volcanic, and metamorphic rocks belonging to the Franciscan formation, of probable Jurassic age, (2) sedimentary rocks of Cretaceous age, (3) a few outcrops of fossiliferous strata assigned to the Temblor formation, of middle Miocene age, (4) large masses of serpentine emplaced along fault zones in post-Miocene time, (5) lenses of silica-carbonate rock formed by the alteration of the serpentine, and (6) large areas of landslide.

This report discusses geologic work conducted in the Strayton district, California on the deposits of quicksilver and antimony.

Report presenting data on the rolling accelerations of airplanes of different types and sizes in abrupt aileron rolls in connection with a number of maneuverability and flying qualities investigations. An analysis was made to determine the relation between the torque applied to the aileron system by the pilot, the motion of the system, and the subsequent rolling motion of the airplane in abrupt aileron roll.

Report presenting the results of a series of flight tests of the maximum speed and cooling characteristics in high-speed level flight and in climb of the XP-42 airplane equipped with a long-nose high-inlet-velocity cowling. The results indicated that a maximum speed of 338 miles per hour at 870 horsepower at 17,000 feet was achievable, which is above the engine critical altitude. Pressure measurements in the entrances in the cylinder baffles showed a uniform distribution of pressure on the front of the engine in high-speed level flight and a fairly uniform distribution in full-power climb.

Report presenting computations made to determine the effect of changes in wing aspect ratio, additional side area, flight-path angle, and normal acceleration on the relation between the fin area and the dihedral angle required for spiral and for oscillatory lateral stability for a hypothetical airplane of the pursuit or fighter categories. The diagrams indicate that the effect of wing aspect ratio on lateral stability is small.

This report is part of a series describing the structural features, the character of the oil- and gas-producing beds, and the localities where additional oil and gas may be found in parts of Osage County, Oklahoma. This part provides an overview of the discussions in the previous 10 publications and provides a summary of relevant information.

This report is part of a series describing the structural features, the character of the oil- and gas-producing beds, and the localities where additional oil and gas may be found in parts of Osage County, Oklahoma. This part discusses the geology and resources of the Burbank and South Burbank oil fields, in the northwestern part of Osage County and the eastern part of Kay County.

Report presenting testing in the high-speed wind tunnel to determine the drag characteristics of several types of radial-engine nacelle on a low-drag airfoil. The drag coefficients of nacelles incorporating cowling-nose shapes shown by previous tests to be efficient and afterbodies of adequate length were about the same magnitude as commonly obtained for comparable installations on conventional wings. Results regarding the reduction of data, effect of nacelles on lift, and pressures at wing-nacelle juncture are provided.