From abstract: "Electrical measurements have been made on CaB6, SrB6, BaB6, YB2, YB4, YB6, and YB12 for the purpose of testing models of the electronic structure of the boron atoms in the four boride types represented. The compounds CaB6, SrB6, and BaB6 were found to be semiconductors. The Hall coefficients of YB4 was also measured, but could not be interpreted because the free electron theory does not provide a theoretical value for comparison with experiment. The results are in agreement with the models proposed."

A reinforced-concrete steel-plate-lined vault and steel vault door were exposed to a nuclear detonation (shot Priscilla, about 37 kt, balloon suspended, at 700 ft) at the predicted 75-psi peak incident pressure level (1150 ft from Ground Zero). The vault was designed by the ultimate-strength theory to utilize the additional strain energy available in the elastoplastic and plastic ranges. Flexural and thrust capacities were determined, and shear capacity was computed. It was established that above-ground structures can be designed and constructed to survive the pressure levels experienced by this structure. The vault and door provided adequate blast and thermal protection for normal usage, and the structure was adequate to resist overturning and excessive sliding under conditions of the test.

From introduction: "This brief paper deals with the subject of radial temperature differences for heat transfer to fluids flowing through concentric annuli under the following conditions and assumptions: a. constant heat flux; b. fully-established turbulent flow; c. heat transfer through inner wall only; d. physical properties independent of temperature."

The remodeling, fabrication, and instrumentation of a high vacuum system are described. The faults encountered with the old system and their solution are outlined. Tests were made on diffusion pump oils and on the reduction of pump oil back diffusion. The measurement of high vacuum pressures by a cold cathode ionization gage at various points on a vacuum system are discussed.

Report discussing the effects of thermal diffusion length and certain details in the design of light water moderated reactors and their effect on reactivity.

The fission and spallation reactions caused in uranium by bombardment with high energy protons (340 to 350 Mev) were investigated. The reaction products were separated from the target by chemical processes and identified by their radioactive properties. The relative yields of the observed fission products were measured, and the results plotted as a function of mass number. Several of the spallation products were identified and their yields estimated.

Abstract: "The uranium content of badly contaminated uranium solutions may be determined quickly using visual comparison methods to an accuracy of [...]. This accuracy may be considerably improved by employing the fluorimeter herein described. Interfering ions and their removal using liquid-liquid extractions are considered."

Abstract: The procedures recommended for analysis in Department 190 Laboratories, in the Limits Control Laboratory, and in the Analytical Development Laboratories, of all process materials from the HCP cycle are presented in a stepwise manner. A description of the characteristics of each sample type along with a brief description of factors involved in the Analytical Quality Control program is included.

Methods of conversion of UF4 to U3O8 by fusion with ammonium oxalate dihydrate and other salts are described.