"Axial fatigue tests were made on 189 coupon specimens of 0.032-inch 24S-T aluminum-alloy sheet and a few supplementary specimens of 0.004-inch sheet. The mean load was zero. The specimens were restrained against lateral buckling by lubricated solid guides described in a previous report on this project. About two-thirds of the 0.032-inch specimens were plain coupons nominally free from stress raisers. The remainder contained a 0.1285-inch drilled hole at the center where the reduced section was 0.5 inch wide" (p. 1).

Report presenting calibrations in axial tension over the strain range from 0 to 0.0024 are presented for 15 types of single element multistrand wire strain gages. The majority of the gages showed significant differences between the calibration factors for strain increasing and strain decreasing. Improvement in gage performance after preloading was apparent in most cases.

Report presenting experiments with a flat reinforced sheet model, the longitudinals of which were loaded axially. Two groups of sheets, one with one panel and one with two panels, were cut out and the stress distributions in stringers and sheet was measured with electric strain gages.

Note presenting the results of a study and research investigation of nondestructive test methods for spot welds in aluminum-alloy sheets. The purpose of the research was to investigate proposed nondestructive test methods for spot welds in aluminum alloys, to determine the feasibility of the tests, and to recommend the research methods found suitable for development and reduction to practical application.

"It is well known that the vorticity for any fluid element is constant if the fluid is non-viscous and the change of state of the fluid is isentropic. When a solid body is placed in a uniform stream, the flow far ahead of the body is irrotational. Then if the flow is further assumed to be isentropic, the vorticity will be zero over the whole filed of flow. In other words, the flow is irrotational. For such flow over a solid body, it is shown by Theodorsen that the solid body experiences no resistance" (p. 1).

Note presenting fairing compositions applied to aircraft surfaces, welds and junctions of metal plates, and rivet depressions to improve the aerodynamic efficiency of the airplane at high speeds. A method is described for formulating fairing compositions which have, within limits, desired coefficients of thermal expansion. Results regarding water-immersion tests, thermal expansion and softening temperature, temperature-cycle tests, and density are provided.