The following report is based on work performed under the auspices of the U.S. Atomic Energy Commission. The purpose of this report is to describe an air-core strong focusing synchrotron and its functions.

Summary. At the time this project was initiated, all brazing had been confined to small retorts of ten cubic feet capacity or less. Larger assemblies were scheduled which required retorts of over 100 cubic feet capacity. Hydrogen atmospheres had given the best results, however, there was considerable reluctance to use hydrogen in these large retorts from a safety standpoint. It was thought that thru the use of PMC 2252, an argon - 2 1/2% hydrogen gas atmosphere which in non-explosive, sufficient cleaning action might be attoined without the inherent hazards encountered with hydrogen. An investigation of the argon - 2 1/2% hydrogen gas as a brazing atomosphoer

From abstract: This paper presents the results of a study of the error in radio interferometer measurements of near sources attributable to the use of asymptotic formulae, valid for distant targets.

Abstract: Design nomographs and equations have been prepared for determining the bending stresses and hoop stresses at the junction of a cylinder and sphere when: (1) Internal pressure exists in the sphere and (2) There is a difference in average temperature between the cylinder and the sphere. A correlation of calculated stresses and photoelastically determined stresses for models with internal pressure is presented.

Tests were conducted to determine methods of removing scale deposits from the HRT heat exchangers. A mockup of the heat exchanger header was cleared of a deposit of iron rust by reverse flushing at a flow rate below 75 gpm. A tube bundle consisting of 109 1/4in. O.D. x 0.049 in. wall tubes was plugged with rust. Approximately 80% of these tubes were unplugged by using a 70 psi water pressure differential in combination with vibration from a pneumatic rivet gun. No mechanical method was employed in the tests which could clear the remaining tubes.

In connection with the program of the measurement of eta for U233, several critical experiments have been performed by R. Gwin and D. W. Magnuson of ORML with light water solutions of uranyl nitrate (highly enriched in either U233 or U35) in an essentially bare sphere 27 inches in diameter. This report presents the results of two multigroup-diffusion-theory calculations for the above experiments performed by C. B. Mills and associated at Los Alamos. Assumer cross sections, material concentrations detailed neutron balances and a comparison with elementary theory are included. The agreement between the calculated and experimental multiplication constants is excellent for the multigroup calculation but only fair for the elementary calculation. The latter method overestimates the fast leakage so that the computed multiplication constant is less than that found experimentally.

This report is a comparative cost study of radioactive waste disposal for the Lawrence Radiation Laboratory (UCRL). In particular, it compares the costs of sea disposal in depths of 1000 fathoms and of 2000 fathoms off the California coast with land burial of the wastes at the Hanford Atomic Products Operation (HAPO), Richland, Washington, at the National Reactor Testing Station (NRTS), Idaho Falls, Idaho, or at the Nevada Test Site (NTS), Nevada. In the comparison, the cost of utilizing a commercial waste-disposal firm is also shown as well as a tentative cost of using the Military Sea Transport Service (MSTS).

Memorandum presenting the effects of wing modification and stability augmentation on the computed longitudinal behavior in the pitch-up region and probable pilot opinion of the pitch-up characteristics of two current fighter airplanes. An exploration of the addition of a wing-leading edge is included. Results regarding computed pitch-up behavior and probable pilot opinion are provided.

Fused uranium dioxide has desirable characteristics for fabricating high density nuclear fuel elements by swaging. Methods of preparing dense uranium dioxide particles being investigated at HAPO include are arc fusion, and sintering and crushing of low density powder. This paper reports the results of exploratory experiments to prepare fused uranium dioxide by induction heating of low density powder in graphite crucibles.

Several hollow uranium cores of "C" size I & E diameters were fabricated by cold extrusion (550 to 750 F) at Hunter Douglas Aluminum Corporation. Results show diameter control and reproducibility are excellent. Preferred orientation induced by this process is completely removed by a single standard beta heat treatment.

This report was written to describe briefly several possible variations of such systems along with probable cost estimates. Previous work has been shown that the application of scintillation detectors is the simplest and most reliable means for such monitoring. By proper detector selection and measuring methods, the system can be of an approximate gamma dose-rate with gamma energy independence above about 100 Kev. The same system using detector change only is directly applicable to beta, gamma, slow neutron and fast neutron detection. Any type of alarming device desired can be incorporated.

The Stack Effluent Radioisotope Monitor is an instrument which continuously measures and records the amounts of each of several different radioactive isotopes in the stack effluent of the Redox Facility. An informal report, HW-56151, describing the theory of operation and the circuits was prepared and is available to Hanford personnel from the technical files. The formal report, HW-56151 Rev, containing essentially the same information, is available from the Office of Technical Services, Department of Commerce, Washington 25, D. C.

Relatively long time cycles are required for the standard nitric acid dissolution of enriched uranium using safe batch size techniques for criticality control. Upwards of forty eight hours are required for the total dissolution of solid of I and E enriched slugs in nitric acid. The dissolution capacity may be increased by: (1) using a dissolver critically safe by virtue of its geometry or, (2)increasing the rate of uranium dissolution. Dilute agua regia -- a mixture of hydrochloric and nitric acids -- is known to dissolve uranium much more rapidly than nitric acid. This reports present a flowsheet for the rapid dissolution of uranium slugs in dilute agua regia.

Extraction systems involving chelating agents are widely used in radiochemical separations on a control basis due to the economy in time and equipment. In the case of waste streams, the element of interest is, by definition, at a very low concentration in the presence of gross fission product activities. The resultant large sample size necessary for a reliable analytical results creates a marked radiation hazard to laboratory personnel.

Property changes to common graphites resulting from reactor irradiation depends strongly on the temperature of exposure. Radiation affects at 30 C and 400 to 500 C are quite well known; however, at intermediate temperatures, results are not well known although a large volume of graphite in most reactors operate in this range. Production test, IP-22A, was reactivated, after a dormant period of many months, to study radiation damage between 30 and 400 C. This report concerns mainly the experimental details and evaluation of the equipment necessary for the controlled temperature irradiation.

The Atomic Energy Commission has assigned Hanford Atomic Products Operation the responsibility of reprocessing some of the slightly enriched uranium fuel elements from nuclear power reactors. Some stainless steel clad fuel elements contain sodium or a sodium-potassium alloy as a heat transfer medium between metallic core and outer sheath. The nature of the reaction between water and sodium is well known; however, the reaction between sodium and an oxidizing acid is more energetic and not so well known. The unknown factor of interest is the pressure generated by the reaction between the next transfer medium and the acid used for fuel dissolution prior to solvent extraction. The scouting studies discussed in this report were made to determine hydraulic pressures developed when sodium is exposed to cold concentrated nitric acid beneath the liquid surface.