The results of the fall-out monitoring program at fixed stations more than 200 miles from the test site following the series of atomic tests in Nevada during the spring of 1952 are shown in a series of maps. Trajectories of debris from the individual bursts are given, together with a discussion of meteorological phenomena associated with the transport of atomic debris.

The objective of the production test described in this report is to provide the authority and mechanism to remove process tubes from the piles for inspection. The test is intended to provide a more positive tube inspection program than was previously provided under production test number 105-9-P, ``Corrosion of Slugs and Tubes``, document number 7-3928.

The following document describes data collected from a 14-month period of analyzing crustaceans containing radioactivity. Provided is information based on the change of radioactivity through seasonal changes.

Fragments of radioactive materials were deposited in the Redox area during August, 1953. By radiation monitoring, the location, physical properties, and dosage were determined. The cause was assumed to be the buildup of ammonium nitrate containing ruthenium on the filters of the Redox stack. The amount of occupational exposure, and the reasons why this incident happened were also discussed.

Introduction: "The problem of determining the properties and necessary controls on the TBP Plant waste disposal to eliminate transport line plugging and to permit higher concentration prior to return of this to the tank farms was studied. A report of preliminary findings was made to L. W. Finsh on January 31, 1953. This report compiles information in the aforementioned report and findings since its issuance. Previous studies related to this problem are summarized in the U. R. Technical Manual, HW-19140."

Analysis indicates that, in order to achieve supersonic flight with nuclear powered aircraft, a reactor -power plant combination capable of operating at temperatures considerably in excess of current practice must be developed. It is pointed out that there exist two general avenues of approach toward the goal of attaining high temperature reactors and power plants. The first approach involves the continuation and augmentation of research along the lines pursued by the conventional turbo-jet engine manufacturer, namely a search for material coatings or materials that will retain structural strength in high temperature oxidizing atmospheres. The second approach seeks to take advantage of the peculiar characteristics of the compressor-jet engine that permit the operation of the high temperature components in a non-oxidizing atmosphere. The results of a preliminary design study of a supersonic aircraft powered by a high temperature sodium, liquid vapor compressor -jet engine are summarized. The analysis considered, in as much detail as was warranted by the limited experimental information available, the characteristics of the reactor, power plant and airframe involved in determining performance. This study has been conducted for the purpose of guiding future, long -t e r rn , research work along the lines of high temperature reactors …

Weekly report discussing the state of the raw sugar market, including details for prices and market fluctuations related to weights in tons, regions, distribution, years, and figures.

Daily cash report for Imperial Sugar Company including a list of large withdrawals for the months surrounding the date showing the daily expenses and estimated balance for each entry. It also lists scheduled payments for bank loans.

None

None

None

Memorandum presenting an icing investigation conducted to determine the general de-icing and runback characteristics of three production samples of electric rubber-clad cyclic de-icing boots. The overall de-icing characteristics of two of the boots investigated were quite similar. Results regarding boot surface temperatures and general de-icing and runback characteristics are provided.

Report presenting data from an investigation of the effects of slot location and slot geometry on the flow in a square tunnel for a Mach number range up to 1.4. Calculated static-pressure and angle-of-flow distributions along the slotted boundary are presented for several slot configurations in a tunnel with two opposite walls slotted.

From Summary: "Pressure distributions and force characteristics have been determined for a body of revolution consisting of a fineness ratio 5.75, circular-arc, ogival nose tangent to a cylindrical afterbody for an angle-of-attack range of 0 degrees to 35.5 degrees. The free-stream Mach number was 1.98 and the free-stream Reynolds number was approximately 0.5 x 10 sup 6, based on body diameter. Comparison of the theoretical and experimental pressure distributions shows that for zero lift, either slender-body theory or higher-order theories yield results which are in good agreement with experiment."

"An attempt is made to describe the phenomenological differences between stall flutter and buffeting. Some experimental results are presented concerning both the boundaries at which these phenomena occur and the stresses involved" (p. 1).

Memorandum presenting tests in the 9-inch supersonic tunnel of three bomb or store shapes without fins and with two sets of cruciform fins. Measurements of normal force, chord force, and pitching moment were made; analyses of the effects of angle of attack and Reynolds number on these qualities and also upon center-of-pressure position and fin effectiveness are presented.

Report presenting an investigation of the flow field behind triangular wings alone and in combination with a pointed cylindrical body at Mach numbers of 1.5 and 2.0 through an angle-of-attack range of 0 to 24 degrees. Results regarding the geometric characteristics of the vortex system and downwash characteristics are provided.

The weight breakdowns in bar chart form in the present report have been prepared to give an indication of 'how we spend our weight.' They are expected to focus attention on the design functions that warrant weight reduction activity on future models.

"A variable-area auxiliary air scoop in combination with a fixed-area nose intake was tested at Mach numbers from 0 to 1.3. The purpose of the investigation was to evaluate the effectiveness of such an auxiliary intake in improving the net thrust of an intake-engine combination over a range of speeds. The results indicated that the internal flow was always stable and that improvements in net thrust would be realized at Mach numbers up to about 1.1 for an intake design Mach number of 1.3" (p. 1).

Report presenting an investigation to determine the low-speed, large-scale characteristics of an airplane configuration with an aspect ratio 2 triangular wing of variable incidence. The model consisted of the variable-incidence wing in combination with a fuselage of fineness ratio 13, a triangular vertical tail, and a thin, unswept, all-movable horizontal tail. Results regarding the lift characteristics of the model with the tail off, longitudinal stability with the horizontal tail on, trim lift and drag characteristics, and directional instability are provided.

Report discussing an investigation of external-store characteristics using a 245-gallon external fuel tank mounted under a wing of a North American F-86A airplane. The store normal force was found to increase abruptly on penetration of the buffet boundary. Information about the normal- and side-load distribution and integrated force and moment coefficients is provided.

Report presenting an investigation of spoilers at a Mach number of 1.93 to determine the effects of height and chordwise location on the section pressure distributions and section aerodynamic characteristics of a two-dimensional, 6-percent-thick, symmetrical wing. Spoilers of 3-, 5-, and 7-percent-chord height were tested at three chordwise locations. Results regarding pressure distributions, aerodynamic characteristics, and shock boundary-layer interactions are provided.

From Summary: "An investigation of the altitude performance of a 20-inch-diameter high-temperature-ratio ram-jet combustor which had been redesigned to provide good combustor efficiency over a wide range of temperature ratios was conducted at zero angle of attack in a free-jet facility at a Mach number of 3.0. Configurations investigated incorporated a cylindrical control sleeve which confined the injected fuel at low over-all fuel-air ratios to about 40 percent of the engine air flow. This provided an optimum fuel-air mixture over a portion of the flame holder when the over-all fuel-air ratio was about 0.02."

Report presenting an investigation to increase the compressor surge-limit pressure ratio of the XJ40-WE-6 turbojet engine at high equivalent speeds. An evaluation of the basic redesign of the compressor and 11 additional modifications are examined.