Report presenting the results of an investigation to determine the static longitudinal and lateral stability and control characteristics of a model of the Republic MX-1554 airplane at a specified Mach and Reynolds number. No analysis was provided in the paper in order to expedite publication.

Report discussing the procedures and experimental data of various plutonium waste recovery methods. The report elaborates on the different methods of collection necessary for different wastes.

Report presenting a concept for interrelating the wave drag of wing-body combinations at moderate supersonic speeds with axial distributions of cross-sectional area has been developed. Details of preliminary experiments meant to test the concept are also provided.

Memorandum presenting a procedure based on the transonic area rule, which has been used to design a four-nacelle delta-wing airplane configuration. A flight test of a model of the configuration showed a zero-lift transonic drag rise of 0.010 which, when compared with estimates, indicated the absence of adverse interference effects.

Report presenting a vibrational survey conducted during normal operation of a production eleven-stage axial-flow compressor powered as part of a complete turbojet engine. After serious third-stage vibration was detected, an investigation was conducted to study and eliminate the vibration with several component configurations. The vibrational source was determined to be an aerodynamic phenomenon related to a stall, but a new inlet-guide-vane assembly with a 4-percent increase in inlet area eliminated the vibration and increased the engine thrust 4 percent.

Report presenting flight measurements on a swept-wing jet aircraft to determine the effects of adding forward camber and an increased leading-edge radius on the low-speed stalling characteristics, the high-speed static longitudinal stability, and the airplane drag. The modified leading edge produced values of maximum lift somewhat greater than the slats on a normal airplane, but the stall was unacceptable because of an abrupt roll-off.

Report discussing a flight test of a four-nacelle delta-wing airplane configuration based on the transonic area rule in order to counteract the effects of high pressure drag at transonic and supersonic speeds. The testing verified that the transonic area rule can make designing complex aircraft with low transonic and supersonic pressure drag much easier.

Report presenting a series of survey tests of a transonic axial-flow compressor inlet stage to permit a detailed analysis of the flow across individual blade rows.

Report presenting an investigation of rotating stall and surge at low and intermediate speeds conducted on a 10-stage subsonic axial-flow research compressor. Fluctuations of rotating stall and surge were detected by hot-wire anemometers and pressure transducers. Results regarding overall performance and rotating stall, rotating stall and blade vibration, surge, and discussion of surge are provided.

Report presenting the results of an experimental investigation of three plane wings in combination with a body, which represented both low- and high-wing arrangements. The three wings had different plan forms: a tapered unswept plan form, a tapered 45 degree sweptback plan form, and a triangular plan form. Results regarding the effect of Reynolds number and effect of vertical position of the wing are provided.

Report presenting a study of seven additives in 0.5-volume-percent concentration for their effects on the low-pressure limits of flame propagation of propane-air mixtures. Limits were measured in a flame tube of new design. Results regarding propane-air mixtures, propane-air-additive mixtures, and flame propagation qualities are provided.

Report presenting the design and experimental performance of a turbine configuration designed to drive a high-speed, high specific-weight-flow supersonic compressor. Results regarding two configurations and their work output, design weight flow, and blade loading are provided.

From Summary: "An investigation of the characteristics of a full-scale supersonic-type propeller has been made in the Langley 16-foot transonic tunnel with the 6000-horsepower propeller dynamometer. The tests covered a range of blade angles from 20.2 degrees to 60.2 degrees at forward Mach numbers up to 0.96. The results showed that envelope efficiency at an advance ratio of 2.8 decreased from 86 percent to 72 percent when the forward Mach number was increased from 0.70 to 0.96."

In connection with different seals for C & D equipment it appears advantageous that many parts could be made of rubber or other elastic polymers. However, data on the deterioration rate of these materials under irradiation are somewhat scant in the available literature. It appears that for neutrons and pure gamma radiation that a good grade of natural rubber stands up best in all the test reported and because the results of the neutron irradiation are so closely correlated with results from gamma it has been proposed that the principal source of damage is caused by secondary irradiation generated within the rubber by the neutrons.

From introduction: "Report describing the study of radiation damage in boron carbide with an integrated thermal neutron flux of 3x10^20 neutrons/cm² in the Materials Testing Reactor (MTR)."

"The drag of bodies has now assumed greater importance because, as shown in NACA RM L53I15a, 1953 and NACA RM A53H18a, 1953, the transonic drag rise of an airplane can be the same as its equivalent body. Obviously, the airplane designer would like his airplane to have a low-drag equivalent body. This paper shows some of the factors which minimize the drag of bodies at transonic and supersonic speeds and shows some of the penalties caused by deviating from low-drag body shapes" (p. 1).

Preliminary results of one phase of a control-motion study program involving several jet fighter-type airplanes are presented in time-history form and are summarized as maximum measured quantities plotted against indicated airspeed. The results pertain to approximately 1,000 maneuvers performed by a Republic F-84G jet-fighter airplane during squadron operational training. The data include most tactical maneuvers of which the F-84G airplane is capable. Maneuvers were performed at pressure altitudes of 0 to 30,000 feet with indicated airspeeds ranging from the stalling speed to approximately 515 knots.

From Summary: "An investigation of the low-speed, power-off stability and control characteristics of a 1/10-scale model of the Convair YF-102 airplane has been made in the Langley free-flight tunnel. The model was flown over a lift-coefficient range from 0.5 to the stall in its basic configuration and with several modifications involving leading-edge slats and increases in vertical-tail size. Only relatively low-altitude conditions were simulated and no attempt was made to determine the effect of freeing the controls."

"Altitude performance of a YJ71-A-7 turbojet engine, with afterburner inoperative, was determined in the NACA Lewis altitude wind tunnel over a wide range of flight conditions. Engine speed and exhaust-nozzle area were controlled independently during this investigation. The variation of corrected values of air flow, net thrust, and fuel flow with corrected engine speed was not defined by a single curve with changes in altitude at given flight Mach number" (p. 1).

"An investigation has been made at high subsonic speeds of the aerodynamic characteristics in pitch and sideslip of a 1/l4-scale model of the Grumman XF10F airplane with a wing sweepback angle of 42.5. The longitudinal stability characteristics (with the horizontal tail fixed) indicate a pitch-up near the stall; however, this was somewhat alleviated by the addition of fins to the side of the fuselage below the horizontal tail. The original model configuration became directionally unstable for small sideslip angles at Mach numbers above 0.8; however, the instability was eliminated by several different modifications" (p. 1).

Photogeologic map of Stinking Spring Creek-15 quadrangle, Emery County, Utah

Report of progress on the metabolic properties of various materials, biological studies of radiation effects, health chemistry and physics.

At high excitation energies, competition of proton and c-particle emission with neutron emission becomes important. For low excitation, the competition between Y-emission, neutron emission, and fission should be taken into account. To aid in the evaluation of this competition an experiment has been performed to measure the number and energy spectrum of the protons and c-particles emitted in the high energy bombardment of uranium with protons, deuterons, and c-particles.