Technical report covering (1) analysis of uranium bromide and chloride samples, (2) the ferric-nitrate method of analyzing uranium fluorides for fluorine, (3) spectrographic determination of boron, cadmium and manganese in magnesium metal, (4) service analyses. contributions to other problems, (5) attempted preparation of uranous oxyfluoride, and (6) corrections in previous reports.

Technical report. Areas covered are properties of uranium halides, properties of uranium nitrides, and hydride formation at high pressure.

Technical report with short articles on (1) Uranium-oxygen system compositions UO2 to U3O3; (2) Thorium hydride; (3) Production of cerium; and (4) Production of thorium.

Technical report describing a gasometrical method for the determination of H2 in extruded U rods.

Technical report abstract. The present state of knowledge concerning the effect of pile radiation on a variety of solid materials is reviewed. Radiation corrosion will not be a serious hazard for aluminum or stainless steel but it can be for iron or lead if either are exposed to water. Apart from corrosion the principal uncertainty is in regard to the Wigner effect on the behavior of metals. There is at present no ground for optimism regarding the behavior of tuballoy. The effect on aluminum or a bonding material while less severe must also be considered serious. The expectation in regard to graphite is that its behavior will not cause trouble during the first 100 days of operation although serious troubles will probably arise within two years of operation. Organic materials can be used safely only in regions of limited exposure.

Calculations were made to determine the temperature at various points of a thick disc and cap, on the assumptions that the heat production rate is uniform throughout the slug and that the slug is in perfect thermal contact with the cap. Results obtained by different methods of computation are compared with each other and with results obtained by Drew on the Paschkis electrical network computer at Columbia University.

Some methods for calculating the k requirements of various shaped piles are indicated, with particular reference to the shape of the tank in the homogeneous plant.

From abstract: "Comparison of the activity produced by fast neutrons on lead with other activations corroborates the assignment of the 3.2 hr. activity as Pb209, and the assignment of the reaction as capture of fast neutrons. Two different measurements show that the neutrons captured have energies greater than 100 KEV. This average capture cross section for primary neutrons from 7.5 MEV deuterons on a thick target of beryllium is measured as 10[^]-27 ca[^]2."

Warping of a rod by a variation in heat transfer coefficient around the periphery is considered. Estimates for some simple cases are given, and a more precise numerical calculation is carried out in ne instance.

A report which investigated vacuum distilation, entrainer gas distillation, and entrainer gas plus bromine vapor distillation.

The following report describes tests made for the purpose of determining the accuracy and permanency of various types of high resistance bleeders, and their resistance variation during use over a period of approximately six months.

Report detailing values of x-ray lives and limits for trans-uranic elements. Formulas and methods are detailed throughout the report.

Technical report describing the investigation of the short-lived activities produced in oxygen compounds by irradiation with pile neutrons. The most prominent of these activities in cooling water is a beta and gamma emitting activity of about 8 second half-life. Because of its production by epicadmium neutrons it was believed to be the 8 second N16 produced in the pile by n,p on O16. The identification has been accomplished and it is established that the 8 second activity is N16. Part 2 of the report deals with the determination of the recoil range of the Al28 atoms formed by pile n,p reaction on Al27.

Technical report abstract: Since UNH is a highly dissociated compound which ionizes to NO3 and (UO2), the latter ion being very weakly basic, a solution of pure UNH is quite acid (pH about 3). It is possible to titrate to a phenolphthalein and point with standard caustic solution and obtain a figure which represents the free acid plus the NO3 from the the UNH. However, titration of the free nitric acid alone in such a solution presents quite a problem. By precipitating and removing uranium from solution by means of potassium ferrocyanide, the residual free acid may be titrated directly by means of standard caustic using either methyl red or phenolphthalein indicators, with an error of less than 4%. A method is given to determine formic acid, should that acid be present in the mixture.

It is usual to determine the density of neutrons by using foils of metals which become radioactive as a result of bombardment in the region under investigation. From the rate of disintegration of the newly formed radioactive element the number of neutrons absorbed can be calculated. By use of the capture cross section of the element of which the foil is composed the density of the neutrons can then be computed. By counting the alpha particles from a bismuth foil of known weight after exposure to neutrons the density of the neutrons which produced this activity can be calculated. The least accurately known value which enters into this evaluation is the capture cross-section of bismuth for pile neutrons. This value may be improved by future measurements. It is of importance only for absolute measurements of neutron density so that relative values can be measured with considerable accuracy on the basis of known data.

Measurements made in a uranium cylinder result in a mean value of 1.55 cm. for the diffusion length L for distances of 1 to 4 cm. from the base of the cylinder. Calculations give a value which agrees with the experimental result and show further that L increases from 1.40 to 1.63 cm. as the neutrons diffuse a distance of 5 cm. into the uranium.

The distribution of thermal neutrons in a W slug having a one centimeter aluminum end cap has been calculated on the basis of simple diffusion theory. It is found that the average neutron density, and therefore the power output, at the end of the slug is about 34% higher than the density far from the end cap. This result agrees well with the recent Argonne pile experiments (CP-1729).

Abstract. The effect of various inhibitors on the production of CrIII in W waters containing chromatic has been studies at a variety of pH's in the CP-3 pile. The addition of 2 ppm NaClO3 appears to have little effect a a pH of 5.3, but 2 ppm NaClO3 cr 0.15 ppm of Cl2 (in the form of NaOCl) somewhat decreases the amount of chromatic reduced at a pH of 7.1. The inhibition is not great enough, however, to reduce the amount of CrIII formed to the maximum concentration permissible at W (0.02 ppm). The addition of 3 ppm (NH4)2S2O3 as an inhibiter will permit W water to be used a a Ph of 7.0, but not at a pH of 6.5 as far as chromate reduction is concerned. The concentration of CrIII would be 0.01 ppm and 0.05 ppm, respectively, after one passage through the pile. Previous conclusion as to the effects of temperature, pH, intensity and the addition of ammonium persulfate, which had been reached from experiments with simulation W water, have been checked by studies with solutions made from water chipped directly from Hanford. All of the effects noted were found to be similar to those already reported, …

Technical report. Long-time tests have been made on the effect of various types of radiation on the corrosion of 2S aluminum in simulated W water. In no case was any acceleration of corrosion by the radiation observed; the effect of radiation, if any, appeared to be a protective one. Deuteron irradiation did accelerate the corrosion of mild steel at low flow rates in hot water of pH 6 to 7, but no appreciable effect was observed with copper, stainless steel, or tuballoy. The general theory of the effect of radiation on corrosion is discussed, with the conclusion that no acceleration of corrosion by radiation is to be expected in most cases of practical interest.

The change in the simple [formula] distribution of neutrons in a spherical lump of uranium caused by the distribution in velocities of thermal neutrons is calculated. If the calculated curve is fitted as well as possible by a simple [formula] curve, it is shown that the value of [formula] obtained in this way is a function of [formula], the radius of the sphere. For small radii the [formula] obtained in this manner will be as much as 25% greater than the [formula] corresponding to average velocity neutrons. The change in the thermal utilization caused by the distribution in velocities is discussed. The flux of neutrons into a sphere is calculated taking into account the velocity distribution and this is compared with the usual theory.

Abstract. Wigner effects on aluminum, beryllium, and tuballoy have been studied by the electrical resistance method. Samples were exposed during an interval which would have produced an increase of approximately 22% in resistance of AGOT-K graphite. The resistance of tuballoy increased approximately 1%. It is shown that the increase can be accounted for by the amount of fission product impurity formed during the exposure. Neither aluminum nor beryllium showed any change. In the case of Be, the Wigner effect may be obscured, to some extent, by the approximately .2 - .3 atom % of impurity present in the samples. Based on the increase occurring in ADOT-K graphite, a change of approximately .2 - .5 x10-6 ohm-om might be expected in the case of Be. The accuracy of the method was sufficiently great to detect a change of this magnitude. Other experiments with Be will be undertaken when purer samples are available. Meanwhile, some samples of the present type ae being subjected to further irradiation.

Abstract. the electrodeposition of uranium metal, in the form of tree-like deposits, from molten strontium halide baths is described. Under the best conditions studied, approximately 40% recovery is attained. Freedom from side-reactions of the reduced uranium with anode products and/or refractory materials, and high cathode current densities appear to be essential to the success of the process. the refining of uranium under similar conditions appears to occur quite readily, with approximately 50% current efficiency. The preparation of UI3 is also described.

Effect of aquadag coating on noise reduction in polyethylene coaxial cable was tested. A satisfactory combination of coaxial cables and connectors interconnecting sources of small ion currents or ionizing impulses with the measuring device is described.

The temperature coefficient of eta has been measured with the thermal column of the Argonne pile using uranium foils of different isotopic ratios. The temperature change was effected by filtering neutrons through silver. The measured fractional change per degree centigrade is [formula].