From Introduction: "This paper presents the results of the investigation of wing-alone and wing-fuselage combinations employing a wing with the quarter-chord line swept back 35^o, aspect ratio 4, taper ratio 0.6, and NACA 65A006 airfoil section."

From Introduction: "This report presents the aerodynamic characteristics at low speed end high Reynolds number as determined in the Ames 40- by 80 foot wind tunnel."

Report presenting an investigation of a 24-inch-diameter rotor for a supersonic axial-flow compressor in air up to an actual tip speed of 1654 feet per second and a maximum equivalent tip speed of 1765 feet per second. Results regarding overall performance, rotor-inlet characteristics, rotor-passage flow characteristics, and rotor-outlet characteristics are provided.

From Introduction: "This paper presents the results of the investigation of the wing-alone and of the wing-fuselage configuration employing a wing with an unswept quarter-chord line, aspect ratio 4, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the air stream. The results of closely related sweptback-wing investigations, which are part of the present transonic programs, are presented in references 1 to 3."

Report discussing the effect of half-span and full-span split flaps through a deflection range on the low-speed, longitudinal characteristics of a sweptback wing with a round-nose, extensible leading-edge flap. Information about the effect of split-flap deflection on lift and stalling characteristics, effect of split flaps on gliding characteristics, and effect of leading-edge roughness on longitudinal stability is presented.

"Six numerical examples are presented for steady, two-dimensional, compressible, nonviscous flow in centrifugal compressors with thin straight blades, the center lines of which generate the surface of a right circular cone when rotated about the axis of the compressor. A seventh example is presented for incompressible flow. The solutions were obtained in a region of the compressors, including the impeller tip, that was considered to be unaffected by the diffuser vanes or by the impeller-inlet configuration" (p. 141).

The free turbulent mixing of a supersonic jet of Mach number 1.6 has been experimentally investigated. An interferometer, of which a description is given, was used for the investigation. Density and velocity distributions through the mixing zone have been obtained. It was found that there was similarity in distribution at the cross sections investigated and that, in the subsonic portion of the mixing zone, the velocity distribution fitted the theoretical distribution for incompressible flow. It was found that the rates of spread of the mixing zone both into the jet and into the ambient air were less than those of subsonic jets.

From Summary: "A smooth-water-landing investigation was conducted with a small seaplane to obtain experimental wing-bending-moment time histories together with time histories of the various parameters necessary for the prediction of wing bending moments during hydrodynamic forcing functions. The experimental results were compared with calculated results which include inertia-load effects and the effects of air-load variation during impact. The responses of the fundamental mode were calculated with the use of the measured hydrodynamic forcing functions. From these responses, the wing bending moments due to the hydrodynamic load were calculated according to the procedure given in R.M. No. 2221. The comparison of the time histories of the experimental and calculated wing bending moments showed good agreement both in phase relationship of the oscillations and in numerical values."

"An analysis and calculations on the stability of the free laminar boundary layer between parallel streams were made for an incompressible fluid using the Tollmien-Schlichting theory of small disturbances. Because the boundary conditions are at infinity, two solutions of the Orr-Sommerfeld stability equations need not be considered, and the remaining two solutions are exponential in character at the infinite boundaries. The calculations show that the flow is unstable except for very low Reynolds numbers" (p. 571).

"The flexural vibration of a rotating propeller blade with clamped shank is analyzed with the object of presenting, in matrix form, equations for the elastic bending moments in forced vibration resulting from aerodynamic forces applied at a fixed multiple of rotational speed. Matrix equations are also derived which define the critical speeds end mode shapes for any excitation order and the relation between critical speed and blade angle. Reference is given to standard works on the numerical solution of matrix equations of the forms derived" (p. 1).