From Introduction: "The performance of several tail-pipe burners with fixed area exhaust nozzles is reported in references 1 to 4, and the performance of an NACA-designed tail-pipe burner with a variable-area exhaust nozzle is reported in reference 5. Operational characteristics of the tail-pipe burner are also discussed."

Through theoretical and analog results the effects of two nonlinear stability derivatives on the longitudinal motions of an aircraft have been investigated. Nonlinear functions of pitching-moment and lift coefficients with angle of attack were considered. Analog results of aircraft motions in response to step elevator deflections and to the action of the proportional control systems are presented. The occurrence of continuous hunting oscillations was predicted and demonstrated for the attitude stabilization system with proportional control for certain nonlinear pitching-moment variations and autopilot adjustments.

The purpose of this new series of reports is to present in roughly finished form the results of the various start-up experiments on the BNL reactor as soon as the analysis of the experimental data is completed.

"Time histories are presented of horizontal-tail loads, elevator loads, and deformations on a jet-powered bomber during abrupt pitching maneuvers at a pressure altitude of approximately 20,000 feet. The normal and pitching accelerations measured varied from -0.90b to 3.41g and from -0.73 to 0.80 radian per second per second (sic), respectively, with a Mach number variation of from 0.40 to o.75. The maximum horizontal-tail load measured was 17,250 pounds down. The maximum elevator load was 1900 pounds up. The stabilizer twisted a maximum of 0.76 degrees leading edge down at the tip. The greatest fuselage deflection at the tail was about 1.7 inches down" (p. 1).

Report presenting the longitudinal and lateral characteristics of a wing-fuselage combination with a wing with the leading edge swept back 63 degrees and cambered and twisted for a uniform load at lift coefficient 0.25 and Mach number 1.5. The investigation occurred over a range of sideslip angles. The results indicated that the longitudinal characteristics were essentially unaffected by Reynolds number or the sideslip angles investigated.

Report discussing an investigation of two transonic research airplane models at a range of Mach numbers and Reynolds numbers. The main difference between the models was the aspect ratio of the horizontal tail. Results regarding the stability, control, incremental horizontal-tail characteristics, downwash, horizontal-tail load, stability factors, and a tailless configuration are provided.

Report presenting testing of the rolling effectiveness and drag of half-delta wing-tip ailerons on rectangular and tapered wings sweptback 0 and 45 degrees for a range of Mach numbers. The rolling effectiveness was relatively uniform across the Mach number range and was lower at subsonic speeds and higher at supersonic speeds than the partial-span plain ailerons.

Report presenting testing of two NACA two-blade propellers at a range of blade angles and Mach numbers. The effect of compressibility and design section camber are presented for each propeller. The results indicated that if the outboard sections of a propeller are the thinnest, the design of the propellers should incorporate loading distribution that is concentrated in the tip sections.

Report presenting an investigation in the 4- by 4-foot supersonic tunnel to determine the static longitudinal stability and control characteristics of a supersonic aircraft configuration at a Mach number of 1.59. The model had a 40 degree sweptback tapered wing with 10-percent-thick circular-arc sections normal to the quarter-chord line.

Report presenting the results from several recent flights on the Northrop X-4 No. 2 airplane, including the longitudinal stability characteristics over a range of Mach numbers in straight and accelerated flight and the short-period longitudinal-oscillation characteristics.

"An investigation has been conducted in the Langley 20-foot free-spinning tunnel to determine the spin and recovery characteristics of a 0.057-scale model of the modified Chance Vought XF7U-1 airplane. The primary change in the design from that previously tested was a revision of the twin vertical tails. Tests were also made to determine the effect of installation of external wing tanks" (p. 1).

"The particular integrals of the second-order and third-order Prandtl-Busemann iteration equations for the flow of a compressible fluid are obtained by means of the method in which the complex conjugate variables are utilized as the independent variables of the analysis. The assumption is made that the Prandtl-Glauert solution of the linearized or first-order iteration equation for the two-dimensional flow of a compressible fluid is known. The forms of the particular integrals, derived for subsonic flow, are readily adapted to supersonic flows with only a change in sign of one of the parameters of the problem" (p. 909).

Report discussing study on recovery of nitric acid in the uranium recovery process. The behavior of chloride ions and tributyl phophate is noted, and the quality of recycled nitric acid was tested. Stainless steel in the nitric acid recovery system was evaluated for corrosion.

Report presenting a free-flight investigation of two rocket-powered model configurations to determine the damping in roll. The model had rectangular wings of 4.5 aspect ratio and were the same except for the airfoil sections. Results regarding rolling velocity and total-drag coefficient are provided.