Retrieval of 5-lb splits of -1/4 inch coal from designated 30-gallon drums was completed. Preparation and analysis of these samples for the second yearly quality evaluation is in progress. After consultation with the DOE Project Manager, two replacement samples were collected. These are the first of the series which will be stored in foil laminate bags. Both of these samples were placed in 30 gallon steel drums lined with polyethylene bags at the mine site. They were equipped with lid gaskets made from Tygon tubing, and 1/4 in. metal tubing fittings to purge and pressurize the drum with argon.

This summary presents the data accumulated to date with only brief comment. It is prepared with the intent that the viewers will offer advice on terminology, data presentation, methods and other. The year end analysis will detail changes in the data due to the tillage treatments. The data is incomplete due to equipment problems and time limitations due to the wet fall and early freeze up. The trial was not completed due to our inability to get the Mikkelsen Chisel Plow Shovel (MCP), a 16 inch sweep with an anhydrous knife, to penetrate untilled land. The MCP shovel penetrated to deep on plowed ground and pulled so hard that the front wheels of our JD4440 tractor were jerked off the ground. The Standard Chisel Plow Shovels (SCP), a 16 inch sweep, worked well and the data is included.

The objective of this project is to evaluate and demonstrate a cost effective emission control technology for acid rain precursors, oxides of nitrogen (NO{sub x}) and sulfur (SO{sub x}), on two coal fired utility boilers in Illinois. The units selected are representative of pre-NSPS design practices: tangential and cyclone fired. Work on a third unit, wall fired, is on hold'' because of funding limitations. The specific objectives are to demonstrate reductions of 60 percent in NO{sub x} and 50 percent in SO{sub x} emissions, by a combination of two developed technologies, gas reburning (GR) and sorbent injection (SI). With GR, about 80{endash}85 percent of the coal fuel is fired in the primary combustion zone. The balance of the fuel is added downstream as natural gas to create a slightly fuel rich environment in which NO{sub x} is converted to N{sub 2}. The combustion process is completed by overfire air addition. SO{sub x} emissions are reduced by injecting dry sorbents (usually calcium based) into the upper furnace. The sorbents trap SO{sub x} as solid sulfates that are collected in the particulate control device.

The objective of proposed research is development of catalysts with enhanced slurry phase activity and better selectivity to fuel range products, through a more detailed understanding and systematic studies of the effects of pretreatment procedures and promoters/binders (silica) on catalyst performance.

In a previous paper we developed a simple model describing the far-field from a video-pulse source near the ground and for grazing incidence. We report here on a recent field test in which we attempted to verify the model. Our results show quantitative agreement with the model for most of the tested parameter space. We have also extended our model to include all elevation angles, including up to vertical. The computed engagement envelope shows three distinct regions: At grazing angles the field is small and diminishes to near zero at the earth's surface; at low-to moderate angles strong lobing occurs; at high angles the video-pulse field approaches its free-space form. 6 refs., 16 figs.

In this project we well evaluate the performance of Sel-Gel alumina membranes in coal liquid upgrading processes under realistic temperature and pressure conditions and investigate the feasibility of using such membranes in a membrane reactor based coal liquid upgrading process. In addition, the development of novel ceramic membranes with enhanced catalytic activity for coal-liquid upgrading applications, such as carbon-coated alumina membranes, will be also investigated. (VC)

Ceramic membranes are a new class of materials, which have shown promise in a variety of industrial applications. Their mechanical and chemical stability coupled with a wide range of operating temperatures and pressures make them suitable for environments found in coal liquid upgrading. In this project we will evaluate the performance of Sel-Gel alumina membranes in coal liquid upgrading processes under realistic temperature and pressure conditions and investigate the feasibility of using such membranes in a membrane reactor based coal liquid upgrading process. In addition, the development of novel ceramic membranes with enhanced catalytic activity for coal-liquid upgrading applications, such as carbon-coated alumina membranes, will also be investigated.

It is shown that hollow cathode discharges can operate in a mode characterized by a two-component electron energy distribution: bulk electrons with a thermal distribution with a temperature of a few electron volts, and a component of fast electrons with an energy of about 30 eV and a thermal spread of about 0.1 eV. Measurements of both parallel and perpendicular energy spreads confirm the existence of fast, low energy spread electrons. Selective extraction of these electrons can form the basis of a high current, high brightness electron gun which could be well suited for EBIS applications. 8 refs., 4 figs., 1 tab.

Ceramic membranes are a new class of materials, which have shown promise in a variety of industrial applications. Their mechanical and chemical stability coupled with a wide range of operating temperatures and pressures make them suitable for environments found in coal liquid upgrading. In this project we will evaluate the performance of Sel-Gel alumina membranes in coal liquid upgrading processes under realistic temperature and pressure conditions and investigate the feasibility of using such membranes in a membrane reactor based coal liquid upgrading process. In addition, the development of novel ceramic membranes with enhanced catalytic activity for coal-liquid upgrading applications, such as carbon-coated alumina membranes, will be also investigated.

This document describes the method developed by Sandia National Laboratories (SNL) to evaluate transducer used in the design certification testing of nuclear material shipping packages. This testing project was performed by SNL for the Office of Civilian Radioactive Waste Management (OCRWM). This evaluation is based on the results of tests conducted to measure ruggedness, failure frequency, repeatability, and manufacturers' calibration data under both field and laboratory conditions. The results of these tests are provided and discussed. The transducer were selected for testing by surveying cask contractors and testing facilities. Important insights relating to operational characteristics of accelerometer types were gained during field testing. 11 refs., 105 figs., 16 tabs.

Ceramic membranes are a new class of materials, which have shown promise in a variety of industrial applications. Their mechanical and chemical stability coupled with a wide range of operating temperatures and pressures make them suitable for environments found in coal liquid upgrading. In this project we will evaluate the performance of Sel-Gel alumina membranes in coal liquid upgrading processes under realistic temperature and pressure conditions and investigate the feasibility of using such membranes in a membrane reactor based coal liquid upgrading process. In addition, the development of novel ceramic membranes with enhanced catalytic activity for coal-liquid upgrading applications, such as carbon-coated alumina membranes, will be also investigated.

The objective of this contract is to extend and optimize UOP's single-stage, slurry-catalyzed co-processing scheme. The particular emphasis is one evaluating alternative and disposable slurry-catalyst systems. During the current quarter, Lloydminster vacuum resid was processed without the presence of coal. The objective of this study was to evaluate the manner in which the resid is upgraded at high-severity conditions to help understand the function of the resid during co-processing. This report coves Bench-Scale Runs 30 to 34. In Runs 30 to 34, Lloydminster vacuum resid was processed without the presence of coal using a 0.05 wt % molybdenum-based catalyst at 465{degrees}C.

This current project is pilot-scale testing of NO{sub x} recycle. The objective is to provide further fundamental understanding and useful information for its implementation at the Niles station. A Babcock Wilcox's 6 million Btu/hr Small Boiler Simulator (SBS) has been chosen to perform the tests. The SBS is the same type of cyclone furnace as that at Niles and simulates a large cyclone unit very well. The project involves conducting a series of tests which include injecting NO, NO{sub 2}, N{sub 2}O, and simulated NO{sub x} recycle stream respectively. The work performed during this reporting period focused on the site preparation, shakedown tests, and baseline tests. The shakedown testing of NO injection into the primary air stream alone and the secondary air stream alone showed promising results. A large amount of NO injected into furnace was destroyed, especially when the NO was injected into the primary air duct. However, the measuring instrumentation needs to be improved to give accurate data.

Mobile agent technology facilitates intelligent operation insoftware systems with less human interaction. Major challenge todeployment of mobile agents include secure transmission of agents andpreventing unauthorized access to resources between interacting systems,as either hosts, or agents, or both can act maliciously. The Anchortoolkit, designed by LBNL, handles the transmission and secure managementof mobile agents in a heterogeneous distributed computing environment. Itprovides users with the option of incorporating their security managers.This paper concentrates on the architecture, features, access control anddeployment of Anchor toolkit. Application of this toolkit in a securedistributed CVS environment is discussed as a case study.

None

An investigation was done to determine the maximum credible event value for samples of explosives and disassembled components up to 1.2 g when stored in conductive plastic vials as packaged and handled, stored, or transported at Mound. The test was performed at Test Firing, with photographs taken before and after the test. The standard propagation test setup was used; a vial containing 1.2 g of PETN (pentaerythritol tetranitrate) was surrounded by other like vials containing 1.2-g samples of PETN. The 1.2-g PETN pellet was then ignited by an EX-12 detonator. The test showed that there was no propagation and that the maximum credible event value for the handling tray is 1.2 g. The test also showed that when the tray is placed in a metal container the MCE value will still be 1.2 g. 9 figs.

The overall objective of this program is to develop the engine and lubricant system design approach that has the highest probability for commercial acceptance. Several specific objectives can also be identified. These objectives include: definition of the dominant wear mechanisms prevailing in coal-fueled diesel engines; definition of the specific effect of each coal-related lube oil contaminant; determination of the potential of traditional engine lubrication design approaches to either solve or mitigate the effects of the coal related lube oil contaminants; evaluation of several different design approaches aimed specifically at preventing lube oil contamination or preventing damage due to lube oil contamination; and presentation of the engine/lubricant system design determined to have the most potential. 2 figs., 3 tabs.

We have made striking and considerable progress in our AGS program which is searching for a Quark-Gluon Plasma or other new phenomena at the AGS. We are employing a TCP Tracking Magnetic Spectrometer that has handled up to {approx}100 tracks, the maximum observed in 14.5 GeV/c {times} A Si ions incident on Au and Cu. In essence the TPC covers more than the forward half hemisphere in the nucleon-nucleon cms (i.e. {ge} 2{pi}) and thus allows tracking, momentum and angular analysis of the charged particles emitted in these heavy ion collisions. Particle identification for negative pions can be made approximately by assuming negative particles are pions. Then by subtraction of negatives from positives in a suitable manner the proton characteristics can be determined. {Lambda} and K{sub s}{sup 0} V particles have been identified singly in events and {approx}50 double {Lambda} and 2 triple {Lambda} events have been observed in the relatively small data sample we have obtained and analyzed this year. Further discussion of these topics are contained in this report.

This report discusses research done in string field theory; bosonic technicolor; and supersymmetry. (LSP)

The role of weak interactions, particularly electron capture and {beta}{sup {minus}} decay, in presupernova evolution is discussed. The present uncertainty in these rates is examined and the possibility of improving the situation is addressed. 12 refs., 4 figs.

This project is a part of the continuing Smolt Monitoring Program (SMP) to monitor Columbia Basin salmonid stocks coordinated by the Fish Passage Center (FPC). The SMP provides timely data to the Fish Passage Managers for in season flow and spill management for fish passage and post-season analysis by the FPC for travel time, relative magnitude and timing of the smolt migration. Sampling sites were McNary, John Day and Bonneville Dams under the SMP, and the Dalles Dam under the Fish Spill Memorandum of Agreement'' for 1989. All pertinent fish capture, condition and brand data, as well as dam operations and river flow data were incorporated into the FPC Fish Passage Data Information System (FPDIS). 15 refs., 6 figs., 6 tabs.

We show that the size of the hard gluonic contribution to the first moment of the proton's spin-dependent structure function g{sub 1} is entirely a matter of the convention used in defining the quark distributions. If the UV regulator for the spin-dependent quark distributions respects the gauge invariance of Green's functions (allows shifts of loop momenta) and respects the analyticity structure of the unregulated distributions, then the hard gluonic contribution to the first moment of g{sub 1} vanishes. This is the case, for example, in dimensional regularization. By relaxing the requirement that the regulator allow shifts of loop moments, we are able to obtain a nonvanishing hard gluonic contribution to the first moment of g{sub 1}. However, the first moments of the resulting quark distributions correspond to matrix elements that are either gauge variant or involve nonlocal operators and, hence, have no analogue in the standard operator-product expansion. 11 refs., 2 figs.

Two controllers are developed to provide attitude control of a spinning rocket that has a thrust vectoring capability. The first controller has a single-input/single-output design that ignores the gyroscopic coupling between the control channels. The second controller has a multi-input/multi-output structure that is specifically intended to account for the gyroscopic coupling effects. A performance comparison between the two approached is conducted for a range of roll rates. Each controller is tested for the ability to track step commands, and for the amount of coupling impurity. Both controllers are developed via a linear-quadratic-regulator synthesis procedure, which is motivated by the multi-input/multi-output nature of second controller. Time responses and a singular value analysis are used to evaluate controller performance. This paper describes the development and comparison of two controllers that are designed to provide attitude control of a spinning rocket that is equipped with thrust vector control. 12 refs., 13 figs., 2 tabs.

MAssive Compact Halo Objects such as brown dwarfs, Jupiters, and black holes are prime candidates to comprise the dark halo of our galaxy. Paczynski noted that these objects (dubbed MACHOs) can be detected via gravitational microlensing of stars in the Magellanic Clouds with the caveat that only about one in 10{sup 6} stars will be lensed at any given time. Our group is currently involved in constructing a dedicated observing system at the Mount Stromlo Observatory in Australia. We will use a refurbished 1.27 meter telescope and an innovative two-color CCD camera with 3.4 {times} 10{sup 7} pixels to monitor 10{sup 6} {minus} 10{sup 7} stars in the Magellanic Clouds. During the first year of operation (1991--1992), we hope to detect (or rule out) objects in the mass range 0.001M{sub {circle dot}} {le} M {le} 0.1M{sub {circle dot}}, and after five years, we hope to have covered the range 10{sup {minus}6}M{sub {circle dot}} < M {approx lt} 100M{sub {circle dot}}. 4 refs.