Report discussing progress from May, 1960 through July, 1960 on a study of radiation synthesis involving halogenated compounds. Experimental procedures and data are included.

Report covering progress regarding a study on radiation synthesis involving halogenated compounds. Experimental progress, results and discussion are included.

From summary: The design of a spectrometer with the requisite improvement in crystals facilitates X-ray tube fluorescence.

Quarterly report discussing activities of the Maritime Gas-Cooled Reactor (MGCR) Program and the progress of the Program in developing a nuclear-powered marine propulsion system utilizing a high-temperature, gas-cooled nuclear reactor, close-cycle gas-turbine power plant.

Abstract. The region where exact thermodynamic description of the state of matter at high pressure and high temperature is possible is located. In the remaining region various approximate theories and empirical relations are discussed. These considerations are applied to hydrogen to locate the density and pressure at which the diatomic bond collapses. Also the approximate conditions are determined at which no bound electron states exist.

Report documenting the progress of the Army Gas-Cooled Reactor Systems Program to develop a mobile nuclear power plant for military field operation.

Introduction. The phase diagram data reported in this paper were obtained during an investigation of the beryllium-metal compounds of the titanium group transition elements. Several compounds in these systems had been previously reported but their compositions and structures were not all known. In the course of this study many details of the phase diagrams of the system were observed. Tentative diagrams consistent with this data will be presented.

The purpose of this experiment is to study the quantitative adsorption characteristics of a carbon adsorber bed receiving a radioactive inert gas in a helium stream. An objective of the experiment is to measure the equilibrium transmission of the radio-active gas through a carbon adsorber in order to determine if radio-active decay of the adsorbed gas permits additional adsorption.

Tests were conducted to determine the friction factor of randomly packed beds of 3/4-inch diameter spheres in 8-inch and 15-1/4-inch diameter beds, and of 1-1/2-inch diameter spheres in 15-1/4-inch diameter bed. The bed depths were varied in an attempt to isolate the effects of entrance and exit losses. The bed Reynolds number, base on sphere diameter, was varied from 5,000 to 50,000.

Previous studies have been made of the relationship among acceleration, specific power, payload fraction, and travel time for many interplanetary missions. These utilized tangential thrust and correspond to the high thrust Hohmann transfer orbits. In addition, a complete optimization of the one way Mars mission has been accomplished. Since the minimum Jupiter round trip time was six and a half years for tangential thrust, calculations were carried out using higher energy transfer orbits. It is shown that the orbit-matching problem cannot be solved with tangential thrust programming in this case. The initial period of acceleration away from the earth's orbit was accomplished using tangential thrust in order to minimize energy expenditure. This was followed by a period of coasting until the proper moment arrived for commencing the orbit-matching maneuver. This terminates when the velocity and spatial coordinates of Jupiter's orbit are matched. The technique used for accomplishing these various orbit matching conditions without iteration are described. Best results for the final maneuver were obtained with the thrust vector approximately normal to the velocity vector. By this technique it is shown that the round-trip Jupiter mission may be carried out in four and an half years with 16% payload and 0.10 …

The chief purpose of this contract is the development of ceramic materials with high dielectric constant and high dielectric strength values, and suitable for use of dielectrics in capacitors capable of storing large amounts of energy in small volumes. Work performed during the fifth quarter included (1) Material development and sample preparation; (2) Sample testing; (3) Optical studies of titanates; (4) Fabrication of large ceramics; and (5) Capacitor design.

The chief purpose of this contract is the development of ceramic materials with high dielectric constant and high dielectric strength values, and suitable for use of dielectrics in capacitors capable of storing large amounts of energy in small volumes. Work performed during the fourth quarter included (1) Material development and sample preparation; (2) Sample testing; (3) discussion of ceramic density measurements; (4) Optical studies of titanates; (5) Fabrication of large ceramics; and (6) Capacitor design.