Report presenting an investigation of the effect of two wing sections and a tip tank on the aerodynamic characteristics of a rigid unswept wing in the high-speed tunnel over a Mach number range of 0.60 to 0.90. Results regarding the effect of original airfoil sections, effect of modifications to Section B, effect of tip tank, and characteristics of the tip tank in the presence of the wing are provided.

None

None

Report discussing a wing-alone and wing-fuselage configuration with particular characteristics as part of a series of tests of wings using the transonic-bump test technique. Lift, drag, pitching moment, and root bending moment were obtained for the configurations. The effective downwash angles and dynamic-pressure characteristics in the tail region are also described.

Introduction: In order to determine the relative corrosion resistance of welded mild and stainless steels in Redox Stream IAW neutralized to pH 0, 2, and 10 a test program, described below, has been carried out.

The interaction between neutron and proton in the triplet state has been investigated. The central and tensor potentials have been assumed to be of the ''meson'' type but of possibly different ranges. The variational-iterational method has been utilized to determine V{sub o}, the strength of the central potential, and {gamma}V{sub o}, the strength of the tensor potential. A wide variation in the values of both central and tensor ranges were included. Calculations of this type have proved difficult in the past principally because of the sensitivity of the results to the quadrupole moment Q of the deuteron for which accurate wave functions are necessary. It would be desirable to have a more accurate value of Q deduced from experiment. The percent D state in the deuteron and the effective triplet range have also been computed. The results are applied to the discussion of the magnetic moment of the deuteron, the photoelectric disintegration of the deuteron, and neutron-proton scattering. It is concluded that experimental information on neutron-proton interaction at their present accuracy does not determine the range of the tensor forces except within rather broad limits. A decrease in the uncertainty in the triplet range by an order of magnitude would …

Report presenting a preliminary theoretical and experimental investigation of the supersonic characteristics of blunt-trailing-edge airfoils. Results regarding the drag measurements at zero lift, measurements at angle of attack, and a general discussion of the theoretical and experimental results is provided.

This report describes the basic design, intermediate and final stacking procedures, and graphite behavior of nuclear reactors DR and H during construction. Included in the report are test records to substantiate basic design assumptions and data and the actual performance of the graphite during preliminary and final stacking.

By use of the assumption that the pressure-volume relation is linear, a solution to the problem of designing a cascade for a given turning and with a prescribed velocity distribution along the blade in a potential flow of a compressible perfect fluid was obtained by a method of correspondence between potential flows of compressible and incompressible fluids. The designing of an isolated airfoil with a prescribed velocity distribution along the airfoil is considered as a special case of cascade. If the prescribed velocity distribution is not theoretically attainable, the method provides a means of modifying the distribution so as to obtain a physically significant blade shape. Numerical examples are included.

Labcratory data which indicate that the recovery of Pu and U and decontamination from fission products are feasible in a solvent extraction process using tributyl phosphate are given. The procedure consists of extracting Pu(IV) and U with 15% TBP--85% Varsol using 5.0 N HNO/sub 3/ as a salting agent. (J.R.D.)

Report presenting the results of an experimental investigation of rim cracking in a welded-blade composite gas-turbine wheel, in two carbon-steel disks, and five tool-steel disks. Various characteristics were investigated, including the effectiveness of holes in preventing crack propagation and the influence of hardness and various types of notch on rim cracking.

Fundamental principles and techniques used for voltage measurements primarily for frequencies in the upper audio- and radio-frequency ranges and including part of the ultrahigh frequency range.

Abstract: "A method is described for the identification and quantitative determination of trace amounts of rare earths in graphite by measurement of the energies and decays of the activities induced by neutron irradiation. The specific rare earth elements identified are europium and samarium. During the development of this method, the half-lives of Eu-152 and Sm-153 were determined. These are reported as 9.32 +/- 0.04 hours and 46.34 +/- 0.23 respectively."

Memorandum presenting an investigation conducted to evaluate the effectiveness of a simple internal regenerative fuel preheater for a 20-inch-diameter ram jet. Data obtained at subsonic sea-level conditions indicated that fuel could be successfully preheated in this manner.

A report discussing a method of computing the critical mass of U₂₃₅ contained in a water solution confined to a spherical core and surrounded by an infinite water tamper, a modification of said method in which the effect of the resonance fission and absorption is taken into account, and physical constants required to calculate the critical mass using these methods.

None

None

Report presenting the results of an experimental investigation to determine the pressure-recovery and mass-flow characteristics of single and twin NACA submerged intakes on the sides of a fuselage at various angles of sideslip. Tests were conducted with single and twin submerged intakes on a model of a fighter-type airplane.

From summary: "A method for the preparation of normal uranyl carbonate has been developed. Heretofore, this compound has been known only as a rare, naturally occurring material." The report further discusses the physical properties of the compound, its solubility in water, and its interaction with sodium carbonate.

None

The general principles of a liquid-liquid solvent extraction method for the separation of metallic elements are outlined.

This is a progress report from Brookhaven National Laboratory for the period July 1 through December 31, 1949.

The following items of equipment have been completed: Two Scaler Multipliers, EO-18 and EO-338, undergoing test and adjustment. One Thyratron Heater Control for Scioto Laboratory. One Pilot model switch box for Group 16 hoods at Scioto Laboratory. One Pilot model patch box used as auxiliary to the present switch boxes. Installation of electronic equipment and sorting and cataloguing of stock at Scioto Laboratory has been started. The Y Section induction heaters have been installed electrically. With the present setup in the WD Building, it has been necessary to recycle all the solution which passes through the pH chamber on the clariflocculators. Sufficient tests have been run on the Berkeley Decimal scaler to indicate that, by using a pre-emplifier, it will be a satisfactory replacement for the scaler multiplier. Reworking of B-wall tubes has been held up pending the delivery of neon gas. Further investigations have been made on the frequency compensated constant voltage Sola transformers. Three automatic potential controllers have been modified in accordance with investigations of Group 10. The program of preventative maintenance on automatic potential controllers has resulted in a marked reduction of service calls and down-time for the operating group.

None