The following report describes two rapid, micro methods for the determination of UNH in Redox waste samples that had been developed fir the concentration range 0.2 to 100 g/l.

None

Report presenting the damping-in-roll coefficients for a series of thin triangular plan-form wings and two rectangular wings in the 9-inch supersonic wind tunnel. The damping in roll of the rectangular wings was very close to what was predicted by linear theory, but the triangular wings gave results approximately 10 percent below that predicted when the wing leading edges were well ahead of or behind the Mach cone.

"Results are presented from tank take-off tests of a dynamic model of a hypothetical high-speed airplane fitted with NACA hydro-skis and having the transverse curvature of the lower rear portion of the fuselage broken by small longitudinal chine strips. For the configuration tested, both trim and resistance were considerably reduced by the addition of the strips from the speed at which the ski emerged to the speed at which the rear of the fuselage came clear of the water. The results indicate that fuselage shape has a large effect on the take-off characteristics for a hydro-ski configuration in which the rear of the fuselage acts as a planing surface" (p. 1).

From Summary: "A series of publications on the source-distribution methods for evaluating the aerodynamics of thin wings at supersonic speeds is summarized, extended, and unified. Included in the first part are the deviations of: (a) the linearized partial-differential equation for unsteady flow at a substantially constant Mach number. b) The source-distribution solution for the perturbation-velocity potential that satisfies the boundary conditions of tangential flow at the surface and in the plane of the wing; and (c) the integral equation for determining the strength and the location of sources to describe the interaction effects (as represented by upwash) of the bottom and top wing surfaces through the region between the finite wing boundary and the foremost Mach wave. The second part deals with steady-state thin-wing problems. The third part of the report approximates the integral equation for unsteady upwash and includes a solution of approximate equation. Expressions are then derived to evaluate the load distributions for time-dependent finite-wing motions."

"In a round turbulent jet at room temperature, measurement of the shear correlation coefficient as a function of frequency (through band-pass filters) has given a rather direct verification of Kolmogoroff's local-isotropy hypothesis. One-dimensional power spectra of velocity and temperature fluctuations, measured in unheated and heated jets, respectively, have been contrasted. Under the same conditions, the two corresponding transverse correlation functions have been measured and compared" (p. 1).

This document details activities at the Hanford Engineer Works during the month of May 1949.

This report details events of importance reported by the Hanford Operations Office for the week ending June 15, 1949.

"Changes, corrections and additions to the original report are included in this addendum. These are brought about by further development of the design by Blaw-Knox, ANL and ORNL. The changes are listed in accordance with the main headings, pages and paragraphs to which they apply."

The operation of the 184" synchro-cyclotron is reviewed in terms of the theory as developed by the authors. Certain relevant data on the properties of the magnet and rotating condenser are also presented.

A German log rodmeter of the pitot static type was calibrated in Langley tank no. 1 at speeds up to 34 knots and angles of yaw from 0 deg to plus or minus 10 3/4 degrees. The dynamic head approximated the theoretical head at 0 degrees yaw but decreased as the yaw was increased. The static head was negative and in general became more negative with increasing speed and yaw. Cavitation occurred at speeds above 31 knots at 0 deg yaw and 21 knots at 10 3/4 deg yaw.

Progress is reported on the quartz fiber microbalance design and research. The mechanism for drawing the quartz fibers and the measurements of the properties of the fibers are described. Design and construction of a mass spectrograph and a cloud chamber is presented. Refilling B-wall tubes is investigated.