A carrier containing 138.99 liters of solution, uranium concentration 202.04 g/liter with an isotopic concentration of 97.3% U-233, was prepared for shipment. The total uranium was 28,062 +/- 60 g (95% confidence level) and the U-233, 27,305 +/- 66 g (95% confidence level).

Sanderson & Porter have carried out a series of studies over the last four years which indicate that the pebble-bed reactor way be an attractive way to obtain low-cost power. At the request of the Atomic Energy Commission, two design studies have been carried out on this concept at the Oak Ridge National Laboratory. The first of these a preliminary design of a 10-Mw(t) reactor experiment, the PRRE, was initiated September 10, and a report on the study was issued November 1960. The second phase of the work, a conceptual design study of a 330-Mw (e) central station, was initiated November 1, and is the subject of this report.

From abstract: "Bis(di-n-hexylphosphinyl)methane, HDPM, [(C6H13)2P(O)]2CH2, has been studied as an extractant for a variety of metals. HDPM was evaluated as an extractant for uranium(VI) and compared with tri-n-octylphosphine oxide, TOPO, (C8H13)3PO. In nonpolar solvents, HDPM forms a polymeric-like substance with compounds of uranium(VI). Viscosity measurements indicate that the molecular weight of this polymeric-like substance is about 100 times greater than the corresponding complex with TOPO. Polymer formation occurs only when nonpolar solvents are used as diluents for HDPM and is easily avoided by using polar solvents such as 1,2-aichlorobenzene. HDPM forms 1:1 and 2:1 complexes with uranium(VI) nitrate. Equilibrium constants for these complexes as well as that for the 2:1 TOPO complex were calculated and it was shown that the over-all constant is at least ten times larger for the HDPM complex than for the TOPO complex. The effect of concentration of various mineral acids, extractant concentration, temperature, and diluents on the extraction of uranium are discussed."

The following report is one of a series of quarterly reports following the progress and development of improved zirconium alloys for service in superheated water and steam. This report covers the period between January 1 to March 31, 1961.

Quarterly report documenting progress on a project to determine an improved zirconium alloy for service in superheated water and steam. This report describes the results of approximately 75 compositions that were prepared prior, and presently are being arc-melted and fabricated into corrosion specimens, continuing the investigations of the effect of zirconium purity and heat treatment on corrosion and resistance.

This report follows a series of tests run to determine the shielding properties of beryllium oxide, conducted at the Battelle Lid-Tank Shielding Facility. Neutron and gamma penetrations through and behind beryllium oxide were measured.