From Introduction: "This paper, which should be of interest to those concerned with transonic wind tunnels, covers the design and operating characteristics of the nozzle."

This report presents a description of the rules, history and new technical innovations in the Deutsch de la Meurthe Cup race of 1934.

With some airplanes the approach to the stall is accompanied by changes in the behavior, such as tail buffeting or changes in the control characteristics of the airplane so that the pilot obtains a warning of the impending stall. Vith other airplanes it is possible to approach the stall without any perceptible warning other than the reading of the air-speed meter, in which case the danger of inadvertent stalling is considerably greater. Although it is not within the scope of this paper to discuss stalling characteristics, it is desired to point out that in general the danger of inadvertent stalling is greatest with those airplanes that behave worse when the stalling occurs; that is, with airplanes in which the stall starts at the wing tips. A warning of the impending stall is desirable in any case, but is particularly desirable with airplanes of the latter type.

"In connection with the application of stable tricycle-type landing gears to transport airplanes, the question arises as to whether certain passengers may not experience relatively great accelerations in an emergency landing. Since the main landing wheels are behind the center of gravity in this type of gear, a hard-braked landing will cause immediate nosing down of the airplane and, when this motion is stopped due to the front wheel striking the ground, there will be some tendency for the rearmost passengers to be thrown out of their seats, The provided rough calculations are designed to show the magnitudes of the various reactions experienced in a severe landing under these circumstances" (p. 1).

From Introduction: "A study of crash-impact survival in light airplanes is reported in references 1 and 2. A similar study for fighter airplanes is reported in reference 3. This report discusses crash-impact survival in transport airplanes."

From Introduction: "This report presents a computational procedure which provides for the rapid and accurate calculation of any streamline in a series of special flows. Detailed information is given on the boundary conditions and equations used for computing the characteristic nets and stream function."

Report discussing theoretical basis of the acoustics of a moving nonhomogeneous medium. Experiments that illustrate or confirm some of the theoretical explanation or derivation of these acoustics are also included.

From Introduction: "The purpose of this report is to summarize, without extended proofs, the results of a study of a simplified model of nonadiabiatic, compressible fluid flow, both subsonic and supersonic, and to state these results in a form that will make them immediately useful in providing a theoretical background for current technical problems of high-speed combustion.

Memorandum presenting an experimental study of the effects of several variations in configuration geometry on the aerodynamic characteristics of flat-top wing-body combinations. Generally, the configurations consist of one half of a body of revolution mounted beneath a wing of essentially arrow plan form. Results regarding the effect of trailing-edge sweep, effect of the addition of auxiliary bodies, effect of tip-flap deflection, effect of dihedral, effect of leading-edge sweep, effect of fuselage fineness ratio, effect of fuselage profile shape, and static longitudinal stability characteristics are provided.

The adhesive and protective characteristics of National Bureau of Standards Coating A-417 were investigated, as well as the effect of the coating on the life of forged Refractaloy 26 and cast Stellite 21 turbine blades. Coated and uncoated blades were run in a full-scale J33-9 engine and were subjected to simulated service operations consisting of consecutive 20-minute cycles (15 min at rated speed and approximately 5 min at idle). The ceramic coating adhered well to Refractaloy 26 and Stellite 21 turbine blades operated at 1500 degrees F. The coating also prevented corrosion of the Refractaloy 26, a corrosion-sensitive nickel-base alloy, and of the Stellite 21, a relatively corrosion-resistant cobalt-base alloy. Although the coating prevented corrosion of both alloys, it had no apparent effect on blade life.

Report discussing the origin of air traffic dates from the war. The important development of aeronautic industries and the progress made in recent years, under the impelling force of circumstances, rendered it possible, after the close of hostilities, to consider the practical utilization of this new means of economic expansion.

Report discussing model tests prove the feasibility of enhancing the aerodynamic qualities of wing-fuselage fillets by appropriate design of fuselage and wing roots. Abrupt changes from maximum fuselage height to wing chord must be avoided and every longitudinal section of fuselage and wing roots must be so faired and arranged as to preserve the original lift distribution of the continuous wing. Adapting the fuselage to the curvilinear circulation of the wing affords further improvement. The polars of such arrangements are almost the same as those of the "wing alone," thus voiding the superiority of the high-wing type airplane known with conventional design.

"Tests of two 10-foot-diameter two-blade propellers which differed only in shank design have been made in the Langley 16-foot high-speed tunnel. The propellers are designated by their blade design numbers, NACA 10-(5)(08)-03, which had aerodynamically efficient airfoil shank sections, and NACA 10-(5)(08)-03R which had thick cylindrical shank sections typical of conventional blades. The propellers mere tested on a 2000-horsepower dynamometer through a range of blade-angles from 20 degrees to 55 degrees at various rotational speeds and at airspeeds up to 496 miles per hour" (p. 1).

From Introduction: "Presented in this paper are the results of an investigation of a semispan model of a delta wing with 60^o sweepback at the leading edge which was equipped with a large triangular control having an overhang balance mounted on a skewed hinge axis. The purpose of this investigation was to determine the aerodynamic characteristics of a delta wing with a control which was designed to provide aerodynamic balance at zero control deflection based on the span load distribution of reference 1."

From Introduction: "The wings were tested in combination with fuselage similar to the one used in the 7- by 10-foot wind-tunnel investigations. The results are reported herein and are compared with results for three similar model wings on the transonic bump (references 1, 2, and 3)."

Report discussing testing of a scale model of the Convair F-102B to determine its aerodynamic characteristics at several Mach numbers. Four basic body modifications and two afterbody configurations were evaluated.The body modifications were all found to slightly reduce values of minimum drag, but did not cause a change in the static stability and lift-curve-slope values compared to the F-102A.

From Introduction: "The results of two phases of this investigation, presented in references 1 and 2, have indicated possible ways of reducing hull drag without causing large changes in aerodynamic stability and hydrodynamic performance."

Report discussing a particular wing-body combination that is part of a larger investigation to determine the lift, drag, pitching moment, and root bending moments for various configurations. Information about the aerodynamic characteristics at the tail plane is also provided.

From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuselage configurations employing a wing with the quarter-chord line swept back 60^o, aspect ratio 2, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the free stream."

From Introduction: "The present report gives all the results, including those published in reference 1 and the results of previously un-published tests tests of the airfoils at positive angles of attack."

From Introduction: "The investigation was intended to cover the characteristics of individual cups and of similar cups mounted on complete cup wheals. This report treats the static tests run on the individual cups."

"The purpose of the present work is to extend the previous investigation and to derive additional airfoil sections designed to minimize the undesirable characteristics of the previously tested airfoils. The tests of these additional airfoils were made in the Langley two-dimensional low-turbulence tunnel (LTT)" (p. 2).

From Summary: "This report contains the lift, drag, and moment characteristics of tapered Clark Y, Gottingen 393, and USA 45 airfoils as obtained from tests made in the Variable Density Wind Tunnel of the NACA. The results are given at both low and high Reynolds Numbers to show scale effect and to provide data for use in airplane design."

From Introduction: "The purpose of this paper is to discuss and evaluate some of the input signals or control parameters which have been experimentally employed to operate turbojet inlet-control systems. These include the normal-shock position, the oblique-shock position, and the diffuser-exit Mach number. The discussion is based on results obtained at the NACA Lewis laboratory during control investigations of ram-jet engines (ref. 1 to 5) and during a study on the control of a supersonic inlet for the J34 turbojet engine (refs 6 and 7)."