The mechanism whereby insulin lowers the blood glucose concentration is currently under extensive investigation. Despite the general agreement that the addition of insulin increases glucose uptake by various isolated tissues, the question has been raised whether administered insulin produces its blood sugar lowering effect in vivo primarily in increasing glucose uptake. Furthermore, it has been suggested that physiologically-released insulin may not exert the same effects as are produced by administered insulin. Attention has also been focused on whether insulin (exogenous or endogenous) exerts its action mainly or entirely on the liver and to what extent insulin influences glucose uptake and glucose production by the liver. The studies to be reported are a continuation of earlier work and are concerned with the effects of insulin, both exogenous and endogenous, on glucose utilization by the tissues and glucose production by the liver under various dietary condition in the unanethetized, intact dog, using C¹⁴ glucose.

The absolute differential cross sections for elastic scattering of 31-Mev He3 ions on Be, Al, Cu, Sn(nat), Sn120, and Bi have been measured in the angular range of approximately 10 to 120 deg in the center-of-mass system. Thin self-supporting foil targets were chosen to span the parameter A 1/3, where A is the target mass number. The first excited states of the isotopes of the above elements had sufficient energy separation from the ground state to enable elastic scattering to be resolved from inelastic scattering. The detection system, consisting of Cal(Tl) scintillation crystals, was capable of 3%pulse-height resolution and 1 degree angular resolution. Characteristically, the light-element angular distributions show strong diffraction effects. The differential cross section divided by the Rutherford cross section decreases exponentially at large angles for the heavy elements, and the differential cross sections break away from Rutherford behavior at angles which increase almost linearly with increase of atomic number of the target nucleus. A comparison of the results for natural tin, and tin enriched to 85% in Sn120, indicated that within the experimental uncertainties over the measured angular interval, there were no pronounced isotopic effects. The data are presented both in tabular and graphical form to allow …

One of the techniques by which highly ionized plasmas can be generated in the laboratory makes use of strong, electromagnetically driven shock waves propagating into a cold gas. In this paper the phenomenon is analyzed as a one-dimensional single-fluid hydromagnetic problem, neglecting dissipation behind the wave.

This is a preliminary report on the magnetic measurements taken to date on the AGS experimental magnets. It mainly summarizes the results which were necessary for the setting up of the proton separated beam in August 1961. A few curves on information obtained since then are included. When the study is finished, a complete report on all phases of the work, including the methods used, will be forthcoming.

This report covers the S-I-5-B-M fuel irradiation in the GETR Maritime Loop during the first quarter of fiscal year 1962. The data are summarized in Section II.

Use of that portion of the characteristic curve of photographic film in which transmission is linear with log exposure eliminates the distributional error and thus makes possible the assessment of total mass of an inhomogeneously distributed cell consistent without scanning or measuring the cell's projected area. Measurement consists of obtaining the difference in output of a photocell receiving the total light transmitted by a photomicrograph of the cell, and a photomicrograph of the microscope field illumination against which the cell was photographed. A method of making such measurements is given, and its basis is described.

The effect of temperature on the yield strength of the polycrystalline hexagonal Ag-Al intermetallic phase was investigated over the temperature range 77 to 775 K. It was found that the curve for yield stress vs temperature for both polycrystalline Ag-33 at .% Al specimens that were heavily cold worked prior to deformation and those that were recrystallized prior to deformation was parallel to that for prismatic slip in single crystals.

Description of a computer program which optimizes the locations and strengths of magnets for experimental beams at the Brookhaven AGS written for the IBM 7090 computer. Layout, method, and routines are given particular attention, and representative data cards are shown.

One of the techniques by which highly ionized plasmas can be generated in the laboratory makes use of strong, electromagnetically driven shock waves propagating into a cold gas. In this paper the phenomenon is analyzed as a one-dimensional single-fluid hydromagnetic problem, neglecting dissipation behind the wave. We hypothesize that the rarefaction wave remains attached to the front. In the limit of essentially complete ionization behind the front the problem can be solved analytically as long as the transverse magnetic field there remains small compared with the longitudinal field.

Antiproton-production and nucleon-interaction cross sections were investigated for antiprotons in the energy range 0.5 to 1.0 Bev. The antiprotons were distinguished from other particles produced at the Bevatron by a system of scintillation- and velocity-selecting Cerenkov counters. The excitation function and momentum distribution were recorded for antiproton production in carbon and compared with statistical model expectations.

A summary of the dynamic behavior of the proton bunches in the Brookhaven Alternating Gradient Synchrotron (AGS) has been given previously. In these reports, the usual linearization of the differential equations involved has been made and the theory was restricted to well bunched beams. The linearized approach is no longer valid at transition where the actual phase angle of the bunch can differ appreciably for a short time from the stable phase angle Φ₀. In this report the non-linearity of the differential equations for phase oscillations will no longer be neglected. At transition the beam is slow enough so that the electronics of the bootstrap system can be considered as being ideal and the radius servo loop can be characterized by one time constant. Under these assumptions the analysis can be carried out in a two-dimensional phase plane. The essential new result will be the short existence of a stable equilibrium point for the bunch motion not coinciding with Φ₀. The results here derived have been tested experimentally and at least a qualitative agreement was found. However, the conclusions are no more valid if debunching takes place since we have still neglected the finite bunch width.

The neutron-deficient yttrium isotopes Y82, Y83, and Y84 have been produced by irradiations with the Berkeley heavy-ion linear accelerator. Where possible, identifications were made by establishing genetic relationships with known daughter or granddaughter activities. The half-life of Y84 determined by direct decay is 39+-1 min. By a series of timed chemical separations, the following half-lives have been established: Y82, 9+-3 min; Y83, 8+-2 min. No information pertaining to the radiations emitted in the decay of three yttrium isotopes, other than Y84, has been obtained. The gamma-ray spectra of Y84 and Sr83 are shown.

Two types of apparatus are described for measuring the absorption spectra of metal-ammonia solutions with the Gary Model 14 Spectrophotometer. One apparatus was used for dilute solutions at -70'; the other was used for more concentrated solutions and had provision for holding the solutions at any temperature between their boiling points and -70'.

Beryllium is a favoured canning and/or moderating material in the proposed Australian High Temperature Gas Cooled Reactor. With carbon dioxide as the most likely coolant a detailed knowledge of the corrosion of beryllium in this gas is required. Two separate investigations have proceeded simultaneously. First the effect of the following variables was studied; surface preparation of the specimen, temperature (100—725ºC), pressure (0—280 p.s.i.g.), velocity, and impurity content of the gas. The influence of irradiation has not yet been studied. Autoclaves, thermobalances, and dynamic loops were used. The results were statistically analysed and kinetic data obtained. In all cases specimens with etched surfaces yielded approximately 25 — 30 per cent, greater weight gains than specimens with ground or polished surfaces. On extruded material no "breakaway" oxidation was encountered below 650ºC in commercially dry gas (< 20 p.p.m. moisture). The rate of attack was to some extent affected by the pressure of the gas. Breakaway was only observed in one series of specimens at 650ºC. In this particular case the gas pressure was 280 p.s.i.g. However, it seems that surface temperatures of beryllium cans made from extruded material should be maintained below 650ºC in a reactor system using the commercially pure carbon …

Technical report. From Abstract : "A number of similar eddy current instruments were developed to measure the thickness of Zircaloy over uranium metal in the range of 5 to 25 mils, Zircaloy over UO2 in the range of 20 to 40 mils, and the wall thickness of Zircaloy tubes in the range of 20 to 40 mils. The instruments were designed for use with hand-held probes or with feeder-mounted probes to measure the inside and outside cladding thickness of tubular elements and the wall thickness of Zircaloy sheaths. The instruments have a sensitivity of 3 microamps per mil change in Zircaloy thickness and an accuracy of +/- mil."

The power of nuclear track research emulsion as a fast neutron dosimeter is examined in the exposure of a human phantom to PuBe neutrons. Semiautomatic track scanning and high-speed data analysis obviate the major disadvantages of this dosimeter, and allow the following basic information to be obtained without a serious cost in time: the rulative proton recoil energy spectrum, the absolute differential proton track den sity spectrum, and the average proton recoil energy at various locations in the phantom. From this are calculated the total absorbed local tissue doze due is proton recoils, the local thermal neutron intensity, and that portion of the tissue doze due to thermal [formula] tracks.

A uniform intensity flat top spill-out cannot be obtained by manual control for two reasons: 1. The horizontal density of the internal beam of the Cosmotron is far from uniform. As a result, a manually controlled linear motion of the internal beam into a target will result in a non-uniform spill-out intensity. 2. Stability requirements of the Cosmotron magnet voltage are not easily met without feedback because of inherent component stability. The proposed servo system will sense the external beam intensity, and correct the magnet voltage to keep this intensity constant. This servo must operate through the transfer function of the main ignitron system and the flat top filter. Both of those transfer functions impose special problems.

From abstract: "In this report we present data obtained with the optical simulation apparatus on image quality as a function of the parameters of neutron scattering and image detector resolution...Also included in this report is a brief description of a large area (5 inch diameter) neutron beam exposure facility being set up at the reactor for the phase three work."

Technical report. From Abstract : "Irradiation of 'Dowex' 1, 'Permutit' S-1, and 'Permutit' SK anion exchange resins with alpha particles results in losses in ion exchange capacity and in 'apparent per cent crosslinkage'. The order of decreasing radiolytic stability for these properties in 'Permutit" SX > 'Permutit' S-1 > 'Dowex' 1."

From abstract: "Recently a general chemical method for the analysis of mixtures of alcohols appeared, using pyridine catalyzed acetylation and second order kinetics to determine the amount of the faster reacting component. The use of 0.25M isobutyric anhydride in pyridine containing 0.0025M perchloric acid as catalyst promotes the rate of the reaction and diminishes the time necessary to perform an analysis. A mathematical treatment of the data and kinetic plot reduces the number of kinetic points to only four or five. The mixtures are primarily composed of isomers."

Pechiney and Brush UOX BeO differ markedly in fabrication behaviour, only Brush UOX being readily sinterable. A comparative study of the two powders has shown few outstanding differences in powder properties. Both are of high purity but contain free and combined moisture to the extent of about 1.5 per cent. Pechiney BeO has a larger mean crystallite size (0.2 — 0.3μ) than Brush UOX (0.1 — 0.15μ) and a larger range of crystallite size, and both contain a small proportion of crystallites of size 1μ. and larger. The tap density of UOX is much lower than that of Pechiney, and its surface area is higher by a factor of two, UOX BeO can be hot—pressed or cold—pressed and sintered to high densities at temperatures of 1400º and 1500ºC respectively, which are approximately 300ºC lower than those required for Pechiney. Grain size of fabricated material increases with fabrication temperature in both grades, and at the same temperatures is larger for UOX than Pechiney. However, at comparable densities grain sizes are also comparable for the two materials, The bend strength at room temperature of hot—pressed Pechiney BeO reaches a maximum of approximately 30,000 p.s.i. when pressed at 1750ºC. Above this temperature the …

An investigation of the solvent extraction behavior of salicylato- beryllium complexes is reported. A simplified method for calculating the stability constants has been developed. The values obtained are beta /sub 1/ = 4.0 x 10/sup 12/ and beta /sub 2/ = 4 3 x 10/sup 22/ in 0.15 M sodium perchlorate. (auth)

This manual represents the recommendations of the Instrumentation and Controls Division committee on Electrical and Electronic Symbols and Drawing that have been issued to date. Section I consists of copies of the American Standards Association Graphical Symbols for Electrical Diagrams, with certain variations or additions that have been recommended by the Committee to clarify or more positively identify the device or element symbolized. Since publication of the present ASA standards, certain elements, such as the transistor, have come into common use. Committee and represent the symbols have been selected after considerable study by the Committee and represent the symbols that seem to be standard Reference Information series, Interim E--1.

This report analyzes two samples of Nevada alluvium to measure density and analyze the variety of particles in both samples.