8 Matching Results

Results open in a new window/tab.

Off-Site Animal Investigation Report : Second Annual Report (open access)

Off-Site Animal Investigation Report : Second Annual Report

Since the inauguration of the Off-Site Animal Investigation project n 1957, there has been one annual report rendered as of 30 June 1958. this is the second annual report dated as of 30 June 1959. The objectives of the project have been unchanged during the past year. These are (1) to enhance the Nevada Test Site/off-site rancher relationship through an active investigation project in their interests, and (2) to provide further information as to the status of the off-site animals in their environment, with special emphasis on their radioactive isotope uptake from fall-out. isotope uptake of the animals is being emphasized as well as the gross and microscopic histopathological examinations. Two year's existence in an area of radio-contamination where a full fission spectrum of isotopes can be found, where radiation background reading range from 1/2 mr per hour to 1 = per hour, has produced no noticeable effect on the animals.
Date: June 30, 1959
Creator: Farmer, Garland F.
System: The UNT Digital Library
Determination of Flux Levels in Neutron Detector Wells. Section II. First Performance. Core I, Seed 1. Test Results DL-S-242, T-641311 (open access)

Determination of Flux Levels in Neutron Detector Wells. Section II. First Performance. Core I, Seed 1. Test Results DL-S-242, T-641311

The purpose of the test was to determine the neutron flux level in a BF3 counter well during the second performance of DL-S-225. The measured activity of the irradiation brass bolt was due entirely to the radioactive decay of Zn65. The thermal neutron flux in the BF3 counter well during the second 1000 hour run was calculated to be 2.5 x 10(9) neutrons/cm2 sec.
Date: October 30, 1959
Creator: George, John R. & Cappola, M., Jr.
System: The UNT Digital Library
Loss of Level in D/P Cell Reference Chambers. Section I. First Performance. Core I, Seed 1. Test Results DL-S-279 (RNI-23) (open access)

Loss of Level in D/P Cell Reference Chambers. Section I. First Performance. Core I, Seed 1. Test Results DL-S-279 (RNI-23)

The purpose of the test is to determine the reason for the decreases in the liquid levels of the reference chambers serving the reactor plant remote liquid level indicators. The remote gages and the local liquid level gages agreed closely for the Reactor Plant Component Cooling Water Expansion Tank and the Coolant Discharge and Vent System flash tank and blow-off tank. There appeared to be no loss of water from the D/P cell reference chambers for these two systems over the period of the test. There was no definite indication of leakage from the Valve Operating System reference chamber, however, the differences between remote indicator readings and the sight glass readings are attributed to sticking of the ball check valve on the upper sight glass, inaccuracy of the readings and instrument error. It is recommended that he lower shut-off valve on the upper sight glass be cleaned and reopened prior to reading the sight glass to ensure that the ball check valve is not stuck in the closed position. No lead age was found in any of the level indicating systems.
Date: October 30, 1959
Creator: Gentry, George
System: The UNT Digital Library
Final Technical Report on Physics Research (open access)

Final Technical Report on Physics Research

Results are summarized on theoretical considerations of the excited states of the Ca isotopes, experimental studies of the level structure of Ca42 and Ca44, studies of the production of circularly polarized bremsstrahlung by beta rays, the Moller scattering spectrometer, and the Moller scattering coincidence experiment.
Date: November 30, 1959
Creator: McCullen, J. D.; Kraushaar, J. J.; Woolum, J. C.; Sandifer, C. W.; Kliwer, J. K.; Baker, D. et al.
System: The UNT Digital Library
Leveling of Extraction Tool Crane Rails. Section I. Second Performance. Core I, Seed 1. Test Results DL-S-246, FY-59-323 (open access)

Leveling of Extraction Tool Crane Rails. Section I. Second Performance. Core I, Seed 1. Test Results DL-S-246, FY-59-323

The purpose of the test was to check the extraction crane rails in the area of the reactor pit for level and parallelism. The west extraction crane rail exceeded the allowed tolerance of 1/32 inch at only one location. The elevation of the north bumper was out of tolerance by 1/64 inch. The east extraction crane rail was consistently lower than the west rail by as much as 8/64 inch. The east rail was parallel with the west rail within allowable tolerances over the length tested except at one location where the transit was located, approximately 41 feet from the north bumper.
Date: November 30, 1959
Creator: Pazuchanics, Nicholas
System: The UNT Digital Library
Periodic Radiation Survey. Section III. First Performance. Core I, Seed 1. Test Results DL-S-231, T-612394 (open access)

Periodic Radiation Survey. Section III. First Performance. Core I, Seed 1. Test Results DL-S-231, T-612394

The purpose of the test was to determine the radiation levels inside the concrete enclosures but outside the reactor plant containers after shutdown following plant power operation. Radiation levels at the survey points in the 1-AC and 10BD Boiler Chambers Enclosures and in the Reactor Container Enclosure indicated that no significant radiation hazards were present approximately 25 minutes after all rods had been inserted. The radiation levels approximately 4 minutes after shutdown at the survey points in the Auxiliary Chamber Enclosure indicated that several points were above background, the highest test level being obtained in contact with the East Auxiliary Chamber container drain pipe.
Date: November 30, 1959
Creator: Shramko, John, Jr.
System: The UNT Digital Library
Time Variation of Thermodynamic Parameters of a Gas in the Region of a Shock Front : Progress Report III (open access)

Time Variation of Thermodynamic Parameters of a Gas in the Region of a Shock Front : Progress Report III

The original goal of this investigation was to compare the thermodynamic characteristics of the gases in and behind the shock fronts in gases at initial pressures in the millimeter range and to compare these characteristics in the geometries of single and double discharges. The shock fronts were not visible, so it was not possible, at these pressures, to get visual data from the shock front itself. The parameters giving the properties of the gases were faces. Measurements made with an image converter camera (which is still in the development stage) agree well with these made with a photomultiplier tube. Differences are observed between the front velocities in the cases studied. These are of the order of 3 to 15 per cent. Considering the nature of the shot to shot fluctuations in the discharges and the inductance variation between the single and double discharges represent a physical difference. The mathematical treatment which says that two equal strength colliding with a wall behaves, has not been shown to be inadequate by this investigation. It was hoped that a stronger confirmation could be fien to the theory, but the accuracy of the data does not warrant it.
Date: November 30, 1959
Creator: Eastmond, E. John (Elbert John), 1915-; Hales, Richard Wayne, 1926-; Hoyt, G. D.; Baird, Ramon C.; Chowdhury, P. N. R. & Strong, William J
System: The UNT Digital Library
Corrosion of INOR-8 and Inconel Dissolver Components of the Fluoride-Volatility Process (open access)

Corrosion of INOR-8 and Inconel Dissolver Components of the Fluoride-Volatility Process

The corrosion of INOR-8 and Inconel dissolver components used in the fluoride volatility process for the dissolution of zirconium with anhydrous HF in molten salts was investigated. Ten dissolution runs were made using simulated subassemblies formed from Zircoloy-2. The dissolver and components were made from INOR-8. Both the dissolver vessel and draft tube were examined several times during the series of runs. The solids which formed at different areas in the system were also analyzed. The results showed that the corrosion of the INOR-8 dissolver was greatest at the salt-off gas interface and at the HF gas inlet. Almost all of the corrosion took place during run 10 when no zirconium was present. Portions of the dissolver were cleaned after run 10 and sent to BMI for evaluation. The results of the Battelle metallographic examinations of the portions are included along with several photographs. The results with Inconel tubes in the copper-lined hydro-fluorinator confirmed the observations that the liquid gas interface areas were the most susceptible to attack.
Date: December 30, 1959
Creator: Fink, Frederick W.
System: The UNT Digital Library