In this report a method is presented for the calculation of the profile drag of airfoil sections. The method requlres only a knowledge of the theoretical velocity distribution and can be applied readily once this dlstribution is ascertained. Comparison of calculated and experimental drag characteristics for several airfoils shows a satisfactory agreement. Sample calculatlons are included.

Report presenting an experimental investigation concerned primarily with the extension of test data on the drag of revolving disks, cylinders, and streamline rods to high Mach numbers and Reynolds numbers. The tests generally confirm earlier theories and add in some new results. One of the primary findings of interest is that skin friction does not depend on Mach number.

Report presenting an investigation made of the flow downstream from a two-dimensional grid, formed of parallel rods. The two-dimensional character of the flow was insured by end plates normal to the rods and covering the entire flow field. The nature of the flow was determined primarily by means of total-head measurements.

"Following a brief history of the NACA investigation of jet-propulsion, a discussion is given of the general investigation and analyses leading to the construction of the jet-propulsion ground-test mock-up. The results of burning experiments and of test measurements designed to allow quantitative flight-performance predictions of the system are presented and correlated with calculations. These calculations are then used to determine the performance of the system on the ground and in the air at various speeds and altitudes under various burning conditions. The application of the system to an experimental airplane is described and some performance predictions for this airplane are made" (p. 1).

Report presenting elementary basic solutions of the equations of motion of a compressible fluid in the hodograph variables are developed and used to provide a basis for comparison in the form of velocity correction formulas, of corresponding compressible and incompressible flows.

Report presenting the utilization of the differential equation of Chaplygin's jet problem to give a systematic development of particular solutions of the hodograph flow equations, which extends the treatment of Chaplygin into the supersonic range and completes the set of particular solutions. The solutions serve to place on a reasonable basis the use of velocity correction formulas for the comparison of incompressible and compressible flows.

Report presenting tests on an exhaust-gas turbine with four separate nozzle boxes each covering a 90 degree arc of the nozzle diaphragm and each connected to a pair of adjacent cylinders in a Pratt & Whitney R-1340-12 nine-cylinder radial engine. Results regarding the power output of the engine and turbine, effect of the turbine on engine power, turbine power output and speed characteristics, mean turbine efficiency, effect of the blowdown turbine on exhaust-gas temperature, and condition of the blowdown turbine after tests are provided.

"The results of flight investigations of the profile drag of several carefully finished conventional and low-drag airfoils are presented. The results indicated that in all cases lower profile-drag coefficients were obtained with the low-drag than with the conventional airfoils over the range of lift coefficient tested and that, for comparable conditions of lift coefficient and Reynolds number, the low-drag airfoils may have profile-drag coefficients which are at least 27 percent lower than the profile-drag coefficients of the conventional airfoils" (p.1).

Report presenting an investigation in the 19-foot pressure tunnel to determine the nacelle drag, the cowling-air flow, and the propeller characteristics of a model of a high-performance military airplane. The model is fitted with NACA D(sub S)-type engine cowlings and with propellers embodying NACA 16-series airfoil sections. Results regarding the propeller characteristics, drag and cowling-air flow with the propeller removed, the effect of propeller on flow through cowling, and the influence of cooling requirements on airplane performance are provided.