Removal of particles from air is discussed in terms of three classes of filtering media--air-sampling, respirator, and air-cleaning. Plots of efficiency versus filtering velocity are presented. The pressure drop characteristics of the filters are discussed in terms of initial pressure drops of the clean filters, variations in pressure drop of the individual filters, and comparison of loading rates.

The results of this investigation indicate that maximum electric power generation can be obtained by selecting the turbine steam temperature within a range of plus/minus 30 degrees C. from an "idealized" steam temperature. This "idealized" steam temperature is shown to depend primarily on the maximum permissible uranium temperature. The minimum available condenser temperature and the temperature rise of the coolant in the pile effect the selection of the turbine steam temperature to lesser extent.

This document is a sequel to HW-30226, "Steady State Temperature Distribution in a Solid Slug." A primary feature of the present as well as the former paper is a treatment of the stand heat flow equation in a manner which accounts accurately for the dependence of the thermal conductivity, K, on temperature, v.

Various non-linear calculations for heat conduction in an istropic, homogeneous medium are presented.

In 1949 Barad presented two solutions to the general diffusion equation. Basic in both solutions is the assumption that in very stable atmospheres a point source may be replaced by a vertical area of uniform concentration at a short distance downwind. This vertical area is considered to exist at the distance at which the plume finally "levels-off" and assumes a flat ribbon-like appearance. In addition if the distance over which diffusion takes place is limited to one or two miles and if only the stable atmosphere with its narrow range of eddy sizes is considered, the average diffusion co-efficient (K) has a signficance which it does not have in the case of neutral equilibrium.

Three types of stainless steel (309 SCB, Carpenter 20, 304-L) were exposed to both the liquid and vapor phase of each of three types of solutions. The time of exposure totaled ten days during which the specimens were cleaned and weighed periodically. The three synthetic D-12 waste solutions contained respectively chrome-high chloride, chrome-low chloride and high chloride sans chromium. The solutions were renewed at each weighing.

The preparation of radioactive metallurgical specimens for microscopic examination is one of the responsibilities of the Radiometallurgy Sub-Unit. An abrasive cut-off machine development program, based upon a previous experimental model, was undertaken to provide a method for sectioning of irradiated materials without undue personnel exposure or spread of contamination and finally to provide data for the design of an abrasive cutting unit for use in the work cells in the Radiometallurgy Building. A horizontal-feed type set-off machine, powered by a 7 1/2 hp motor with V-belt drive, has been developed for the submerged sectioning of irradiated uranium and is currently being used successfully to obtain samples for metallurgical, chemical and physical investigations without excessive personnel exposure or spread of radioactive contaminates.

In obtaining the results reported here a double focusing magnetic type spectrometer was used. Momentum spread was about 1%, and in most cases 2560 counts per point were taken. An end window Geiger tube was used as a detector. The window was of mica with areal density of 1.6 mg/cm2.

Laboratory studies have shown that the double salt, CaF2-PuF4, can be precipitated by rapid addition of hydro-fluoric acid to solutions containing 25 to 75 g Pu/1, caleium equimolar to plutonium, and 1 to 10 M HNO3. The precipitate, which is subsequently washed with water and dried to 300 degrees C in dehumidified, deoxygenated argon, can be reduced thermally by calcium to give high yields of plutonium metal.

Several improvements have been made in the gamma scintillation counter (GSC). The Model V gamma scintillation counter uses a canned thallium activated sodium iodide crystal as a detector. Although the electronic components remain unchanged, a modification of the sample support has been made to improve reproducibility of geometry. To assure comparable results between various counters, they must be operated at the same energy threshold and counting yield. Methods have been developed to assure operation at a preferred energy threshold of 0.1 Mev and an arbitrarily fixed counting yield of 3.36% for Cs-Ba-137. Partial pulse height discrimination against U 237 is also accomplished.

Summary: A method was found for determining calcium concentrations in TBP process streams in spite of serious interferences bysodium, ferrous, uranyl, sulfate, phosphate, and sulfamate ions as well as by TBP. The precision attainable varied from sample to sample, depending upon its composition. In general, errors of 20% or greater occurred. The smallest determinable amount of calcium was about 10 mg/1.

Some data on the temperature effect in pulse columns are reviewed. New data obtained with the "vibrational" stirrer are reported. The effects on both the dispersion and coalescence and the net rate of extraction suggest that improved operation of the RA column and lowered waste losses would be expected at elevated temperatures.

Abstract: "The valve-actuated pulse column is employed to give phase separation on each half cycle in the countercurrent flow cycle and provides independent control over each step in the cycle. The dependence on temperature of operation, on pulse frequency and amplitude, and on plate design and spacing has been studied for extraction and stripping of uranium with tributyl phosphate in a hydrocarbon diluent. It is found that the efficiency increases quite significantly as the temperature is raised regardless of the direction of transfer and this increased efficiency is accompanied by greater operational freedom. A decrease in hole size, decrease in plate separation and increase in frequency all lead to higher efficiency in agreement with the concept that small drops continually formed coalesced and reformed, lead to maximum interphase transfer. The high extraction efficiency of the column is probably aided further by the relatively sharp pulse produced."

Many factors are responsible for the rapid growth of analytical chemistry during the past ten to fifteen years. One of the most important of these factors is the greatly increased significance to present day chemistry of many elements that in the recent past were principally chemical curiosities. Since the Atomic Energy program is concerned with many such elements, it is of interest to discuss the cause for this concern and the resulting effect on the field of analytical chemistry. A number of pertinent analytical research problems at Hanford will be cited as examples.

Observations on sheep representing flocks in Utah adjacent to the Nevada Proving Ground were compared with findings made on experimental sheep exposed to various amounts of radioiodine. The Utah sheep showed no evidence of the radiation damage observed in experimentally treated sheep. Estimations of amounts of radioiodine on vegetation required to cause serious thyroid damage following a contamination event are included.

The approaches to the solution of the problem of removing or nullifying the effect of the hydrolysis of uranyl ion on acid titrations were: 1) use of a complexing agent and titration technique suitable for micro samples; 2) addition of a reagent that reacts with uranium to release 1 or 2 equivalents of acid per mole of uranium present (this permits correcting the titration value for the acid contributed by the uranium, or conversely permits an alkimetric titration of uranium); 3) separation of the uranium and acid with subsequent titration of the acid; and 4) direct titration of the sample with base. All these approaches yielded at least one method suitable for titrating acid in micro samples of uranium nitrate solutions.

The conventional volumetric micro-determination of phosphate depends upon the precipitation of phosphomolybdate, filtration and washing of the precipitate, and titration with standard base. The method is slow and tedious, subject to many interferences, and is not applicable to samples containing less than 1-2 mg of phosphate. Other weak acid anions, such as carbonate or acetate, interfere in the method. Strong acid anions, such as nitrate, sulfate, and chloride do not interfere.

The uranium recovery processes which are in operation or under construction at the present time--TBP, Redox and Purex--yield an aqueous uranyl nitrate solution as the recovered uranium product. For conversion of this recovered uranium to UF6 for feed to the gaseous diffusion plants, the uranyl nitrate in the solution is concentrated with or without prior organic stripping, calcined to UC3, reduced to UO2 with hydrogen, hydro-fluorinated to UF4 with RF, and finally fluorinated to UF6 with elemental fluorine.

Gamma scintillation monitor Model 3 is designed to continuously monitor and record the gamma activity of a process solution.

In connection with different seals for C & D equipment it appears advantageous that many parts could be made of rubber or other elastic polymers. However, data on the deterioration rate of these materials under irradiation are somewhat scant in the available literature. It appears that for neutrons and pure gamma radiation that a good grade of natural rubber stands up best in all the test reported and because the results of the neutron irradiation are so closely correlated with results from gamma it has been proposed that the principal source of damage is caused by secondary irradiation generated within the rubber by the neutrons.

The following document describes data collected from a 14-month period of analyzing crustaceans containing radioactivity. Provided is information based on the change of radioactivity through seasonal changes.

Plankton collected from the Columbia River by the net method and by the centrifuge method were compared. The centrifuged plankton (nannoplankton) exceeded the net plankton in weight, in abundance of organisms and in radioactivity. Similar seasonal trends were present in both types of plankton.

The construction and operation of a fission gas generator, containing about 25 grams of uranium in the form of a powder with a high specific surface, are described in detail. The purpose of the work discussed in this report was to examine the feasibility of producing, separating, and assaying samples of Xe135 in preparation for a proposed measurement of the neutron cross section of this isotope. Krypton and xenon are separated by selective adsorption on charcoal at reduced temperature while iodine is removed by charcoal sorption at room temperature.

For some time, the need has been recognized for an X-ray diffraction unit applicable to studies concerning the crystallographic characteristics of pile irradiated materials. Except for studies involving specimens of low activity, it has been impossible in the past to investigate materials which emit intense beta and gamma radiations. The exact type and degree of irradiation damage to high activity materials has been largely a matter of theoretical conjecture. The object of this report is to describe an X-ray diffraction spectrometer that can be used to collect crystallographic data from irradiated materials.