"An investigation of the rolling effectiveness of spoiler and aileron aerodynamic controls on a fighter-type airplane has been conducted at Mach numbers from 0.6 to 1.5 by the Langley Pilotless Aircraft Research Division by utilizing rocket-propelled test vehicles. No effects of mutual interference between the midspan spoiler and the outboard aileron were detectable. Above the speed of sound, the ailerons were relatively ineffective as compared with the spoiler because of wing twisting" (p. 1).

Memorandum presenting the tail-pipe fuel ratio, mass flow of combustion gas, and radial fuel flow distribution on cooling requirements of tail-pipe burner with annular cooling-air passage.

Report presenting the lift of wing-body combinations at supersonic speeds as obtained by means of an approximate linearized-theory analysis involving an assumption concerning the geometry of the body. A comparison with several groups of data is provided to show the accuracy of the method.

"An investigation was conducted at the NACA Lewis laboratory to obtain pressure-drop data for flow of air with no heat addition through mockups of two reactor segments of the proposed General Electric Company aircraft reactor. Pressure-drop data were obtained over a range of Reynolds numbers from 4000 to 80,000, air inlet Mach numbers from 0.02 to 0.40, inlet pressures up to about 40 inches of mercury absolute, and ambient air temperatures. factors, corrected for entrance, vena contracta, momentum, and exit losses, are considerably higher at the high Reynolds numbers than those reported for turbulent flow in smooth pipes" (p. 1).

Memorandum presenting the results of an investigation of the stability, control, and induced rolling moments of a canard missile with cruciform wings of rectangular plan form at Mach number 1.7. All data including the measured hinge moments of the canard control surfaces, the axial forces on the complete missile, and the forces and moments on the various combinations of the missile components are presented in tabular form.

Report presenting an investigation of the altitude performance of a 28-inch diameter ram-jet engine using a direct-connect system in an altitude test chamber. The majority of the investigation occurred at Mach number 2 at altitudes above the tropopause (250 degrees Fahrenheit inlet temperature). Various design configurations were explored and runs were made with different types of fuel.

"An NACA 65(sub 1)-212 airfoil of 8-foot chord was provided with a gas-heated leading edge for investigations of cyclical de-icing. De-icing was accomplished with intermittent heating of airfoil segments that supplied hot gas to chordwise passages in a double-skin construction. Ice removal was facilitated by a spanwise leading-edge parting strip which was continuously heated from the gas-supply duct. Preliminary results demonstrate that satisfactory cyclical ice removal occurs with ratios of cycle time to heat-on period (cycle ratio) from 10 to 26" (p. 1).

The trajectories of droplets in the air flowing past an NACA 651-212 airfoil at an angle of attack of 40 were determined. The collection efficiency, the area of droplet impingement, and the rate of droplet impingement were calculated from the trajectories and are presented herein.

"An investigation was conducted in the NACA Lewis icing research tunnel to determine the characteristics and requirements of cyclic deicing of a 65,2-216 airfoil by use of an external electric heater. The present investigation was limited to an airspeed of 175 miles per hour. Data are presented to show the effects of variations in heat-on and heat-off periods, ambient air temperature, liquid-water content, angle of attack, and. heating distribution on the requirements for cyclic deicing" (p. 1).

"Icing data collected on routine operations by four DC-4-type aircraft equipped with NACA pressure-type icing-rate meters are presented as preliminary information obtained from a statistical icing data program sponsored by the NACA with the cooperation of many airline companies and the United States Air Force. The program is continuing on a much greater scale to provide large quantities of data from many air routes in the United States and overseas. Areas not covered by established air routes are also being included in the survey. The four aircraft which collected the data presented in this report were operated by United Air Lines over a transcontinental route from January through May, 1951" (p. 1).

From Summary: "A photographic technique for investigating water droplets of diameter less than 200 microns falling freely in air at temperatures between 0 C and -50 C has been devised and used to determine: (1) The shape of frozen droplets, (2) The occurrence of collisions of partly frozen or of frozen and liquid droplets, and (3) The statistics on the freezing temperatures of individual free-falling droplets."

Memorandum presenting a two-dimensional wind-tunnel investigation to determine the extent to which boundary-layer removal through slots is effective as a means for maintaining extensive laminar layers at high Reynolds numbers. Results regarding drag, suction-flow and pressure-loss distribution, surface pressure distribution, lift, and difficulties encountered in obtaining extensive laminar flow are provided.

Memorandum presenting the boundary-layer velocity profiles were measured on ten samples of various porous materials and on impervious aluminum plate mounted flush with the inner surface of the side wall of a small wind tunnel. Suction was applied to the back side of the porous test materials through a 4-inch-square opening. Results regarding measurements on the impervious plate and measurements on porous materials without suction and with suction are provided.

Memorandum presenting an investigation to determine the energy transfer by thermal radiation from the flame of a single tubular turbojet-engine combustor to the combustor liner. The effects of variations in combustor inlet-air pressure, fuel-air ratio, and air mass flow on the transfer of radiant energy were studied.

Report presenting an investigation at Mach number 1.91 to determine the gross spreading characteristics of jets expanding from convergent and convergent-divergent nozzles using total-temperature surveys. Results regarding the preliminary development and jet spreading characteristics of the different types of nozzles are provided.

"An experimental investigation is being conducted at the Lewis laboratory to establish general principles for the design of noncritical turbine rotor configurations. This investigation includes evaluation of cooling effectiveness, structural stability, cooling-air flow distribution characteristics, and methods of supplying cooling air to the turbine rotor blades. Prior to design of a noncritical rotor, a standard turbine rotor of a commerical turbojet engine was split in the plane of rotation and machined to provide a passage for distributing cooling air to the base of each blade" (p. 1).

"An investigation of the isothermal wake-flow characteristics of several flame-holder shapes was carried out in a 4- by 4-inch flow chamber. The effects of flame-holder-shape changes on the characteristics of the Karman vortices and thus on the recirculation zones to which experimenters have related the combustion process were obtained for several flame holders. The results may furnish a basis of correlation, of combustion efficiency and stability for similarly shaped flame holders in combustion studies" (p. 1).

"A pneumatic probe based on continuity of mass flow through two restrictions separated by a cooling chamber was constructed to measure gas temperature at and beyond the limit of thermocouples. This probe consisted of a subsonic flat-plate orifice for the first restriction and a sonic-flow converging-diverging nozzle for the second restriction. The effect of variation in gas constants on the calibration is examined for common engine-exhaust gases" (p. 1).

"An investigation of forced-convection heat transfer and associated pressure drops was conducted with air flowing through electrically heated Inconel tubes having various degrees of square-thread-type roughness, an inside diameter of 1/2 inch, and a length of 24 inches were obtained for tubes having conventional roughness ratios (height of thread/radius of tube) of 0 (smooth tube), 0.016, 0.025, and 0.037 over ranges of bulk Reynolds numbers up to 350,000, average inside-tube-wall temperatures up to 1950deg R, and heat-flux densities up to 115,000 Btu per hour per square foot" (p. 1).

Report discussing an investigation to determine the cause and provide a fix for the instability in flight of the antisubmarine rocket Mk 1 Mod 0. The Magnus effects and their nonlinear variation with angle of attack were found to affect the stability, so reducing the Magnus effects should reduce instability in the missiles. The greatest reduction of Magnus effects was found through a combination of nose-ring spoiler and the original direction of the propeller rotation, but the nose ring increased the drag.

Report presenting the results of an investigation at supersonic speeds to determine the aerodynamic characteristics of a model of the North American MX-770 missile at several designated Mach numbers. No analysis is provided. Information about the longitudinal aerodynamic characteristics with trimmer and elevon deflected and lateral aerodynamic characteristics are described.

Report presenting an investigation into the effects of interference at supersonic speeds on the aerodynamic properties of wing-body combinations to determine the pitching moments. The correlation points of various wing-body shapes are provided and suggestions for modifications are made.

Memorandum presenting a supplementary investigation in the 20-foot free-spinning tunnel to determine the effect of external stores and lateral center-of-gravity displacement on the spin and spin-recovery characteristics of a scale model of the McDonnell F2H-3 airplane. Results regarding wing-tip tanks and experimental aerodynamic shapes are provided.

Memorandum presenting a linear theoretical analysis of the performance of three proportional navigation guidance systems installed in a given supersonic, variable-incidence, boost-glide, antiaircraft missile at Mach numbers of 2.7 and 1.3. It is shown that, with the antenna stabilized in space, the effect of component lags on the response is small, so that the speed of response is small, so that the speed of response can be made to approach closely that of the airframe alone.