The mean heat capacity of a sample of powdered beryllium carbide, a possible moderator material for a nuclear reactor, was determined as a function of temperature. A thin-walled stainless steel capsule containing the material was heated in an electric furnace and dropped into a water calorimeter. The following linear equation for mean heat capacity over the temperature range 50 f C-T f C as a function of temperature, T, was derived from the data by the method of least squares: C/sub p/ = 0.299 + 2.16 x 10/sup -4/ T f C el temperatures 0.005 cal gm/sup -1/( f C)/sup -1/. The numerical value of C/sub p/ expressed by this equation is also equal to the mean heat capacity in Btu lb/sup -1/( f F)/sup -1/. (auth)

None

None

None

From Summary: "Despite the development of relatively ice-free fuel-metering systems, the widespread use of alternate and heated-air intakes, and the use of alcohol for emergency de-icing, icing of aircraft-engine induction systems is a serious problem. Investigations have been made to study and to combat all phases of this icing problem. From these investigations, criterions for safe operation and for design of new induction systems have been established. The results were obtained from laboratory investigations of carburetor-supercharger combinations, wind-tunnel investigations of air scoops, multicylinder-engine studies, and flight investigations. Characteristics of three forms of ice, impact, throttling, and fuel evaporation were studied."

"Abrupt, rudder-fixed aileron rolls have been made with the Bell X-1 airplane having a 10-percent-thick wing in glides to a Mach number of 0.82 at about 30,000 feet pressure altitude. Aileron movements were between one-fourth and one-half of full deflection. These aileron rolls indicate that Mach number has little effect on the aileron effectiveness up to a Mach number of 0.82" (p. 1).

Memorandum presenting flight tests with a fighter airplane to study the effect of boundary-layer suction aft of the shock wave on airfoil drag at supercritical Mach numbers and high Reynolds numbers. Airfoil chord force was determined from pressure-distribution measurements obtained at a range of Mach numbers at steady dives. Results of the tests showed no measurable effect of suction for the suction coefficient available.

Report presenting a simplified method for obtaining free-flight measurements of damping in roll through the use of rocket-powered models. Initial configurations have been tested for a range of Mach numbers. Results regarding the rolling velocity with two different airfoil sections and damping-in-roll coefficient are provided.

Report presenting a low-speed wind-tunnel investigation to determine the lateral control characteristics of extensible wing-tip ailerons on an untapered semispan wing with two configurations; one was unswept and had an aspect ratio of 3.13 and the other was swept back 45 degrees and had an aspect ratio of 1.59. Results regarding the plain-wing aerodynamic characteristics and lateral control characteristics are provided.

Report presenting wind-tunnel tests of a semispan model of a thin sharp-edged unswept wing of aspect ratio 4 and taper ratio 0.5 equipped with a full-span, constant-chord, leading-edge flap. The effectiveness of the leading-edge flap in improving the lift-drag ratio of the wing was investigated over a range of Mach and Reynolds numbers. Results regarding the lift characteristics, drag characteristics, pitching-moment characteristics, and lift-drag ratio are provided.

Memorandum presenting an investigation conducted to determine the pressure distribution on a conical body of elliptic cross section at a Mach number of 1.89. Experimental data are presented for a range of angles of yaw from -16 to 16 degrees and angles of attack from -10 to 10 degrees. As the angle of flow deflection was increased, the deviation from experiment of the theoretical pressure distribution slightly increased, although agreement was satisfactory over the entire range of calculations.

Report presenting an investigation of the effect of the rate of change of angle of attack on the maximum lift coefficient of a pursuit airplane equipped with a low-drag-type wing in stalls of varying abruptness over a range of Mach and Reynolds numbers. Maximum lift coefficients were found to increase linearly with increasing rate of change of angle of attack per chord length of travel up to the maximum rate attained in the tests.

Report presenting an investigation of the low-speed characteristics of a wing swept back 42 degrees at the leading edge and having various high-lift and stall-control devices and fuselage and horizontal tail vertical positions. Results regarding the characteristics of the basic wing, leading-edge flap investigation, wing fuselage investigation, and horizontal tail investigation are provided.

From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuselage configurations employing a wing with the quarter-chord line swept back 45^o, aspect ratio 4, taper ratio 0.3, and an NACA 65A006 airfoil section parallel to the stream."

"As part of a program to study the correlation between molecular structure and physical properties of high-density hydrocarbons, the net heats of combustion, melting points, boiling points, densities, and kinematic viscosities of some hydrocarbons in the 2-n-alkylbiphenyl, 1,1-diphenylalkane, diphenylalkane, 1,1-dicyclohexylalkane, and dicyclohexylalkane series are presented" (p. 55).

Topics discussed included scope of work by the Kellex Corporation; Redox Production Plant procurement; bearing capacity of soils and other site characterization for the Redox Production Plant site; purchase of Moyno pumps; scope drawing schedules; 68% nitric acid requirements for the process; pump development for the Redox Production Plant; vessel specifications; Design basis letters on electrical distribution, steam distribution, raw and filtered water distribution, and railroads. The report includes a letter on materials of construction for 202-S building equipment.

This report details events of importance reported by the Hanford Operations Office for the week ending May 18, 1949.

The following report provides results taken from a sodium level indicator developed at Sacandaga using electrical resistance as the principle.

The following report provides the analysis of a large number of unreported data--taken during a study described in report HW-15230--containing density values obtained for solutions of uranium and nitric acid in tributyl phosphate-carbon tetrachloride solutions.

Construction and operation of a simplified ionization chamber.

A report on high voltage pulse transformer designs at the University of California Radiation Laboratory.

"A flight test of the Aero jet Engineering Corporation's 7KS-6000 T-27 Jato rocket motor was conducted at the Langley Pilotless Aircraft Research Station at Wallops Island, Va, to determine the flight performance characteristics of the motor. The flight test imposed an absolute longitudinal acceleration of 9.8 g upon the rocket motor at 2.8 seconds after launching. The total impulse developed by the motor was 43,400 pound-seconds, and the thrusting time was 7.58 seconds" (p. 1).