Groundwater monitoring is an important technical requirement in managing hazardous waste disposal facilities. The purpose of monitoring is to assess whether and how a disposal facility is affecting the underlying groundwater system. This paper focuses on the regulatory and technical aspects of the design, placement, and sampling of groundwater monitoring wells for hazardous waste disposal facilities. Such facilities include surface impoundments, landfills, waste piles, and land treatment facilities. 8 refs., 4 figs.

Over the past few years several proposals have been prepared to investigate the potential hazard of ferrocyanide-nitrate reactions that may occur in some Hanford waste tanks. In 1988 Westinghouse Hanford Company (WHC) decided to perform some of the suggested experimental work. Based on the proposal submitted in July, 1988, it was agreed to do a portion of the work during FY 1988. This report summarizes the results of that work, provides a preliminary analysis of the results, and includes recommendations for further study. The work completed consists of a brief literature search, preparation and analysis of several cesium nickel ferrocyanide, Cs{sub 2}NiFe(CN){sub 6}, oxdiation studies using Differential Scanning Calorimetry (DSC) and Thermogravimetry (TG), and small scale explosion tests.

Forty-two ..beta..-delayed proton precursors with 56less than or equal toZless than or equal to71 and 63less than or equal toNless than or equal to83 were produced in heavy-ion reactions at the Lawrence Berkeley Laboratory SuperHILAC and their radioactive decay properties studied at the on-line mass separation facility OASIS. Twenty-five isotopes and eight delayed proton branches were identified for the first time. Delayed proton energy spectra and proton coincident ..gamma..-ray and x-ray spectra were measured for all precursors. In a few cases, proton branching ratios were also determined. The precursor mass numbers were determined by the separator, while the proton coincident x-ray energies provided unambiguous Z identifications. The proton coincident ..gamma..-ray intensities were used to extract final state branching ratios. Proton emission from ground and isomeric states was observed in many cases. The majority of the delayed proton spectra exhibited the smooth bell-shaped distribution expected for heavy mass precursors. The experimental results were compared to statistical model calculations using standard parameter sets. Calculations using Nilsson model/RPA ..beta..-strength functions were found to reproduce the spectral shapes and branching ratios better than calculations using either constant or gross theory ..beta..-strength functions. Precursor half-life predictions from the Nilsson model/RPA ..beta..-strength functions were also in …

There are two major sections to this report. The first section of the report is an executive summary of the work done this year. For each task, the major results are condensed for the reader's convenience. The major result of each memo, report or presentation is summarized briefly in this section. The second section of the report is a collection of appendices containing reports, memos, and presentations written this year. Here, the interested reader can investigate any topic discussed in the summary in more detail. The documentation is presented in chronological order, and we would like to note that the content of later documents may supercede that of earlier ones. The summaries are divided into sections, corresponding to the tasks outlined in the original proposal for the work. These sections are: MUMAK code development and application; Alfven wave stability problem; TETRA systems code development and application; lower hybrid heating and current drive; and advanced blanket modeling.

A tutorial presentation is given of Raman scattering in crystals. The physical concepts are emphasized rather than the detailed mathematical formalism. Starting with an introduction to the concepts of phonons and conservation laws, the effects of photon-phonon interactions are presented. This interaction concept is shown for a simple cubic crystal and is extended to a uniaxial crystal. The correlation table method is used for determining the number and symmetry of the Raman active modes. Finally, examples are given to illustrate the relative ease of using this group theoretical method and the predictions are compared with measured Raman spectra. 37 refs., 17 figs., 6 tabs.

Small angle diffractometers at pulsed sources need to have fairly short flight paths if they are to make use of the long-wavelength portion of the spectrum without encountering problems from frame overlap or sacrificing intensity with band-limiting or pulse-removing choppers. With such short flight paths, achieving the necessary angular collimation in the incident beam while utilizing the full source size (/approximately/10 cm diameter) and a reasonable sample size (/approximately/1 cm diameter) requires the use of converging multiple-aperture collimation. If the collimation channels are all focused to the same point on the detector then the large sample size will not affect Q/sub min/ or the Q-resolution, even if the sample-to-detector distance is short. The Small Angle Diffractometer (SAD) at IPNS uses crossed converging soller collimators to provide focusing multiple-aperture collimation having /approximately/400 converging beam channels with essentially no ''dead'' space between them. This entire collimator system occupies a distance of only /approximately/60 cm along the incident flight path, while providing angular collimation of 0.003 radians FWHM. The dimensions for the SAD upstream collimator are L/sub c/ = 32.8 cm, d/sub 1/ = 0.974 mm, d/sub 2/ = 0.851 mm, while for the SAD downstream collimator L/sub c/ = 25.0 cm, d/sub …

Over the past few years several proposals have been prepared to investigate the potential hazard of ferrocyanide-nitrate reactions that may occur in some Hanford waste tanks. In 1988 Westinghouse Hanford Company (WHC) decided to perform some of the suggested experimental work. Based on the proposal submitted in July, 1988, it was agreed to do a portion of the work during FY 1988. This report summarizes the results of that work, provides a preliminary analysis of the results, and includes recommendations for further study. The work completed consists of a brief literature search, preparation and analysis of several cesium nickel ferrocyanide, Cs{sub 2}NiFe(CN){sub 6}, oxdiation studies using Differential Scanning Calorimetry (DSC) and Thermogravimetry (TG), and small scale explosion tests.

In order to observe the effects of rheology on the atomization of highly viscous non-Newtonian liquids, glycerin-water solutions and cellulose-glycerin-water solutions have been atomized. In this series of tests, nozzle pressure, air-liquid ratio and liquid viscosity were altered, and the effects were observed. 14 figs.

Relativistic electron beams are being generated with emittances low enough that diffraction radiation can be used for beam diagnostics. Techniques based on diffraction radiation can be used to measure the beam transverse momentum distribution and to measure the transverse spatial distribution. The radiation is intense and can be in the visible spectral region where optical diagnostic techniques can be used to maximum advantage. 4 refs. 3 figs.

This is a progress report on the first phase of a project to measure the economic impacts of a rapidly changing U.S. target base. The purpose of the first phase is to designate and test the macroeconomic impact analysis model. Criteria were established for a decision-support model. Additional criteria were defined for an interactive macroeconomic impact analysis model. After a review of several models, the Economic Impact Forecast System model of the U.S. Army Construction Research Laboratory was selected as the appropriate input-output tool that can address local and regional economic analysis. The model was applied to five test cases to demonstrate its utility and define possible revisions to meet project criteria. A plan for EIFS access was defined at three levels. Objectives and tasks for scenario refinement are proposed.