Report presenting an investigation of the rolling effectiveness of a wing-spoiler arrangement using a rocket-propelled test vehicle in free flight. The configuration investigated in the report is likely not optimum and indicates a need for further exploration.

"A spin investigation has been conducted in the Langley 20-foot free-spinning tunnel on a 1/24-scale model of the North American XP-86 airplane. The effects of control settings and movements upon the erect and inverted spin and recovery characteristics of the model were determined for the design gross weight loading. The long-range loading was also investigated and the effects of extending slats and dive flaps were determined" (p. 1).

Memorandum presenting an investigation of an axial-flow compressor rotor operating with supersonic velocities relative to the blade rows in order to determine the performance characteristics in air and to confirm the performance obtained in Freon-12 at another laboratory. Results regarding the weight flow, work of compression, pressure ratio and adiabatic efficiency, and entry of shock are provided.

Report presenting testing on a series of five flat plate models of aspect ratio 2.0 with 25-percent-mean-aerodynamic-chord flaps at a range of Mach numbers in order to investigate the effect of sweepback on flap effectiveness.

Report presenting an experimental investigation at zero flight speed and sea-level conditions on a 4000-pound-thrust centrifugal-flow-type turbojet engine to determine the amount of thrust augmentation obtainable at maximum rotor speed by the injection of water, alcohol, and water-alcohol mixtures at the compressor inlets. A maximum thrust augmentation of 26 percent was obtained by the injection of 4.5 pounds per second of water and 2.0 pounds per second of alcohol. Results regarding the tail-pipe gas temperature, air-flow and compressor-outlet pressure, fuel flow, specific liquid consumption, and thrust augmentation are provided.

The following report describes procedures taken to utilize the photelometer to procure the most rapid and reliable determinations, but the goal of the tests presented was to create satisfactory dispersions of particles to analyze.

The effects on dynamic lateral stability and controllability of some of the important aerodynamic and mass characteristics are discussed and methods are presented for estimating the various stability parameters to be used in the calculation of the dynamic lateral stability of airplanes with swept and low-aspect-ratio wings.

This report describes the use of pile control over atomic power, including the different methods of control.

Technical report includes three reports of research progress: 1)Meson Mass Determination by Grain Counting, W. H. Barkas; 2) The Magnetic Beta Ray Lens Spectrograph, A. C. Helmholz; 3) Anthracene Counters, E. Martinelli.

Report presenting the results of testing on a model of the D-558-1 in order to determine its pitching-moment, lift, and drag characteristics with no nose-inlet flow, and with the tail removed and at a constant setting. Only a limited analysis is provided.

The following report examines the fission counter, fission plates and activation results of the neutron energy distribution in the center of the Los Alamos plutonium reactor.

Report presenting measurements of downwash angles at points at two vertical positions at the probable tail location behind a high-aspect-ratio wing with an NACA 65-210 section with no sweep and 30 degrees and 45 degrees of sweepback and sweepforward in conjunction with a fuselage.

"It is shown how Schrenk's empirical method of estimating the lift distribution over straight wings can be adapted to swept wings by replacing the elliptical distribution by a new "ideal" distribution which varies with sweep.The application of the method is discussed in detail and several comparisons are made to show the agreement of the proposed method with more rigorous ones. It is shown how first-order compressibility corrections applicable to subcritical speeds may be included in this method" (p. 1).

Testing was conducting to evaluate the effects of support interference on the drag characteristics of two bodies of revolution at zero angle of attack at Mach number 1.5. Drag and base-pressure measurements are made for a variety of Reynolds numbers to determine the effect of varying the length or diameter of the rear support.

Description of the standards used by the electrical power industry for the measurement of the electrical quantities.

From Summary: "Wind-tunnel tests of a full-scale two-blade NACA 10-(10)(08)-03 (high camber) propeller have been made for a range of blade angles from 20 degrees to 55 degrees at airspeeds up to 500 miles per hour. The results of these tests have been compared with results from previous tests of the NACA 10-(3) (08)-03 (low camber) and NACA 10-(5)(08)-03 (medium camber) propellers to evaluate the effects of blade-section camber on propeller aerodynamic characteristics."

Report presenting testing of six flutter wings, two swept 45 degrees and four unswept, attached to three freely falling bodies. Flutter frequency and phasing were recorded.

Report presenting an investigation to study cowling-spinner combinations based on the NACA 1-series nose inlets and to obtain systemic data for one family of approximately ellipsoidal spinners. 11 of the spinners were also tested in various combinations with 9 NACA open-nose cowlings, which were also tested without spinners. Results regarding flow over spinners, internal flow, external flow over cowling, critical Mach number characteristics, envelope values, and cowling section are provided.

This report contains a selected list of Government sponsored research projects on related aircraft materials in effect during the calendar year 1947. Information is contained on titles, description, sponsoring and conducting agencies.

Report presenting a preliminary investigation of cone-type diffusers designed for minimum spillage at the inlet during operation in the supersonic tunnel at Mach number 1.85. Pressure recoveries of a series of stationary cones with included angles from 20 degrees to 60 degrees were investigated. Results regarding the pressure recovery with stationary cones and pressure recovery of movable-cone configurations are provided.

Report issued by the Bureau of Mines over the progress made in emergency mine communications. The results of testing done on low-frequency radio communication are presented. This report includes tables, graphs, illustrations, and photographs.

Contains derivations, based on a simplified theory, of approximate relations for low-speed stability derivatives of swept wings. Method accounts for the effects and, in most cases, taper ratio. Charts, based on the derived relations, are presented for the stability derivatives of untapered swept wings. Calculated values of the derivatives are compared with experimental results.

Note presenting an investigation to determine the yield strength, ultimate strength, ductility, and plastic stress-stain relations for 24S-T aluminum alloy when subjected to biaxial stresses. The data were interpreted by a generalized St. Venant theory in an attempt to predict the biaxial stress-strain relations in terms of the uniaxial tensile stress-strain relations. Stress-strain data were also obtained from flat control specimens cut from tubular specimens and compared with tension test data obtained from tubular specimens.

"By consideration of antisymmetrical, as well as symmetrical, buckling configurations, the theoretical shear buckling stresses of clamped rectangular flat plates are evaluated more correctly than in previous work. The results given, which represent the average of upper- and lower-limit solutions obtained b the Lagrangian multiplier method, are within 1 1/4 percen of true buckling stresses" (p. 1).